Question about kawasaki KLX 110 Motorcycles

1 Answer

Quad backfires while trying to start ,but wont start,any ideas?

Just put new carb on quad,started up drove around, was bogging and bucking,then after shutting off wont start, just backfires through carb while trying to start

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

Make sure you don't have a leak around manifold side of boot

Posted on May 16, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: yz 426 wont idle, backfires and bogs out

Hello phwolfe,
Did not backfire but , boged out appling fuel. Found it was flooding because
the floats were over filling the chambers. Adjusted float settings (by eye )
problem solved !! Keeping the chambers 1/2 to 3/4 full worked for me.
My Bike is a 1983 Midnight Maxim 653cc. 4 Cylinder. Maybe yours is fuel injected ?

Best of luck !!

Ron



Posted on Mar 18, 2009

jmgldsmth
  • 1889 Answers

SOURCE: harley davidson not running

if your engine is backfiring you probably jumped time reset your engine to top dead center valves closed on #1 cylinder check your timing: belt / chain / gears for wear

Posted on Apr 29, 2009

  • 1 Answer

SOURCE: Backfiring

Hi, maybe its the same problem i had, i have a 1200 goldwing where your spark plug are there are holes if these become clogged the water stays there and causes backfiring, get a metal welding rod or steel coat hanger and push through the hole to clear the water, hope this helps good luck.
regards Mark

Posted on May 11, 2009

  • 202 Answers

SOURCE: Bike is backfiring through carb.

do u have the correct spark plug the one recommended by the manufacturer

Posted on Aug 02, 2009

mwoodring1
  • 496 Answers

SOURCE: 2001 Honda Shadow ACE 750 idles, but won't rev up

vac leak craked boots

Posted on Jan 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Starts, idles and runs great up 3/4 throttle. Why does it bog down after that?


Check for vacuum leaks. Spay starter fluid around intake,carb base, etc., while engine is idling, listen for change in engine idle.
To show your appreciation press the helpful button and follow me on fixya for more tips and info.

Feb 16, 2016 | ATVs

1 Answer

89 K5 Blazer 350 TBI cranks but won't start... the rad hose blew, i fixed it then the next day it bogged and backfired, ran fine cold, but when warmed up it would lose power and stall when trying


Have you checked Google I found this hopefully it's not your timing or it may be flooded but doubtful have you tried spraying starting fluid into the intake while cranking it

Jun 01, 2012 | Cars & Trucks

1 Answer

Suzuki lt 50 quad starts and wil tick over but when u try 2 rev it she bogs down and cuts out like a blo9cked carb but i'v had the carb off and its all clean and fine


I got a Suzuki lt 50 it starts fine drives fine at low speed then when I go over half throttle it bogs down I've cleaned the spart plug cleaned the carb and cleaned the jets but its still doin it any ideas please ??

Sep 16, 2011 | Suzuki GSX 750 ES Motorcycles

2 Answers

I have a 2003 ttr 225, it is tough to start, when it does start it idles high, when i get into gear it has trouble going, when it does go it bogs and sometimes backfires.. drove today it stalled in second...


Remove, dissemble and clean the carb. Check the rubber diaphragm for cracks, pinholes and poor seal at the gasket. Install a new spark plug, clean the air filter. The high idle is caused by a lean fuel mixture. Outside air is entering the mix. Look at the rubber "O" ring on the carb joint. Check for cracks and hardening of the ring. Your carb will have a plug or a hose at the front edge of the carb joint. Check the plug / hose and clip. Check for cracks in the plug / hose and hardening. Check the entire length of the hose if a hose is present. Please rate my answer. Thanks! tombones49_43.gif

Mar 31, 2011 | 2003 Yamaha TT-R 225

2 Answers

Starting my Mojave 250


check comprsion. check valve clearance.

Apr 26, 2009 | kawasaki Full Suspension Mountain Bike Men

6 Answers

Yamaha warrior atv [yfm 350] bogging problem


Try checking the switch for your parking brake. It is the top wire in the clutch handle boot. This wire connects to your CDI box, and restricts the RPM's while the parking brake is engauged. To find out for sure, trace the wire down to the plug under the headlight assembly and disconnect it. Now try starting you machine and give it some throttle!

Apr 18, 2009 | 2002 Yamaha Road Star Warrior

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

158 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

yadayada
yadayada

Level 3 Expert

76649 Answers

bazzz7071
bazzz7071

Level 2 Expert

342 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...