Question about 2000 Yamaha DT 125 R

1 Answer

Why doesyamaha dt200r start but not stop 1993 model dt200r

Starts but runs at high revs and wont turn off even with kill switch and key off hard to start from cold

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Sounds like slide in carb is stuck open could possibly be in backwards if ignition switch is wired correct it should kill engine

Posted on May 16, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3567 Answers

SOURCE: I have a Yamaha Riva 50cc. It starts and idles but

Remove and clean the carburetor. That will probably fix the problem.

Please rate this solution. Thanks!

Posted on Apr 02, 2009

NeTTeKco
  • 72 Answers

SOURCE: engin wont stay running

check the spark plug sounds like you gotta fouled plug if that dont work get some carb cleaner and spray the carb out and check the air filter under the seat

Posted on Aug 07, 2009

  • 35 Answers

SOURCE: Wont switch off sing the ignition switch..have to

check the other end of the ingnition wires to the key switch and from the key switch to the selinoid.

Posted on Oct 27, 2009

Benimur
  • 6966 Answers

SOURCE: have a 250cc yamaha virago its been standing for a

Hi and welcome to FixYa,

Almost always, your described problem indicates clogged idling jets. Stale fuel causes varnish like coating which must be removed. This then calls for a carb pulldown, disassembly and soaking non-rubber parts in carb cleaner. In the exploded carb diagram below, the idle (pilot) jet would be # 20.

467dae4.jpg

Good luck and thank you for asking FixYa.

Posted on Nov 17, 2009

  • 8 Answers

SOURCE: went to start bike after sitting for a few weeks

starter relay/solenoid stuck open and drained the battery. charge the battery and replace the relay/solenoid. Sometime you can tap on the relay lightly with a hammer and get it to unstick and work but it's best to replace it.

Posted on Dec 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Lights will not turn off


First you need to isolate the the key switch by unplugging it and test for continuity in the off position witch would mean the switch is bad.

Mar 30, 2014 | 2005 Harley Davidson FLHTCUI Electra Glide...

1 Answer

My 1993 nissan pathfinder wont start i get power to everything but when i turn the key nothing happends i replaced the starter and still wont start nothing happends not a sound could you please help


wire may be loose or your ignition switch could be bad hard telling if it was me id just install push button start cheap and easy to bypass all that

Dec 05, 2012 | 1993 Nissan Pathfinder

1 Answer

Bulldozer quit running now it wont turn over or do anything


check your ground on your starter/starter relay/ground from battery, possibly even a bad start key/switch. Are all your "kill" switches engaged (clutch pedal/brake/seat/door, etc). Since I dont know the model of your bulldozer I am just suggesting the basics. Good Luck

Jun 07, 2012 | 1996 Chevrolet K1500

2 Answers

Ignition key spin around


YOU HAVE BROKEN THE ROD OR RAC IN THE ING.SWITCH . WHEN YOU TURN KEY TO START CAR KEY AND TUMBLER PUSHES A ROD FORWARD TO START CAR. TO TURN OFF IT HAS TO PULL BACK ROD IF ROD IS BROKEN .NO PULL BACK JUST PUSH...........THE STEARING COLLUM WILL NEED TO BE TAKEN APART TO REPAIR .

Nov 15, 2011 | 1996 BMW 318

1 Answer

Wont start , filled gas , changed plugs, can start with ether to airbox but wont continue running


If it wants to start with either then that says there is a fuel delivery problem.
Can you hear the fuel pump run? Maybe run for a few seconds when the key is first turned on.
Has it been run low on gas? Bellow 1/4 often or even empty? Those are good ways to kill a fuel pump.

Sep 27, 2011 | 1993 Suzuki Swift

2 Answers

I have a 93 gsx600f katana I replaced my battery, seliniod, coils, cables, kill switch, cdi box, and kick stand switch. still wont start i press the start switch and nothing. i put a screwdriver on my...


some models need the clutch in (even in neutral) to start, Check if there is a small micro switch under the clutch and check it works with a multi meter

Jun 11, 2010 | 1993 Suzuki GSX 600 F (Katana)

1 Answer

1993 Toyota Corolla revs high and will stay that


Automatic choke stuck on.Replace it the car is running to ritch.

Jul 17, 2009 | 1993 Toyota Corolla

Not finding what you are looking for?
2000 Yamaha DT 125 R Logo

97 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...