Question about 1996 kawasaki VN 1500 Vulcan Classic

Open Question

Needle fell off speedometer on 1995 kawasaki vulcan 1500a. how do you open speedometer to put back on

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 55 Answers

SOURCE: 1995 kawasaki 1500 vulcan jumps out of first gear

first gear shift fork is bent.

Posted on Nov 23, 2008

  • 1 Answer

SOURCE: spark plug gage setting for 1999 kawasaki vulcan

correct setting for your plugs 0.8-0.9mm

Posted on Apr 05, 2009

  • 1 Answer

SOURCE: 1995 Kawasaki Vulcan 800 Speedo stopped working. ???

the speedo cable may be broken i had the same problem and tested the cable and thought it was fine but checked later again and the cable was split inside the cable so may want to check tht again

Posted on Jun 21, 2009

  • 19 Answers

SOURCE: 2004 Kawasaki vulcan 800 classic speedometer cable

Is the actual cable square? There should be a square hole that has to line up with your square cable. Slide the square cable into the square hole, then just screw the nut back on.

Posted on Aug 03, 2009

chevyt1
  • 10 Answers

SOURCE: tail light not working, brake light not working.

try this check the bulb if bad when u put another one in use paper so you dont get oil on the bulb from your fingers this causes the bulb to burn out quicker alson check the switch on the brake might have went bad .if not check all wires make sure all looks pluged in also you should check the fuzes hope this helps

Posted on Sep 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the firing order of a 1994 Kawasaki Vulcan 88 1500A and wires to coil top and bottom?


if it has the original coils the cylinder # is on the coil tower. sitting on bike front is #1 and rear #2.

Jul 22, 2015 | kawasaki Motorcycles

1 Answer

HI This Is Wayne, I have A 1995 Kawasaki Vulcan 1500A! I had a problem with it back firing, and then the front cylinder would start falling down. After 25 rpm, and the bike was warm! I took it to my...


Back firing is often a sign of a lean mixture, more than once I've delt with carbs thinking all was well only to find a small blockage. Did the bike by chance sit with gas i the carbs for a time before this problem showed up? If so, try carb cleaner and lots of compressed air in all the openings especially the idle jet passages. Does not take much to make a difference. Hope this helps. Not always the cure but a good palce to try and very little cost if you do the work yourself.

Sep 25, 2009 | 1996 kawasaki VN 1500 Vulcan Classic

1 Answer

Vn800 meter


Have you checked that the cable is tight? These bikes have a rep for them coming loose. Just take out the bottom bolt of the dash, and lift up; give it an extra 1/2 turn with pliers past finger tight.

Sep 18, 2009 | 1997 kawasaki VN 800 Vulcan Classic

1 Answer

Tail light not working, brake light not working. Is there a connection with both running through that may have gotten unplugged? Where can I find a wiring diagram for a 1993 kawasaki 1500a Vulcan?


try this check the bulb if bad when u put another one in use paper so you dont get oil on the bulb from your fingers this causes the bulb to burn out quicker alson check the switch on the brake might have went bad .if not check all wires make sure all looks pluged in also you should check the fuzes hope this helps

Sep 09, 2009 | 2004 kawasaki VN 1500 Vulcan Classic

1 Answer

94 vulcan 1500A back fires when you decelerate


did you put different pipes on, possibly not enough backpressure, or might have to just adjust carb a little

Aug 26, 2009 | 1996 kawasaki VN 1500 Vulcan Classic

1 Answer

2004 Kawasaki vulcan 800 classic speedometer cable


Is the actual cable square? There should be a square hole that has to line up with your square cable. Slide the square cable into the square hole, then just screw the nut back on.

Aug 02, 2009 | 1995 kawasaki VN 800 A Vulcan

1 Answer

Gas tank


I'm pretty sure it does. I own a 1995 Vulcan and I bought a 2003 tank and looked at the mounting brackets and fuel connections all looked to be the same - but don't put this in stone. I haven't been able to put it on yet because it's still out being painted. There should be no difference in the fuel tank mounts from 1996-1005, but as always, check with a professional if this information is critical.

Nov 10, 2008 | 2004 kawasaki VN 800 A Vulcan

Not finding what you are looking for?
1996 kawasaki VN 1500 Vulcan Classic Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...