Question about Harley Davidson Motorcycles

1 Answer

Low speed miss - Harley Davidson Motorcycles

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Harley Davidson Master
  • 3,506 Answers

What model, year is the bike?? Carburetted or EFI etc??

Posted on Oct 14, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a nissan 1400 champ 95 model.When i drove home bakkie starts to miss like it dont get petrol but if ref high the miss is gone,when low it dies.I have clean it and put new gaskets,still the same


Ignition modules have two sections--a low speed section and a high speed section. Tests of these often are not accurate, so replacement is the only real test.

Aug 12, 2016 | Nissan Cars & Trucks

1 Answer

Kawasaki teryx 2008 750 missing at low speed


Hi, Tony and the usual suspects are:
1. Throttle cables misaligned or misrouted.
2. Damaged or restricted fuel tank venting system.
3. Inlet system air leak.
4. Vacuum piston malfunction.
5. Accelerator pump leaking or no output.
6. Plugged bowl vent.
7. Fuel level in bowl too low.
8. Restricted fuel supply passages.
9. Plugged jets or passages.
10. Worn or damaged needle or needle jet.
12. The enricher valve not seated or leaking.
For more information about your issue and free downloads that you will need please visit the websites below. Good luck and have a nice day.Engine Mis or popping at low speed Kawasaki Teryx Forum
Low speed missing and jerky start Page 2 Kawasaki ATV Forum http://www.militaryatvparts.com/service_manuals/2008-09%20Kawasaki%20Teryx%20KRF750RAF%20Service%20Manual%2099924-1434-02.pdf
http://www.militaryatvparts.com/service_manuals/2008-09%20Kawasaki%20Teryx%20KRF750RAF-OWNERS_MANUAL.pdf

Jan 08, 2016 | kawasaki Motorcycles

1 Answer

2013 800s rzr misses at low speed


Solid state ignition has a capacitor that must charge and when the right time comes a SCR will dump the charge into the coil to make a spark. There is a minimum voltage that is required to trigger the SCR and at low RPMs that normally is close to being not enough. Most likely you will need to change out that CDI ignition or check the coil in the magneto, it may need to be adjusted closer to the flywheel.

Sep 20, 2014 | Polaris 2013 RZR S 800 Orange / White LE

1 Answer

1995 chevrolet tahoe


set the timing to 12 degrees advanced as it is too far retarded for speed. check for side play in the distributor shaft as it will cause missing by altering the setting of the points / ignition module clearance. Separate the ht leads with the ht spacer bars ( available from speed / spares shops.as they will cross jump and cause a miss.

Apr 04, 2014 | 1995 Chevrolet Tahoe

1 Answer

Feels like miss firing at higher speeds


Your caption says misfires at high, then you say low? You have a 95. Lots of miles I assume. So there are several things that would cause misfires at high and low. First is timing chain/belt, sloppy. Second, would be the valves and rings. Valves worn or bent, not seating right. rings just worn out, not holding compression. Do a compression test and see. Low speed or idle misfires can be from vacuum leaks. check hoses. Low and high rpm misfires can be from ignition problems. Wiring, coil/s, ignition modules.

Apr 04, 2014 | 1995 Chevrolet Tahoe

1 Answer

2003 S10 2.2L low speed miss


Could be a vac leak or other ignition problem.
A vac leak could be covered up by the extra fuel and higher idle speed when the engine is cold. And if it is a gasket leaking the leak can get bigger as the engine warms up.
A faulty plug wire or coil could start failing when hot.
A solid miss-fire should make the check engine light come on and set a trouble code.

Jul 05, 2012 | Chevrolet Cars & Trucks

1 Answer

It misses under low rpms


POSSIBLE CAUSES OF MISSING AT LOW SPEEDS. WEAK SPARK AT IGNITION SYSTEM, BAD SPARK PLUGS + WIRES.STOPPED UP FUEL FILTER. DIRTY FUEL INJECTORS,VACUUM LEAKS AT HOSES OR AT THE INTAKE MANIFOLD, LOW CYLINDER COMPRESSION.

Aug 22, 2010 | 2004 Chevrolet Monte Carlo

1 Answer

Engine misses/hesitates on low speeds. Runs fine


is the check engine light on? have you ever serviced the injectors? if not try that first because there are many things that give the symptoms you spoke of. but this is the cheapest.
vbninja E.A.P

Jul 23, 2010 | 2005 Cadillac CTS

1 Answer

Engine missing at low speeds


MISSING AT LOW SPEEDS CAN BE BAD SPARK PLUGS AND WIRES.CLOGGED FUEL INJECTORS.CLOGGED FUEL FILTER.INTAKE MANIFOLD LEAKS.LEAKING EGR VALVE.SHORT IN COIL WIRES CAUSING WEAK SPARK.

May 29, 2010 | 2000 Ford Focus

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

Mike

Level 3 Expert

4340 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...