Question about 2009 Skyteam ST250 SM

Open Question

Where can i find the workshop manual fo skyteam st 250 sm?

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

tellme2
  • 137 Answers

SOURCE: Can you tell me the oil capcity on the Skyteam ST

hi m8,, no u dont need separate oil m8,, one oil 4 all,,on the filler cap usually on the right side of the bike, either will have a dip stick attached to the cap, or a spy glass at the bottom of the engine casing that u r filling,,or u will have a number stamped on the filler cap or casing,,ie ,2500ml or 3000ml,, this stands 4 2500ml is 2 and a half litres ,,or 3000ml stands for 3litres of oil,,

Posted on Mar 26, 2009

  • 3567 Answers

SOURCE: it starts revs then cuts out

Remove the water trap bowl at the bottom of the petcock, (gas valve). Any water or trash in the bowl? Drain a cup of gas from the tank. Any water or trash in the cup? Dump it, clean it and re-mount it, ( not all bikes have a water trap bowl ). Remove the carburetor from the engine.

Remove the float bowl and clean the entire carb with a spray carb cleaner from the auto parts store. Wear protective goggles to avoid getting spray in your eyes. Spray into all the little airways and fittings in the carb. Remove the two screws on the outside throat of the carb and spray into the screw holes as well.
< < READ CLOSELY > >
Be sure to put these two screws back in the same hole they came out of. IMPORTANT > do not tighten these two screws down. Only screw these in until they LIGHTLY seat. Now turn each screw one and one half turns outward. Put the rest of the carb back together, clean the air filter and install the carb. Be sure the bolts are tight. Let the float bowl fill then start the engine. Set the idle speed with the idle screw. This process should get you back on the road.


Please rate this solution. Thanks!

Posted on Apr 07, 2009

  • 3567 Answers

SOURCE: does anyone know the top speed for a Skyteam ST

70 mph.

Posted on Apr 08, 2009

  • 1 Answer

SOURCE: Skyteam ST 125 TR parts

hi these people stock parts for the st125tr.

Adrian Thompson.
Director Sales & Services

T.O.R.Ltd
TORlimited@aol.com
01484 710915
07962 260163

http://www.Tormotouk.com

Posted on Nov 06, 2009

  • 3 Answers

SOURCE: where could i get a igniston barrel from for my

You should be able to get one from chinesebikespares on the net. if you do search you should find them. I use them to get parts for my Skyjet 125. Very speedy service.cheers

Posted on Aug 10, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

None of my lights work on my skyteam 125cc


not illegal if you run daytime only as far as im aware, would start with checking the plug from the switch gear, then check the wiring, and the switch itself, use a meter to locate faults, if this is anything like my chinese bike, ya best of rewiring the lights to stay on permanent

Oct 05, 2012 | 2004 Skyteam ST 125 SM

1 Answer

When i put the indercators on they dont flash just stay on... is it to do with the wiring ?


Check the bulbs on the bike I bet you one of them is burned out.If not try a new flasher unit. Good Luck

Oct 24, 2010 | 2004 Skyteam ST 125 SM

1 Answer

Am looking for the manual for a skyteam st 125y


e-mail maggie@skyteam.cn

I had a reply with manual attached within half an hour

Bigkendo

Apr 30, 2010 | 2004 Skyteam ST 125 Y

1 Answer

What is the fork oil capacity please?


Remove the top caps from the forks and pull the springs out, fully compress the forks and fill them so that the oil is 150mm from the top. Refit springs and caps.

Aug 08, 2009 | 2004 Skyteam ST 200 SM

3 Answers

Skyteam ST 125 TR parts


hi these people stock parts for the st125tr.

Adrian Thompson.
Director Sales & Services

T.O.R.Ltd
TORlimited@aol.com
01484 710915
07962 260163

http://www.Tormotouk.com

Apr 21, 2009 | 2004 Skyteam ST 125 TR

1 Answer

Winter storage


what to do with fluids?If your brake fluid is in need of changing do so before long-term storage. Similarly hydraulic clutch fluid should be changed before you store your bike; both systems may suffer failure if moisture gets in. Also make sure your coolant is fresh, as deposits can form from old fluid. For service intervals, consult your owner's manual.,,,

Nov 10, 2008 | 2004 Skyteam ST 200 SM

1 Answer

T-clocs


tires control lights oil, chassis, stands,,,

Nov 10, 2008 | 2004 Skyteam ST 125 SM

Not finding what you are looking for?
2009 Skyteam ST250 SM Logo

Related Topics:

43 people viewed this question

Ask a Question

Usually answered in minutes!

Top Skyteam Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75197 Answers

Nicola Conroy

Level 3 Expert

1373 Answers

Are you a Skyteam Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...