Question about 2010 Vento Phantom r4i

Open Question

How do I disable my alarm on my vent phantom gt5

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can the car alarm kill your battery but you can start the car but after you turn it off battey died again


sure, if you let the alarm drain the battery, this can destroy any stock battery.
The car batteries are not like golf carts and are not deep discharge rated. (so can be damaged)
so charge the battery, if it wont hold a charge, it is bad.
if it discharges silently, and darkly parked , that is phantom discharge
if is discharges , driving that is a engine charge system failure.
parked over night discharging is phantom discharging.
if the alarm goes off and stays in alarm , then dont use, it.
if the battery is happy with the alarm defeated then the Alarm is bad.

The battery measure 12.6vdc charged,(rested) "voltmeter"
and running measures, 13.3 to 15vdc at idle.

this one tool can solve this problem
http://www.walmart.com/ip/Equus-Innova-3721-Battery-and-Charging-System-Monitor/15137663

cheap.

Dec 05, 2014 | 2000 Chrysler Cirrus

1 Answer

My car alarm comes on randomly and I would like to disable the alarm.


The easiest way to disable the alarm is simply to cut the power wire to the alarm horn. When you have more time, you can try to locate the actual power wire to the alarm, which is usually hidden so thieves can't find it.

Jan 21, 2014 | 2006 Mercedes-Benz CLK 500

1 Answer

Disable back-up warning on Drive Phantom Scooter


Most of these units have the back up buzzer shrink-wrapped together in the wiring harness under the rear shroud. aka motor cover. The buzzer is typically between the size of a 25 and 50 cent piece, is black and has two very small wires coming out of it - one red and one black. You can cut one wire where you can reconnect it later - just in case you cut the wrong wire!

Dec 09, 2011 | Drive Medical Phantom 3 Wheel Scooter, Red

1 Answer

How do I turn off the alarm clock


Hello

The unit has 2 alarms (alarm 1 and 2). They can be used

together or independently. Alarms 1 and 2 have different

sounds so that you can differentiate them. The alarm will
sound for 1 minute unless it is disabled.

To set the alarm:

Navigate to "Set Alarm" setting mode as shown in the

Changing Settings section. The order of the settings is;
alarm 1 or 2, hour and minute.

To enable or disable the alarm:

• Press MENU until you reach alarm 1 or 2 display.

• Press [UP] or [DOWN] button to enable or disable the
alarm. "-:--" means disabled.
OK.

Sep 14, 2011 | Oregon Scientific WR108 Weather Radio

1 Answer

How to connect behringer ultragain pro mic


Here is the manual:http://www.behringer.com/EN/downloads/pdf/MIC2200_P0054_M_ENG.pdf Plug your microphone into the input using a proper cable. Plug another balanced cable into the output on the back and plug it into a microphone input on the mixing board. If your mixing board already has phantom power, disable it for that input as the MIC2200 has phantom power. Read the manual carefully and take note of the directions for phantom power and balanced cables. Make sure you follow the directions carefully. If you need the manual in a different language look the MIC2200 up under products at Behringer.com and you can download in pdf format in many different languges.

Aug 27, 2009 | Behringer Ultragain Pro Mic2200 Microphone

3 Answers

1997 Honda Civic: Battery died and the Alarm won't disable


If you hook up the jumper cables can you disable the alarm with the remote?

Jun 24, 2009 | 1997 Honda Civic

1 Answer

Disable alarm 1999 dodge intrepid


HOW DO I MANUALLY DISABLE THE ALARM FOR A 99 DODGE INTREPID

Jun 14, 2009 | 1999 Dodge Intrepid

3 Answers

Phantom 3 wheel scooter back-up alarm


Easy fix; pull the floor board off by removing the 2 phillips screws. There is a round, black piezo with 2 wires connecting it; a red wire, and a black wire. Cut either of the wires, and then tape both ends of the cut wire to prevent it from grounding out on something. No more annoying noise. To hook it back up, shave the wire's insulation back and connect the wires again, but I don't know why anyone would want that installed again; I guess so someone doesn't back over a dump truck in the scooter ;).

I think the funniest thing (April Fools Day Prank) to do with that damn alarm would be to hook it up to a toilet seat lid, but in a way that the alarm only goes off when the seat is lowered, so if someone had to take a dump, they'd have to listen to the alarm...this might keep employees from taking 30 min bathroom breaks ;)

Oct 14, 2008 | Drive Medical Mini Phantom Three Wheel...

Not finding what you are looking for?
2010 Vento Phantom r4i Logo

Related Topics:

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top Vento Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Brad Brown

Level 3 Expert

15557 Answers

Are you a Vento Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...