Question about 2006 KTM 250 SX-F

Open Question

Ktm 200 leaking oil from head - 2006 KTM 250 SX-F

Posted by Anonymous on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
messstat
  • 365 Answers

SOURCE: my 2003 KTM SX 200 lacking bottom end, top just rebuilt

isn't that a two-stroke? pull the jug off and check the piston/bore...if you can do that you're okay...Otherwise, call "Lazarus" at GT Thunder in Millersburg, FL and ask NICELY what to do.
P.S. he's a BUSY man be NICE to him!

Posted on Jun 15, 2009

Ad
  • 314 Answers

SOURCE: would too much oil in case make oil leak on 2004

All engines have a oil level .if too much oil is put in an engine ,above the recomended level then pressure produced when the engine is running will force ouil into places its not meant to go .This will cause oil leaks in any number of places and could cause damage to seals or correct running of the engine .

Posted on Mar 13, 2010

Testimonial: "thanks fast feedback "

TerryTown
  • 292 Answers

SOURCE: head tourque wrench setting

Thank you for contacting FixYa with your inquiry. I have been going
over some of the older help requests that have been archieved and
trying to provide solutions for those that didn't get answered. Hope
this information helps.

KTM Torque settings


  1. Collar screw, front wheel spindle Front axle nut 40Nm 30ft lbs
  2. Brake Caliper front Brake Caliper front Loctite 243 2 19ft lbs
  3. Brake Disk, front Brake disk front Loctite 243 1 11ft lbs
  4. Brake Disk, rear Brake disk rear Loctite 243 1 11ft lbs
  5. Clamping screws, upper fork bridge Top triple clamp 20Nm 15ft lbs
  6. Clamping screws, lower fork bridge Bottom triple clamp 15Nm 11ft lbs
  7. Clamping screws, fork stubs Front axle pinch bolts 10Nm 7ft lbs
  8. Collar nut, rear wheel spindle Rear axle nut 80Nm 59ft lbs
  9. Hex nut swingarm bolt Swingarm nut 100Nm 74ft lbs
  10. Hex collar screw handlebar clamp Upper handlebar clamps 20Nm 15ft lbs
  11. Allen head screw handlebar support Lower handlebar clamps Loctite 243 4 30ft lbs
  12. Shock absorber top Shock absorber top bolt 60Nm 44ft lbs
  13. Shock absorber bottom Shock absorber bottom bolt 60Nm 44ft lbs
  14. Sprocket screws Rear sprocket bolts Loctite 243 3 25ft lbs
  15. Ball joint for push rod Rear brake pedal pivot Loctite 243 1 7ft lbs
  16. Engine mounting bolts Engine mounting bolts 45Nm 33ft lbs
  17. Engine brace Engine brace 33Nm 24ft lbs
  18. Screw adjusting ring spring preload Shock preload collar bolt 8Nm 6ft lbs
  19. Spoke nipple Spokes 5Nm 4ft lbs
  20. Other Screws on chassis M6 10Nm 7ft lbs
  21. M8 25Nm 19ft lbs
  22. M10 45Nm 33ft lbs
  23. Other collar nuts on chassis M6 15Nm 11ft lbs
  24. M8 30Nm 22ft lbs
  25. M10 50Nm 37ft lbs
  26. Front Sprocket 44ft lbs
TF

Posted on Oct 29, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 KTM EXC 200 cylinder head bolt torque specs


Hi, Amy for this scenario you will need your service manual, parts fiche, and owners manual if you can't find the best tool you ever bought for your KTM, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
torque specs for cylinder head on 00 ktm200
http://www.ktmshop.se/documents/cb32ff6ceaa548abc7b89e51793776e1.pdf
KTM 125 Repair Manual and 200
https://www.partsfish.com/page/oem-parts-for-ktm
KTM 125 Owner Handbook Manual

Feb 04, 2018 | 2002 KTM EXC 200

1 Answer

How much engine oil do I put in a 2010 ktm 150sx


Hi, Neal sorry you can't find the first and best tool you ever bought for your KTM despair not for a mere $10 you can download another one. For more information about your issue and free downloads that you will need please visit the websites below. Good luck and have a nice day.
ktm 150sx oil KTM 2 Stroke
http://www.ktm-parts.com/pdf/TechBull/TB0802.pdf
1999 2010 KTM 125 200 SX EXC Service Repair Manual pdf pdf
http://www.ktmshop.se/documents/1241c3e942689a278e03af1a667ab2c6.pdf
http://www.ktm.com/globalassets/product-manuals-pim-data/dok_bike_bed_6175j0_om_en__sen__aepi__v1.pdf

Jan 14, 2016 | KTM Motorcycles

1 Answer

I have a 99 ktm 250 sx. Had to get cylinder replated and a new piston. I put the bike back together and oil was leaking from the front lower end of the cylinder and i wont idle. Took the bike back ap


If there is a leak in the head gasket it will never run properly. Maybe the carburetor is plugged if it has sat for a while. The gas/oil mixture can go bad over time. The leak could be from a loose gas line. Or possibly even oil dripping from the oil filter if you just cleaned and re-oiled it.

Aug 10, 2013 | Motorcycles

2 Answers

2002 ktm 250 dirtbikes oil leak between cylinder and head by exhuast port


Hi, Anonymous to find the source of your oil leak, start at the point where you see oil and trace its path going up and forward, blowing baby powder from the palm of your hand will help in those difficult to see areas if there is too much oil present then buy a spray can of engine degreaser apply it to the affected area then rinse off with a pressure wand or garden hose, use compressed air to blow off excess water or just let it drip dry, take your bike for a 15 minute ride and check for the leak.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
2002 250 EXC Case Oil Leak
Engine leaking oil through tiny cast hole under exhaust
KTM 250 SX 2005 Repair Manual
http://www.partsfish.com/page/oem-parts-for-ktm
KTM 250 SX Owner Manual

Apr 02, 2017 | KTM SX 250 Motorcycles

1 Answer

Fork oil capacity for KTM 200 EXC 2005


https://youtu.be/kUzEuHYjodo

Oct 06, 2012 | 2005 KTM EXC 200

1 Answer

2003 KTM SX 200 coolant leak breather pipe


Hi, Shaunofnhe for this scenario you will need your service manual, parts fiche, and owners manual if you can't find the best tool you ever bought for your KTM, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
http://motocrosshideout.com/2011/08/19/why-is-coolant-coming-out-the-overflow-tube
Leaking coolant
http://www.motogelnar.cz/manual/KTM/KTM125-200_1999-2003ServiceManual.pdf
https://www.partsfish.com/page/oem-parts-for-ktm
http://mybikemanuals.com/ktm/ktm-uncategorized-owners-manuals

Nov 27, 2017 | 2003 KTM SX 200

1 Answer

What are some common problems with the ktm 530 exc-r 2008


as with all bikes of this nature, check for runout in wheels, loose spokes, lighting working, suspension not leaking, brake discs for exsess wear, check coolant level , check engine oil for evedence of water, leaking water pump, radiator cap leaking past overflow pipe this could be pressure in system due to head gasket failure, fuel leaking, also check area around eng oil plug for evidence of repaire with cemical metal or similar, slightly noisy tappets is not uncommon,, normaly prety good bike, avoid bikes that smoke exsessive, check all gears are working correctly. dont jump out of gear ride in every gear and check for mechanical noise from gearbox, good gearbox normaly easy to select, doesnt jump out of gear, if u are looking at buying a bike of this nature they are fairly high maintenance, like to be cleaned , oiled and addjusted frequent oil changes, these are basic things i would check when buying a machine of this type, not nessasary a ktm, and these coments are not meant to harm your decision only help you chose the rite one.

Jan 05, 2011 | 2008 KTM 530 EXC-R

1 Answer

My 2003 KTM SX 200 lacking bottom end, top just rebuilt


isn't that a two-stroke? pull the jug off and check the piston/bore...if you can do that you're okay...Otherwise, call "Lazarus" at GT Thunder in Millersburg, FL and ask NICELY what to do.
P.S. he's a BUSY man be NICE to him!

Jun 15, 2009 | 2003 KTM SX 200

Not finding what you are looking for?
2006 KTM 250 SX-F Logo

Related Topics:

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top KTM Experts

yadayada
yadayada

Level 3 Expert

79865 Answers

bazzz7071
bazzz7071

Level 2 Expert

342 Answers

Steve Banks

Level 2 Expert

232 Answers

Are you a KTM Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...