Bike has been siting at least few years... last time was started...only way to get to start was squirt gas in carb... ran like ****. wanted to try to get to jets and clean or replace
So what is it you want to know?
How to remove carb?
What to check/clean on it?
Where to get jets?
SOURCE: Won't start?
With just this info.Not knowing if the engine is stock or has bigger cams or high comp pistons.I would say check the starter solenoid by running jumper wire from one side to the other.then check ALL connections for corrosion and tightness
SOURCE: I have Harley Davidson 2000 Sportster 883. I
Neg cable corroded thru.
I bet you have 12v at the battery and less at the other end of the neg cable.
I had the same problem.
SOURCE: 2003 Harley Davidson XL 1200 C Sportster Custom
I would guess stale gasoline or fuel. Try fresh fuel in the tank. If this doesn't clear the problem, you could need to have your carburetor or fuel injection system cleaned. I'm not even sure if they put fuel injection on Sportsters since I don't work on fuel injected bikes. I mostly work on the older bikes like Panheads, Shovelheads, Evos. Not too many Sportsters but have worked on a lot of Ironhead Sportsters. Try the fuel first. It's a cheap fix. Hope it works for you. Good luck with the knee replacement. My wife had one knee replaced and it works great.
SOURCE: 2000 Harley Davidson XLC Sportster 883 won't start
the heat from the bulb being continiuosly on may have melted a wire inside your headlight?
249 views
Usually answered in minutes!
×