Question about Harley Davidson FLSTC Heritage Softail Classic Motorcycles
Posted by Anonymous on
I am sorry but my expertise does not extend to 1992 models. It should be an easy thing to just start removing what obviously is related to that area of the bike and do it bit by bit. Take pictures as you go to remind you how to put it back together again. Is the speedo in a console on the fuel tank?
Posted on Oct 14, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
first take off the brake caliper takes a 10 mm socket..Next jack front of bike up just enough to take pressure off front tire...take off the axle nut lbit more to take pressure off axleock washer and flat washer...Next remove two axle support nuts from the right side of bike 1/2 in socket. now jack bike up a hair more to releave pressure off axle push, hammer with a rubber hammer or what ever it takes to drive it through. jack bike up so it clears fender. Sometimes the tire won't clear the fender bolts if so just release air from tire and it will clear. good luck. Its not hare at all.
Posted on Jun 14, 2009
To remove the ignition switch turn the handle bar fully to the right, turn the ignition switch to access position and with the key in the switch depress the tab under the switch with a small screwdriver (the tab is to the lower left under the knob) and while pressing down on the key, turn the key counterclockwise about 60 degrees. At that point the switch will pull out of the housing.
Posted on Nov 17, 2009
The fork oil is a very specific job needing a manual and a special tool, I don't want to insult anyones mechanical knowledge but if you have never done it before, best to take somewhere else. Engine oil on the other hand is easy, the drain tube to any softail is on the right side by where the frame meets the swing arm, has somekind of plug in it. Start and run bike for a little while, long enough to get it warm but not hot. Remove fill plug and then remove plug in drain line. Using a peice of cardboard or something put in between filter and frame , directing the oil to your drain pan instead of where ever it goes. Put 1 qt oil back in (after everything is reinstalled) start the bike and make sure the oil light goes out, when it does shut bike off and fill to the point that when it is standing upright you get a little oil on the tip of your finger, over filling may result in loss of oil cap from pressure (been there)
Posted on Feb 16, 2010
Tips for a great answer:
Sep 27, 2015 | Motorcycles
Feb 03, 2015 | Harley Davidson Motorcycles
Dec 05, 2012 | 2000 Harley Davidson FLSTC Heritage...
Oct 12, 2012 | Harley Davidson Motorcycles
Jun 18, 2012 | 2000 Harley Davidson FLSTC Heritage...
Mar 30, 2012 | Harley Davidson FLSTC - FLSTCI Heritage...
Jul 11, 2010 | 2004 Harley Davidson FLSTC - FLSTCI...
Jul 10, 2010 | 2008 Harley Davidson FLHX Street Glide
Jul 25, 2009 | 2005 Harley Davidson FLSTC - FLSTCI...
May 08, 2009 | 2000 Harley Davidson FLSTC Heritage...
39 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: