Question about 2000 Harley Davidson FLHRCI Road King Classic

1 Answer

What is 2013 Harley Davidson FLHX u1040 code?

Posted by Anonymous on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Harley Davidson Master
  • 3,506 Answers

U1040 = Loss of ABS serial data (state of health)

Posted on Oct 16, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

jimmy nutron
  • 132 Answers

SOURCE: what type of motor oil used in 1994 harley davidson 883

harley recomends that you use their oil but i would be carefull because it is a cynthetic now if you were using regular oil what that will do is clean all the old build up out of the motor this can be bad because after time there are pin hole leaks that occure but the build up stops it from leaking but if you use cynthetic you cant go back to regular oil it will gum up on you and ruen your motor so you got to find out what has been put in it. but use a 10-30

Posted on Jun 05, 2009

tundrajet
  • 80 Answers

SOURCE: removing harley davidson ultra classic gas tank

Drain the fuel either by siphening or removing the cross over tube at the front of the tank and letting it drain that way or just block off those cross over lines and leave the fule in the tank for removal.

0) remove seat
1) drain fuel
2) undo cross over line (bottom front of gas tank.
3) shut off pet **** and remove fuel line from pet ****.
4)there should only be 2 bolts holding the tank on, one at the top front of the tank and one at the back of the tank.

All in all a pretty easy (but possibloy messy) job.

Posted on Jun 06, 2009

OneRide
  • 379 Answers

SOURCE: how to shut off alarm on a 2002 harley davidson heritage soft tai

I long push on the remote turns it on, 2 quick clicks turn it off.

Posted on Jun 26, 2009

  • 69 Answers

SOURCE: 2002 harley davidson ultra classic setting the clock

Turn the Bike on and the Radio off and then follow the buttons on the screen. Most people think you have to do it while it is running and this does not work

Posted on Jun 28, 2009

  • 17 Answers

SOURCE: harley davidson flstc heritage softail 1997

The fork oil is a very specific job needing a manual and a special tool, I don't want to insult anyones mechanical knowledge but if you have never done it before, best to take somewhere else. Engine oil on the other hand is easy, the drain tube to any softail is on the right side by where the frame meets the swing arm, has somekind of plug in it. Start and run bike for a little while, long enough to get it warm but not hot. Remove fill plug and then remove plug in drain line. Using a peice of cardboard or something put in between filter and frame , directing the oil to your drain pan instead of where ever it goes. Put 1 qt oil back in (after everything is reinstalled) start the bike and make sure the oil light goes out, when it does shut bike off and fill to the point that when it is standing upright you get a little oil on the tip of your finger, over filling may result in loss of oil cap from pressure (been there)

Posted on Feb 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What is U1040 & 1016 code on Harley2009 FLHX stand for?


in obd=2 codes code p 0117 refers to engine coolant temperature (ECT) sensor --- circuit malfunction=== causes ---coolant thermostat---wiring short to ground---wiring short to positive ---ECT sensor
p 0118 is the same ECT sensor malfunction with the added causes of ===wiring open circuit / short to positive --- wiring short to ground ---ground wire defective --- ECT sensor
check with a service center to confirm that and for the U codes which normally refer to busbar connections

Jun 20, 2016 | Harley Davidson FLHX Street Glide...

1 Answer

I have a 2013 road glide and just painted inner faring and hand controlled I got it all back together and the dash will light up but I have no ignition to the motor or turn signals or alarm I also checked...


the part numbers are just part numbers, no diagnostic significance for your problem.

U1040 is a priority 8 and = Loss of ABS serial data

You will need to find out what wiring or connector(s) etc was/were damaged when you had the inner fairing off.

May 03, 2014 | Harley Davidson Motorcycles

1 Answer

How to replace grips on a 2013 flhx


Hi Anonymous, cut the old ones off with a knife or box cutter, then champher the end off the plastic throttle sleeve with file or sandpaper then apply grip glue to the grips and slide them on. Good luck

Apr 23, 2014 | 2008 Harley Davidson FLHX Street Glide

1 Answer

2012 Road Glide Ultra. 16k miles. w Thunder max ECM. Throwing code U1040. What is it and what is the solution?


U1040 = Loss of ABS serial data

Does the "CHECK ENGINE" light stay on?
If not, then it's a "HISTORIC" code (not current).

Clear the code and see if it comes back, as it might have just been a glitch.

Oct 16, 2013 | 2008 Harley Davidson FLHX Street Glide

1 Answer

The key light on the dash of my 2013 FLHX street glide came on


Hi Anonymous, you may have to do an alarm reset, for more information about your question please visit the website below. Good luck and have nice day.
Set Change Override Transport Harley Security Alarm PIN Code No Key Fob...

Mar 15, 2013 | Harley Davidson FLHX Street Glide...

1 Answer

While motor running the security light stays on .2008 harley davidson flhx


Hi Cshester, you may an alarm reset, for more information about your question please visit the website below. Good luck and have nice day.
Set Change Override Transport Harley Security Alarm PIN Code No Key Fob...

Aug 06, 2011 | 2008 Harley Davidson FLHX Street Glide

Not finding what you are looking for?
2000 Harley Davidson FLHRCI Road King Classic Logo

Related Topics:

170 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Gills Lango

Level 2 Expert

195 Answers

Mike

Level 3 Expert

4336 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...