Question about 1994 Suzuki RF 600 R

Open Question

1994rf600 ran well ,then lost spark, replac cdi, still no spark, could 2 coils go down together or is there afuse other than fusebox?

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 25 Answers

SOURCE: fresh rebuild now no spark

If it ran before, I would double check your electrical connections. Its more likely you didn't get a connector pushed all the way together or left off a ground wire. The ignition coil specs are generally 1 ohm or less on the primary (small Wire) side, and 5K-10K ohms on the secondary (spark plug) side. Each side should be tested to ground. Pick-up coils are typically open or really large ohm reading in Megaohms normally and around 100 ohms when the magnet on the flywheel passes by. there is no way to test the CDI box other than putting it on a know running bike or getting a known good CDI and putting it on your bike. Double check that the spark plug cap is secured to the high tension lead as well. Testing the stator is a little more complicated, but a quick way is to close the gap on an old spark plug to about 0.010" and see if there is a week spark. If so, the stator will need to be replaced.

Posted on Jun 16, 2009

wd4ity
  • 4565 Answers

SOURCE: suzuki gn125 wont start. checked carb, cdi, coil.

Check the valve adjustment. If a valve is standing open just a little, the compression will be too low to start the engine. Check fuel delivery by dribbling a little gasoline into the carb and try starting the bike. If it starts and runs for a second or two, you're not getting fuel into the cylinders. Check you carb again.

Posted on Oct 19, 2009

czaa
  • 4514 Answers

SOURCE: I Only get 1 spark. Replaced CDI unit.

maybe--just go buy a clymer repair book and become a pro like us at the fix

Posted on May 17, 2010

  • 879 Answers

SOURCE: 1996 gsxr 750 no spark how do i test cdi

Use a digital multi meter to check it.

Posted on Aug 12, 2012

  • 2 Answers

SOURCE: engine runs on 2 cilynders only no spark on second curcit on the cdi

swop your plugs cable and see if you get spark then you know you have to replace the cables.

Posted on Oct 08, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does my new coil (coil 1) cut in and out?


Not sure what bike you have. I ran into a similar problem with several small engines and the CDI box was the culprit. Replacing with a new coil seemed to fix the problem but it would come back when the box cooled down. You may also try looking for chewed wires on your ECU. Look very closely for any missing insulation on the wire. You may also want to double check the connections to the coil to make sure they are snug.

Aug 24, 2014 | Motorcycles

1 Answer

1981 Suzuki gn400 no spark


I know it sounds silly, but have you checked your earth or ground wiring. If not earthed this type of problem can occur. Did the bike run before you replaced your coil etc? You could have a crook CDI
are you using multi meter mate for correct voltage readings?

Feb 09, 2014 | Suzuki Motorcycles

1 Answer

Mx360 cdi circuit


Hi, Anonymous all this electronic brain surgery is above my pay grade Good luck and have a wonderful day.

Jun 24, 2017 | Yamaha Motorcycles

1 Answer

Hi i have a dinli 100cc quad bike .the quad will nt start and there is no ignition i have checked the spark plug so can you help me if you can i will be very happy


I assume that is a 100cc, 2 stroke ATV? If the starter motor is spinning, and you just don't have any spark. First, replace the spark plug. If that doesn't fix it, then you may have one of the following problems: Bad CDI, Kill Switch or Rip Cord Shut off switch, Frayed wire shorting out, cracked/damaged spark plug cap, bad coil or coil wire, bad stator. My bet is on the kill switch and/or Lanyard/Rip Cord shut off switch or the CDI. You can bypass your shutoff switches to see if they are the problem by either disconnecting the wires or connecting them together(depending on the type of system you have). CDI's routinely fail on small engines and generally cost about $20-$70, depending on the style. www.solanocycle.com

Jan 02, 2011 | Derbi Cross city Motorcycles

1 Answer

Honda XL200R was running great but leaked oil bad so I tore it apart and replaced the head gaskets and piston rings, put it back together now ive got no spark. The head lite comes on when I kick it but the...


well your magneto is fine(because your headlight works when you kick it over) I bet it is something as simple as you forgot to hook up a wire since you had it all taken apart. since your magneto is fine that just leaves #1 coil....or....#2 cdi box.....to find the coil just follow the wire from your spark plug to it....your CDI box should be mounted under the seat( make sure all the wires are hooked up ) and check again.....

Aug 15, 2010 | 2002 Honda XR 200

1 Answer

No spark at spark plugs so wont fire new battery all connections and grounds seem good was sitting for 3 months and ran at that time someone had turned on key and ran down the bat. so replaced but now have...


Check the coils first, leaving the key on may have burnt out part of your ignition system.
Easiest way to check coils is to pull one lead off, plug a spark plug into it. Run a hot wire from the positive side of the battery to the coil ( Do Not Plug it in!!) . If you flash the wire on and off the power side of the coil it should make a spark jump across the sparkplug ( don't forget to earth the base of the plug.)
If the coils are ok, see if you can borrow a CDI unit to try in your bike ( it is good to have mates with the same brand of bike )
Don't forget to check all fuses first and make sure the "Kill Switch" on the handlebars is on.
Happy fault finding.

Mar 29, 2010 | 1986 Yamaha FJ 1100

1 Answer

Lost spark on a chinese 50cc scooter


Change the induction coil or change the spark-plug.

Aug 25, 2009 | 2005 Suzuki RM-Z 250

1 Answer

Fresh rebuild now no spark


If it ran before, I would double check your electrical connections. Its more likely you didn't get a connector pushed all the way together or left off a ground wire. The ignition coil specs are generally 1 ohm or less on the primary (small Wire) side, and 5K-10K ohms on the secondary (spark plug) side. Each side should be tested to ground. Pick-up coils are typically open or really large ohm reading in Megaohms normally and around 100 ohms when the magnet on the flywheel passes by. there is no way to test the CDI box other than putting it on a know running bike or getting a known good CDI and putting it on your bike. Double check that the spark plug cap is secured to the high tension lead as well. Testing the stator is a little more complicated, but a quick way is to close the gap on an old spark plug to about 0.010" and see if there is a week spark. If so, the stator will need to be replaced.

Jun 16, 2009 | 2003 Suzuki RM 125

3 Answers

1986 gsxr 400.not sparking r starting


Hi and welcome to FixYa,

If somehow, the CDI could be opened up, then component level repair maybe tried. There would be 2 final transistors that actually do the switching; 1 for each coil. Offhand, it would appear that 1 of those 2 is faulty. Otherwise, replacement is the only option.

Incidentally, in some versions, a fault in the tachometer could also cause one of the CDI's output to fail.

Postback results of tests.

Good luck and thank you for using FixYa.

May 27, 2009 | 1996 Honda CBR 400 RR

Not finding what you are looking for?
1994 Suzuki RF 600 R Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Ed Nelson
Ed Nelson

Level 2 Expert

149 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...