Question about Yamaha YZF-R1 Motorcycles
Posted by Anonymous on
Hi Anonymous perform the following tests:
1. Fill acid type batteries to proper levels.
2. Charge battery overnight at 1-2 amps you need 12.5 volts or better after charging.
3. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Hook up battery positive cable, then with your multimeter on the milliamp scale connect one lead to the negative battery post and the other lead to the ground cable. Meter should read 3 milliamps or less, 10 milliamps with a radio, 15 milliamps with radio and CB. If your multimeter reads higher you need to isolate the circuit by pulling fuses and circuit breakers one at a time and observe multimeter for a drop in amperage then get out your test light and track down the short in that circuit.
5. Hook up the multimeter to the battery set it to DC volts and start the engine if multimeter falls below 9.0 volts while cranking you need to perform a proper load test on the battery and replace if necessary.
6. With the engine running at 3600 RPM, the battery should read 14.3-14.7 volts if not continue tests.
7. Unplug the voltage regulator from the alternator at crankcase by the front of the primary cover.
8. To test voltage regulator go to https://www.youtube.com/watch?v=F8EjV0IjW9Q
9. With the multimeter set to the ohms scale, with one lead grounded, touch an alternator pin ohmmeter should read infinity, if not replace the stator.
10. With both leads touching alternator pins multimeter should read 0.1 to 0.2 ohms on 1989 and later models. 0.2 to 0.4 ohms 1988 and earlier models, if not replace the stator.
11. With the multimeter set on AC volts scale, both leads touching alternator pins multimeter should read 16 to 20 volts AC for every 1000 RPM'S 1989 and later and 19 to 26 volts AC for every 1000 RPMS. If not replace the rotor.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
bike wont hold charge killed new battery Yamaha R1 Forum YZF R1 Forums
Battery won stay charged on R1
OEM parts for Yamaha
Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e
Posted on Oct 26, 2016
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Have u checked the battery to see if it's good? If so then check your main fuses and if there good be ready to spend some money on a stator. Hope that helps u
Posted on Dec 30, 2011
Tips for a great answer:
Jan 24, 2018 | 2005 Yamaha YZF-R1
May 09, 2014 | 2004 Yamaha YZF-R1
May 05, 2014 | 2006 Yamaha YZF-R1
Apr 25, 2014 | 2005 Yamaha YZF-R1
Dec 30, 2012 | 2000 Yamaha YZF-R1
Oct 14, 2012 | 2010 Yamaha yZFR1
Jun 22, 2012 | 2005 Yamaha YZF-R1
Jun 12, 2011 | 2001 Yamaha YZF-R1
Aug 09, 2010 | 2006 Yamaha YZF-R1
Apr 27, 2010 | 1999 Yamaha YZF-R1
15 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: