Question about Honda CBR 600 RR Motorcycles

2 Answers

After warm up bike will not idle at all.tried idle adjustment no go.just got the bike.it is still unframilliar 2 me

Posted by on

  • CJ Monaco May 11, 2010

    What is the make and the model and what year....

×

Ad

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 207 Answers

Make sure your turning the idle adjuster to the right

Posted on Jun 23, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Bought carbs off ebay for yamaha xj550 but think pilot screws have been adjusted as bike wont idle after warm up as the pilot screws are preset at factory and the manual dose not give any info dose anyone know what factory setting is? how many turns from fully screwed in should they be set?

Posted on Jun 19, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2007 cbr600rr, and I have noticed lately my bike idles around 1900-2000rpm, normal is around 1400-1500rpm(this is when the bike is warm), also when using the engine for braking it feels a little...


Hi, Anonymous and the usual suspects are:
1. Throttle cables improperly adjusted, pinched or need lubrication.
2. Idle adjusting screw needs to be backed off.
4. Air fuel mixture adjusted too lean start with 2 full turns.
5. Intake system air leak.
6. Fast idle choke ramp is not releasing.
7. Broken throttle return spring.
8. Damaged diaphragm or slide.
9. Faulty MAP, TPS, ATS, O2, sensors or wiring/connector
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
2007 Idle Issues
How to Adjust the idle on 04 06 cbr600RR
2007 2009 Honda CBR600RR Service Manual Moto Data Project
http://www.partsfish.com/page/oem-parts-for-honda
Honda CBR600RR 2007 Owner Manual

Jun 01, 2017 | 2007 Honda CBR 600 RR

1 Answer

Honda shadow vt1100c 1986 idile to low after running awhile


There's an idle adjustment screw. The bike runs faster when cold because the fuel\air adjustment is richer on a cold engine. When the bike warms up, the fuel becomes more lean in mixture because the heat causes the fuel to expand, i.e., less molecules of fuel to the firing sequence of the piston. When the bike is warmed up, after say ten minutes, the heat causes a leaner mixture, so adjust the idle on a hot engine (about 1000 rpm more or less). The bike will idle faster when cold, then drop rpm's as the engine warms up. Good luck

Sep 17, 2013 | Motorcycles

1 Answer

Can any one tell me what the settings are for the pilot scew on my benelli 491 rr carburettor


Start the bike and let it idle in neutral. Keep it idling for at least 8-10 minutes so the bike is good and warmed up. Once the bike is warmed up adjust the carburetor screw in or out little bits at a time until the bike idles at approx. 1800 RPM! Easy fix. Good luck!

Sep 16, 2013 | Motorcycles

1 Answer

When to adjust idle


If you can keep the bike running long enough to get it warm with and with no choke then that is when you should adjust the mixture,
First though start by adjusting it cold so the screw is set at about 1.5-2 turns out then run till warm set idle at around 1500 revs and adjust until it just starts to lift the revs then back off a quarter turn

May 02, 2013 | Yamaha Motorcycles

1 Answer

Tickover to fast when warm, 2000dyna low, where is adjuster.


Idle adjustment on back of carb near front of bike. As stated in another post. The bike NEEDS to idle at 1000 - 1200 rpm for proper oil flow.Anything less and you could starve the bike of proper oil circulation and damage the motor.

Jan 19, 2013 | Harley Davidson FXDL Dyna Low Rider...

1 Answer

When is a valve adjustment due on a 06 R1


rate my post for perfect solution
Instructions
    • 1 Open the choke by pulling the choke lever on the left handlebar control toward you. Set the bike on its kickstand, put it in "Neutral" and start it up. Allow the Road Star to warm up for about 10 minutes before continuing with the adjustment procedure.
    • 2 Locate the idle adjustment screw on left side of the bike just below the rider's seat. Twist the adjuster screw clockwise one full turn. This will ensure the bike stays alive so you can adjust it to the proper setting.
    • 3 Close the choke lever and listen to the engine carefully. Twist the idle adjustment screw slowly counterclockwise. You should hear the engine speed start to slow.
    • 4 Twist the idle screw counterclockwise until you hear the engine start to sputter and die. When this happens, stop and turn the screw one half turn clockwise. Your bike should now be idling at the correct speed.



1_16_2013_4_26_18_am.jpg

Jan 15, 2013 | Motorcycles

1 Answer

Wont idle


Make sure your spark plug is not fouled and the gap is correct, also air filter is properly cleaned. If it still wont idle, locate the idle adjustment on the carb. There are 2 screw type adjustments there, one is the idle/air screw and the other is idle adjustment which is the one you want. Start the bike and warm.it up, slowly turn the idle adj. Inward like tightening a bolt, periodically give the engine a slight rev and let it idle.down. Do this until you reach the desired rpm you want to idle at and your finished

Mar 24, 2012 | 2002 Yamaha TT-R 125

1 Answer

2001 vmax My throttle has alot of play in it, which I can adjust, but when I get the bike warm, it won't stay at an idle. The idle will creep up to about 2500 rpm. Almost like the throttle cable...


Try lubing your cables and throttle mechanism first. Do your adjustment when the bike is warm. It sounds like you're making one of the cables too tight.

Jun 27, 2011 | 2001 Yamaha V-Max

2 Answers

What is idle RPM of Pulsar 150 DTSi 2007 model. Mine shows 1500 and after warm-up show 2000


Most bikes are in the 1000rpm range unles they are 2 stroke (some small Aprillas etc.), dont always go by the tacho meter, you can usually hear if the bike is idling too high or too low and idle adjustment is usually fairly easy once you find the adjuster screw.

Feb 18, 2011 | 2007 Bajaj Pulsar 150

1 Answer

1998 roadking idles to fast after it warms up.


Is it fuel injected or carbureted? If the bike is fuel injected it will idle fast until the engine warms up...if it continues to idle fast after about 10-15 seconds it could have a faulty sensor.

If carbureted, after you push the choke in does it still idle fast? If so, there is an idle adjust screw on the top of the carburetor just behind the air cleaner.

Do you have a tach on the bike? If you do, then the normal warmed-up idle should be 1000rpm.

Sep 09, 2009 | 2001 Harley Davidson FLHR - FLHRCI Road...

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

819 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

bazzz7071
bazzz7071

Level 2 Expert

342 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...