Question about 2002 Honda XR 200

1 Answer

Fuel leaks from hose that comes from carbuerator when fuel is turned on, why

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 957 Answers

It has a hole in it somewhere. they get brittle with a little age and can crack and start to leak. make sure there are clams on the hose as well

Posted on May 09, 2014


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Fuel leak carbuerator

Is it a visible leak? Most quadra jet carbs leak internally. There's a rubber plug that comes in the overhaul kit that solves the problem

Jan 14, 2014 | Vacuums

1 Answer

How do you know if the float is stuck on carbuerator

Fuel will come out of overflow pipe and leak onto floor

Sep 30, 2013 | Motorcycles

1 Answer

Fuel leak

This sounds like a stuck float needle in the carbuerator.You might have some luck with a rubber mallet-turn on the fuel,then thump the bowl a few times.If this doesn't work,you may have to remove the bowl to see if the float has sprung a leak and filled up with fuel.(the float won't float if it is filled with liquid!)

Oct 26, 2012 | Electrical Supplies

1 Answer

Smell of gas while driving is very noticable inside of the car.

Sounds like one of the rubber hoses in the engine bay may be leaking. Could also be a leak somewhere around the carbuerator or fuel injectors.

Turn on the car and look/smell your engine bay. Look for anything that may indicate a leak or try and follow your nose. Leave running for awhle, and if you still can not find it, turn car off, and check all lines again.

May 29, 2010 | 2003 Saturn L-Series

1 Answer

Small hole on carbuerator opposite where gas hose connects leaks

perhaps there was a hose on/in it at one time cause it sounds like an over flow/vent.

Apr 18, 2010 | Garden

1 Answer

Priming pump bulb pumps gas/oil mixture out on the ground. Where does the lower end of the tubing attach to? Do not have a manual There is a cap on top of the fuel container with one line attached and an...

Many times the return hose is routed thru the hole you described with no extra fittings or grommets. I suspect the hose cracked at that point, some of it fell inside the tank, and the rest is what you can see on the outside, so you may need to replace the hose with a longer one. The diameter needs to be larger than the hole as the 'press-in' fit seals the tank from leaking.

Nov 09, 2009 | Husqvarna 155bt Gas Backpack Leaf Blower

1 Answer

I am replacing the fuel tank assy and purge bulb (i.e. primer) on my Sears Craftsman model 358.798940. The original plastic tubing was old and brittle and broke apart while disassembling, so I could not...

The order of fuel travel should be:
Fuel filter to fuel hose to Carb's Fuel Supply nipple. (On the main body of the carb)
Primer Plate Nipple on carb to fuel hose to Suction Nipple on Primer Bulb. (It must pull fuel thru the carb, not push)
Pressure Nipple on Primer Bulb to fuel hose to Fuel Tank Return hose.

When correctly installed, the fuel will be PRESSED into the fuel tank via the return hose when primer is pressed in . . . and SUCTIONED out of the tank and into the Carburetor when primer in released.

Hope this helps,

Oct 16, 2009 | Garden

1 Answer

Not getting fuel to digital carbuerator

Replace the fuel pump.If you live up North then in some cases where the air is real cold and nippy the fuel lines will actually leak flaky gas into the pump without it on to pump it to the carb, therefore corrosion and rust seize the Fuel Pump until it doesn't turn on when the key is in the 2nd position.

Apr 03, 2009 | 1985 Cadillac Eldorado

1 Answer

I have fuel dripping in the front near carbuerator

Most often the leak is at the fuel line connection at the carb. Replace this gasket and check the fuel filter at the same time. Do not use thread sealant! Do not drive it with this leak!! Frankster016

Nov 26, 2008 | 1984 Oldsmobile Delta 88

1 Answer

1988 gmc v 3500 350m carbuerator

its possible that there was something in the tank or line that plugged your new filter. try changing it again

Oct 10, 2008 | 1988 GMC K3500

Not finding what you are looking for?
2002 Honda XR 200 Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4888 Answers


Level 3 Expert

79847 Answers


Level 2 Expert

342 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides