Question about Motorcycles

1 Answer

Yamaha ZR what the caus of losing 3rd gear in the transmission.how to fix it?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 279 Answers

The gear maybe held in place by a KEYWAY or Pin. If it broke then the gear will just spin on the shaft and not propel the bike.

Posted on May 06, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to fix ram 1500 2005 transmission that sometimes gets stuck in 3rd gear. from start to finish truck will stay in 3rd gear.


When did you last replace trans filter and fluid? Dirt may be causing shift valve to stick.

Dec 28, 2014 | 2005 Dodge Ram 1500

1 Answer

Hello my yamaha vega ZR is knocking when i shif in the 3rd gear.how to fix it?


if only in 3rd then sounds like you broke a tooth onthat gear ! is it a ticking sound ?

May 06, 2014 | Motorcycles

1 Answer

Yamaha vega zr


what is wrong with 3 rd gear symptoms are what ,jump out of 3 rd
will not engage , noisy. Can be shift fork damage or shift drum damage or worn dogs on lnterlacing gear. what ever the case may be engine have to be dismantaled.

May 06, 2014 | Motorcycles

1 Answer

TRANSMISSION


Fuse # 20 or 21 gets power through ignition. This fuse controls PRNDL indicator, speedometer, tach, & will cause transmission to not shift gears correctly. Ours took off in 3rd gear when put in Overdrive & only ran in 3rd gear. If we tried to manually shift thru gears (auto trans), it had 1st, 3rd, reverse. No 2nd or over drive. Replaced ignition. Fixed problem. Root problem was Electric motor that engaged 4 wheel low side was bad. Every time we used 4 Low side it threw power surge through ignition & blew ignition out. Good Luck.

Feb 06, 2014 | 1997 Chevrolet K1500

2 Answers

Today while I was riding my 2001 Yamaha YZF-600R i noticed that in first gear ( could be others as well) when i hit around 7-8k RPM's it kinda skips. I don't really know how to describe it,but its...


Under the seat in front of the battery I'd a dmsll box with I think 6 wires, it's a rectifier box and when they heat up a wire melts, I just fixed another Yamaha that did the same thing u are describing and that's what the problem was

Aug 10, 2011 | 2001 Yamaha YZF 600 R thunder cat

1 Answer

Only runs in 1st and 2nd gear and reverse.


This is a fault mode in which the transmission either loses electrical power or the PCM deactivates all of the electronics. The transmission will default to max line pressure. The driver will have Reverse and 3rd, with manual 2nd available by putting the gearshift in 2 or 1 (doesn't matter). 1st, 4th, and TCC lockup will not be available. It will not hurt the car to drive it like this for short periods, but use manual 2nd to get the car moving, and be aware that the trans will generate more heat than normal while operating in limp-home mode due to increased torque converter slippage during 2nd gear starts and no lockup in 3rd gear.

Trans shifts into gear harshly, car feels sluggish off the line
, No 1st, 4th or TCC lockup available, Manual 2nd, 3rd and Reverse are only available gears, CEL is on: Transmission is either in limp-home mode or has lost electrical power. If there are lots of error codes in the PCM, check the under hood fuse that powers the transmission, and if it pops again, look for a short in that circuit like an O2 sensor harness touching exhaust. Otherwise, check PCM codes for a particular fault in the transmission causing the PCM to put it in limp-home mode.

No 1st or 4th available; trans shifts 2nd to 3rd by itself in D or OD and locks the converter : ShiftA solenoid failed. Easy fix in the pan. Or a wiring problem from PCM to trans.. or PCM.

Car goes into gear but feels very sluggish like the brakes are dragging, but it will roll easily (starts out in 4th gear), you manually shift to 2 to get it moving, once it's moving you put it back in OD and the car shifts 3rd to 4th on its own and locks the converter at the appropriate time: ShiftB solenoid failed: Easy fix in the pan. Or a wiring problem from PCM to trans.. or PCM.

Dec 14, 2009 | 2006 Hummer H3

1 Answer

92 chevy s10 4x4 4.3L manual transmission no 3rd gear


Hi:

Your transmission has 3 shift rails...
1st - 2nd
3rd -4th
5th- Reverse

If your 3rd gear doesn't work , you have an internal transmission problem, such as a syncronizer, or similar fail... There is not much you can fix, without removeing the transmission.

Nov 30, 2009 | 1992 Chevrolet S-10

1 Answer

5TH GEAR KEEPS ON BREAKING , 3RD PINION GEAR


What year is this? How many times has this happened?

In 1998-2000 Yamaha apparently had heat treating issues with their transmission parts. They have fixed the problem and replaced their spare parts inventories, so if the gear you most recently broke was more than maybe 5 years old, it might have been a defective part.

Othrwise - make sure you inspect the mating gear and the shift fork. If either is damaged, it could take out a gear quickly.

Nov 11, 2009 | Yamaha WR 450 F Motorcycles

1 Answer

1995 Sabb 900 clutch wont engege in reverse


Bad syncro for third gear. Sorry, but you aren't fixing this one yourself, unless you replace the transmission yourself.

Sep 14, 2009 | 1995 Saab 900

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75117 Answers

kakima

Level 3 Expert

102366 Answers

Are you a Motorcycle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...