Harness thru door jam looks good
SOURCE: 2000 pontiac bonneville SLE
Its a signal wire splice that is under your driver seat carpet.( 4 brown wires)
SOURCE: 1996 pontiac grand am drivers side window off track how do fix and is it hard not power windows
remove the door panel, from the inside you should have access to the window. lift the window up unto the raling. Check to see if the railing is not bent or why the window came off the railing.
SOURCE: 04 pontiac montana sliding doors no longer work
the sliding doors on montana assuming there power have a electrical harness on the bottom track that break and jam the doors but unlikly both have this problem do the doors lock @ unlock if not check switch at drivers door
SOURCE: 2000 pontiac montana power window|locks doesnt
I had a 99 with the same problem, and suggest you check under the passenger side front carpet. Remove the flat door kick plate, lift up the carpet on the front passenger side floor and you will see a large wiring harness running along the floor, wrapped in black tape. Water and salt gets into this harness and will rot out several wire splices that you will see. Look for wires that run from 2 wires down into one (under black tape.) These are spliced together, and rot out. There was several large gauge wires/splices(windows up and down) and I think 2 very thin wires/splices (lock/unlock) . Even if the wires look connected, give them a good tug, they will come apart and be green with corrosion. This is a very common problem and worth the effort to check out. Repairing these splices fixed both the power windows and locks at the same time. Good luck
SOURCE: 2001 Pontiac Aztek power windows do not work when
Inside the door is a pair of rods, connecting a wire in a figure 8 pattern. There are four tiny little plastic tabs that surprisingly, break off fairly easily. I had mine break off when A GPS suction cup prevented the window from going down in auto mode and the window dropped into the door. Without those four plastic tabs, there is no way to connect anything and you have to get an entire new assembly for your window. You might be able to fabricate yourself some new ones, but if you can do that, then you're not on this site to begin with. The dealership wants an arm and a leg, but the unit is fairly self explanatory as long as you're comfortable taking your door apart and working on it yourself.
729 views
Usually answered in minutes!
×