How to tighten passenger peg on harley - 2001 Harley Davidson XL 1200 C Sportster Custom

The passenger floorboards install the same way as the existing rear pegs.

on the end of the peg you will see a head for the bolt it requires an Allen wrench to tighten.

You should be able to take just the footpeg off the support from the frame. It may not be a bolt but a pin with a circular clip on the other side.

Good Luck
steve

If you are talking about the front foot peg. Take the screw that holds the peg to the mount out. Inside the mount you will see an allen that tightens the mount to the shaft you will need to tighten this allen. Then put the peg back on and your done.

I’m happy to help further over the phone at https://www.6ya.com/expert/al_e83b1941f9c0f302

Yes, this is where the passenger foot peg on the left side of the bike goes. There is an arm that clamps onto the round stub on the inspection cover and is afjustable to almost any angle. The right side foot peg support bolts to the end of the transmission and also has an adfustable arm that clamps onto a stub on it. Then the pegs go on the end of the arms. Go to this site and take a look . http://www.bikebandit.com/1975-harley-davidson-flh-1200/o/m770#sch171752 I'm pretty sure they didn't move the peg brackets to the seat tubes of the frame until 1977. If your bike has two holes in a welded-on tab on the rear of the down tubes behind the primary and the transmission, you can use the later model peg brackets. But, if your bike has no holes in the frame or the swingarm for passenger peg brackets, this is the only style you can use and stay original. You could fabricate and weld on tabs to later model peg brackets or use clamp on brackets and pegs.


Good Luck
Steve