Question about 2003 Honda VT 1100 C2 Shadow Sabre

1 Answer

Change oil pump 2003 expediton

I think I have over filled the oil and blown an oil pump seal. What do I need to do?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 26 Answers

If there is excess oil outside the motor then it is usually coming from breather pipe which goes to airbox. Check if oil is in the airbox. If so, clean out airbox and drain excess oil out of engine. If the bike has an oil light make sure it goes out on start up. If not, better if you have oil pressure tested.

Posted on Apr 24, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Kohler engine oil leak


Could have blown a seal however before checking for that I would check the drain plug and filter seating if you changed the filter. Make sure the drain plug is not cross threaded. You can run a little low but should never over fill. Hope this will help. Most of the time if over filled you will get some smoke as well.

Apr 25, 2014 | Garden

1 Answer

Oil pump seals or replacement


I'd try to drain some of the oil out
get some carby cleaner spray the area and dry of.
restart bike and see if it stops the leak.?
Good luck

Apr 23, 2014 | 2003 Honda VT 1100 C2 Shadow Sabre

1 Answer

Hard to fill gas tank, stalls, and loss of power


it could still be a head gasket it could be losing fluid on the inside in the water jacket around the motorwhen you change your oil did it look milkylike coffee with too much milk in italso look at your antifreeze and see if its got a oil in it

Jan 31, 2014 | 2003 Buick Century

1 Answer

Oil flter leak, 2005 expediton


if you just change the oil it might be that the old o-ring still on hence the leak.put a new filter and make sure that the old o-ring is off.

Dec 21, 2012 | 2003 Ford Expedition

1 Answer

2003 Honda CR 250 R oil leaking front of the exhaust pipe


Hi, Anonymous and the usual suspects are:
1. Engine oil over filled.
2. Piston rings worn past service specs.
3. Broken piston rings.
4. Piston pin retaining clip failure.
5. Cracked piston.
6. Broken piston ring lands.
7. Hole in the piston.
8. Valve/guide clearance worn past service specs.
9. Worn out valve seals.
10. Crushed or loose valve seal.
11. Gouges in cylinder walls.
12. Cracked cylinder or head.
13. Blown head gasket.
14. Crankcase breather blocked or hose pinched.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
2003 cr250r exhaust leak at exhaust port
Need help trying to reduce excess spoge 2002 CR250R
CR250 2002 2003 pdf
http://www.partsfish.com/page/oem-parts-for-honda
Honda CR250R Owner Manual Competition Handbook

May 20, 2010 | 2003 Honda CR 250 R

1 Answer

How do you change water pump seal 98 rm 125 !!???


It should be just that, a leaking seal, gasket. The water pump is external on that bike and doesn't go anywhere but the cooling dept.It doesn't get mixed with oil or anything. Take off the pump itself and replace the gasket. I think that should do it, unless it is the pump itself leaking.
Suzuki RM125 RM 125 Water Pump Housing,,,,
That is an ebay ad. Just in case. Hope this helps.

May 03, 2010 | 2003 Suzuki RM 125

1 Answer

How to change oil on a 2003 Kawasaki Vulcan 750 motorcycle? Where is the oil pan plug?


Firstly run your engine till you reach its normal running temp .The engine drain plug will be found under neath the engine normally at the lowest part .Warm oil drains out of the engine much more quickly that cold oil ..when all the oil stops dripping then remove the oil filter ,make sure that the sealing ring is removed ,take care the oil in the filter will be very hot .replace with your new filter make sure you do not cross thread the oil filter unit and any seals have been fitted . Refit your drain plug and fill up to the required level . start engine ,your oil level will drop because the oil filter will fill up and the new oil will be pumped around the engine. make sure that the engine level is topped up when all the oil has reached all the parts of the engine .Do not over fill the engine as this will cause unwanted pressure .and oil leaks .Remember to replace the oil filler cap and that its tight .

Mar 14, 2010 | 2003 kawasaki VN 750 Vulcan

2 Answers

I think water go in to the engine oil of my bike, what can cause that? crf450, 2004


Water pump oil seal is not a possible cause. Even if the water and oil seal were so worn out that the coolant passed through both seals the weep hole in the crankcase cover would have to be completely stopped up and sealed. In that case it would leak into the transmission oil not the engine oil. The coolant leak would likely be in the cylinder/head area.

Nov 05, 2009 | 2004 Honda CRF 450 R

3 Answers

GM truck vortec Eng oil pressure low with high engine noise


CHECK THE OIL PUMP SUMP TUBE O-RING. THEY COLLAPSE CAUSING THE OIL PUMP TO PULL AIR INSTEAD OF OIL. TO VERIFY OVER FILL ENGINE OIL AND CHECK ENGINE OIL PRESSURE. THIS IS A COMMON PROBLEM ON ALL NEWER GM V-8 ENGINES : 4.8 5.3 5.7 6.0

Feb 21, 2009 | 1998 GMC Sierra

1 Answer

460 engine, automatic trans 39 700 original hard kms engine oil level has risen 2 gallons in 50 miles


you did not say what the year model of the engine is. but if the fuel pump is located on the block, the the fuel pump is bad and pumping fuel into the crank case...

Jun 09, 2008 | 1995 Ford F350

Not finding what you are looking for?
2003 Honda VT 1100 C2 Shadow Sabre Logo

110 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers

yadayada
yadayada

Level 3 Expert

76109 Answers

Mike

Level 3 Expert

4339 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...