Question about 2010 Harley Davidson FLHX Street Glide

1 Answer

My voltage on my 2010 street glide will not go above 13 volts and I can't figure out why?

Posted by Anonymous on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Harley Davidson Master
  • 3,506 Answers

Fully charged battery and normally operating charging system???

Posted on Oct 18, 2014


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2007 street glide misses and wonts to stall out when taking off??

my roadking just did the same thing, check the gasket between carb and intake

Posted on Aug 10, 2009

  • 109 Answers

SOURCE: how much air should I put in air shocks 2010

Don't mean to sound nasty but I thought new hogs have on board compressor to keep shocks,front and rear filled up?Your shocks need air maybe compressor aint working?Just a guess,sorry.

Posted on Mar 20, 2010

  • 4565 Answers

SOURCE: All the back lights will

If it's brand new, I'd take it back to the dealer and let them fix it under warranty. It sounds like the rear fender subharness is not connected or shorted somehow. A subharness is a wiring harness loom that connects to the main harness and feeds and "outlying" area of the bike like the fenders or handlebars.

Good Luck

Posted on Oct 24, 2010

  • 4565 Answers

SOURCE: my 2010 street glide headlight

Check your tail light. If it's out as well, check the fuse panel for a blown fuse in the "lights" position.

Good Luck

Posted on Feb 22, 2011

  • 496 Answers

SOURCE: have a 2010 street glide with harmon kardon sterio

do you mind me asking why you want a head phones on your bike? well anyways this is what you need to do, go down to radio shack and get a hook up and if your able to find a switch to turn off the main speakers so just your head phones are on. remove the head unit and locate your speaker wires now solder in the jac. best of luck if you need more help please contact me

Posted on May 23, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Air shocks 2010 street glide Harley davidson

6-18 pounds of air pressure and you have to use a low pressure air pump to air them up

Feb 12, 2015 | 2010 Harley Davidson FLHX Street Glide

1 Answer

2010 Harley Trike 12 volt plug has no power. Acc light on console is on. Where do i look next

Check the acc fusing but probably it is a wire loose or off of the acc plug assembly.

Sep 12, 2014 | 2010 Harley Davidson Trike Street Glide

1 Answer

2010 street glide rocker box torque specs and underneath rocker box torque specs

Hi Anonymous, you are going to need tools for this procedure, the first and very best tool you will ever buy should be a factory service manual. For just $5.50 you can download one at the website below:
Good luck

Apr 07, 2014 | 2010 Harley Davidson FLHX Street Glide

1 Answer

2010 flhx battery fully charged but starter drags bad then clicks. Jumped power from car, still does the same thing.

Hi Anonymous, perform the following tests:
1. Fill acid type batteries to proper levels.
2. Charge battery overnight at 1-2 amps you need 12 volts or better after charging.
3. Make sure all connections are clean and tight especially the negative cable at both ends.
4. Hook up volt meter to battery and start engine, if meter falls below 9.5 v replace battery.
5. With engine running at 3600 RPM battery should read 14.3-14.7 volts if not continue tests.
6. Unplug voltage regulator from alternator at crankcase by front of primary cover.
7. To test voltage regulator go to:
8. With ohm meter, one lead grounded, touch alternator pin meter should read infinity, if not replace stator.
9. With ohm meter, both leads touching alternator pins meter should read 0.1 to 0.2 ohms on 1989 and later models. 0.2 to 0.4 ohms 1988 and earlier models, if not replace stator.
10. With volt meter set on AC scale, both leads touching alternator pins meter should read
16 to 20 volts AC for every 1000 RPM'S 1989 and later and 19 to 26 volts AC for every 1000 RPMS. If not replace rotor. Good luck

Jan 01, 2014 | 2010 Harley Davidson FLHX Street Glide

1 Answer

2010 flhx street glide bendix gear wont engage flywheel

Hi Anonymous, your battrry is severely discharged or your starter relay and or starter drive is faulty. Good luck

Oct 27, 2013 | 2010 Harley Davidson FLHX Street Glide

1 Answer

How do I remove the corrosion in the fuse box of a 2010 Street Glide?

Hi Larry, pick up a can of contact cleaner spray at radio shack or auto parts store. Have nice day.

Mar 24, 2013 | 2010 Harley Davidson FLHXSE CVO Street...

1 Answer

How to check the primary oil on 2010 street glide trike

Hi Anonymous, please be aware that this question has already been asked and answered. Thank you.

Aug 08, 2012 | 2010 Harley Davidson FLHXX Street Glide...

Not finding what you are looking for?
2010 Harley Davidson FLHX Street Glide Logo

Related Topics:

93 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4818 Answers


Level 3 Expert

4348 Answers


Level 3 Expert

78919 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides