Question about 2000 Harley Davidson FXDWG Dyna Wide Glide

1 Answer

Engine quits runing after approx 15 minutes

I have a 99 Dyna wide glide that will shut down after running for about 5-8 minute. after ten minute or so it stars back up again and later dies.I took it down the road and after about ten minutes it dies.New petcock, new gas cap, rebuild carb. i am lost.

Posted by Anonymous on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Harley Davidson Master
  • 3,506 Answers

Check temperature sensor

Posted on Oct 18, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

v2iper
  • 150 Answers

SOURCE: will a gas tank off a 5 harley dyna wide glide

It sure will!! You answered your own question. guess i get no points for this one.

Posted on Jun 15, 2009

stephensaon_
  • 284 Answers

SOURCE: 02 harley fxdwg brake light stays on

Make sure your rear brake pedal has freeplay in it. when you slowly push the lever down by hand you should be able to feel some freeplay. if not the the reason it keeps staying on is because the vibration of the motor is actually pumping up your brake ( light too ) and not releasing it until it bleeds off the pressure.

Posted on Jun 27, 2009

  • 50 Answers

SOURCE: 2002 Dyna wide glide. Will not IDLE

not running for a year! You have a varnish buildup in the low end circuit of the carb. You will need to remove the carb and do a full teardown of the carb to properly rectify this problem. SOMETIMES we are able to free up the passages by putting SEA FOAM cleaner in the tank , fill her up with fresh fuel and ride through the tank and it will clear up. SEA FOAM can be purchased at an auto parts store and is sometimes very effective. 1/4 cup to full tank fuel.

Posted on Jul 14, 2009

wd4ity
  • 4565 Answers

SOURCE: I have a 99 road

It sounds like a fuel flow restriction somewhere. Sure, it'll start every time and idle for a while but take it down the road a bit. If it quits, I'd suspect that for some reason it's not getting fuel to the engine from the tank. Loosen the fuel cap, the cap vent may be bad. The vented cap the right side tank cap. If it's fuel injected, it could be the fuel pump or something. It sounds like a fuel problem to me.

Good Luck
Steve

Posted on Jan 17, 2011

  • 54 Answers

SOURCE: my dyna super glide shuts

Sounds like an electrical problem. Maybe the ignition module is overheating and when it cools it works again. That depends on what ignition you have also. Possible that you have a chassis electrical overload and a circuit breaker trips. If you are in a place that is quiet when it stalls listen very carefully and you might hear a click. If you hear a click try and start the motor, if it runs then chances are it is a breaker. You will need to find which one and then find why you have an overload of amps, usually a shorted wire or bad ignition switch however electrical problems are tough to cure.
I could list a lot of things to do but it would depend on your skills. If you don't normally work on your bike but have a mechanic then you should take it to him. Otherwise get a schematic (In the back of the factory manual) and start tracing and testing.
An ignition is usually tested by replacing it.

Posted on Jul 14, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What could cause my harley to stop?i need some technical advice can anybody help me?


Have you changed your gas filter, sometimes after sitting you will have gas flow but it will clog while driving

Jul 19, 2014 | 2000 Harley Davidson FXDWG Dyna Wide Glide

2 Answers

Why would my 1998dyna wide glide harley just shut down after riding a while,i turn it off for 15 minutes, fire it back up and it just dies out?


I have a Harley, They say that HD stands for Hundred Dollars, they are right. Change the coil and plugs, It uses a Wasted Spark system and the plugs don't last plus the coil won't produce high voltage when hot.
Mine is an XLCH1000

Jul 19, 2014 | 2000 Harley Davidson FXDWG Dyna Wide Glide

1 Answer

Why would my harley davidson 1998 dyna wide glide stop running after a short trip after being shut off for 20 minutes and restarted?


when it shuts down does it sputter first or is the shut down immediate without warning. sputtering is usually a condition of lack of fuel.any intake leak at the manifold especially at the head will cause "sneezing" out of the carb. Restart can be difficult and intermittent. A weak ignition module especially the adjustable kind can be unpredictable. a lot of the after markets are adjustable.A 1998 scooter tells me you have an Evo and being it's 16yrs old the likelihood of having a stock module is nil. check the plug where the module plugs to the ignition harness as well. Often times,because of it's age,these pins turn green or they either bend or they pull out just enough to break contact. I've also experience cracking of the wire insulation causing temporary short. shutting down the engine and difficult restarts.As with all jobs,check the simplest and obvious and don't start buying parts until you have checked all connections especially at the module where it meets the ignition harness.

Jul 19, 2014 | 2000 Harley Davidson FXDWG Dyna Wide Glide

1 Answer

I have a 05 wide glide with fuil injection. it starts good ride about 2 mile and dyes out


determine if any dtcs are set and if so what ones. Check engine temperature sensor. cHECK RUNNING FUEL PRESSURE ALSO.

May 11, 2014 | 2005 Harley Davidson FXDWGI Dyna Wide...

1 Answer

04 wide glide shuts off and wont start for a few minutes


Does it shut down hot? if carbureted, check adjustment of carb & plugs

Apr 24, 2014 | 2004 Harley Davidson FXDWG - FXDWGI Dyna...

1 Answer

Were is the oil dip stick on a 2004 dyna wide glide


Hi Anonymous, the engine oil dipstick on later models unscrews, on earlier models it just pulls out with moderate force, on Softail and Sportster models the dipstick is located on the right hand front side of the oil tank and the Harley Bible says, engine should be at normal operating tempurature, let idle on jiffy stand for two minutes. Shut off engine and hold bike straight up and dipstick all the way in, correct engine oil level will be at the top full mark. Do not overfill oil tank as this will cause engine breathing issues. On Dyna and Touring models The engine oil dipsticks are located on the right front top corner of the transmission and the engine oil pan is underneath the transmission. The engine oil level is checked in the same manner as Softails and Sportsters. If you are having oil carryover or breathing issues (dipstick launch) try running oil level half way between the add and full marks, running the engine at this oil level will not harm normal operation. Good luck and have nice day.

Nov 16, 2012 | 2004 Harley Davidson FXDWG - FXDWGI Dyna...

1 Answer

2008 dyna wide glide won't hold idel speed after 15 minutes of running. Changed spark plugs, good for 2 days then same problem back. Bad gasoline?


If the bike is equipped with a carburetor, try not using the enricher (choke) so long. The enricher circuit in the carburetor is extremely rich. I see people let their bikes run for almost ten minutes with the enricher on and they can't figure out why they are fouling plugs. Only run the enricher until you can get the engine to run with the throttle. I use the throttle lock located on the underside of the throttle grip. Just idle the engine up that about 1500-1700 RPM, turn the enricher off, and tighten the little knob just enough to hold the throttle and keep the engine running until it warms up. Prevents you from fouling plugs. If this is not the case or you have fuel injection on your bike, you may need to take it to a qualified mechanic. I don't advise tearing into your carb or fuel injection unless you know what you're doing.

Good Luck
Steve

Jul 20, 2011 | Harley Davidson FXDWG Dyna Wide Glide...

1 Answer

02 harley fxdwg brake light stays on


Make sure your rear brake pedal has freeplay in it. when you slowly push the lever down by hand you should be able to feel some freeplay. if not the the reason it keeps staying on is because the vibration of the motor is actually pumping up your brake ( light too ) and not releasing it until it bleeds off the pressure.

Jun 23, 2009 | 2002 Harley Davidson FXDWG Dyna Wide Glide

Not finding what you are looking for?
2000 Harley Davidson FXDWG Dyna Wide Glide Logo

145 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Gills Lango

Level 2 Expert

195 Answers

Mike

Level 3 Expert

4336 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...