Question about 2001 Suzuki VS 1400 Intruder

1 Answer

Suzuki Intruder flasher relay

I think my flasher relay (control unit) is bad, its making a clicking noise. would thins cause my bike not to start?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 168 Answers

Flasher relay should not stop it from starting. check
there is safety switches on some brake and clutch levers that could be bad or sticking.check kill switch to see if it work proper

Posted on Apr 22, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
97F350diesel
  • 1326 Answers

SOURCE: where is the battery located on a 1996 suzuki

Normally the battery for all bikes is under the front seat. If not obvious from looking near the engine.

Posted on Aug 06, 2009

  • 4 Answers

SOURCE: suzuki 1400 intruder wont start.. just clicking noise.

It's most likely the connection to the battery. The screws dont tighten in well and you get the famous clicking....I replaced the stock philips screws with a hex bolt and after two years of trying to solve the problen have been starting everytime for the past year no problems. Another gie away is the intermitant starting problem gets worse when wet.

Posted on Sep 16, 2009

slave2aslave
  • 302 Answers

SOURCE: Have 96 suzuki intruder 800. Has been sitting for

I would try checking the rubber between the carb and motor for air leaks,and/or spray carb cleaner through while running with the air box open.
Hope this helps.

Posted on Oct 06, 2009

  • 330 Answers

SOURCE: Backfiring 2004 Suzuki Intruder

an exhaust leak can, check the exhaust gasket and bolts.Carbs being loose unlevel or dirty can as well. the carbs may need too be set for proper timing with each other.

Posted on Apr 08, 2010

Testimonial: "Thanks! I'll do exactly that."

  • 36 Answers

SOURCE: my bike makes starting noise but it won't turn

if you hear a spinning noise then the starter needs replaced, aclicking noise means u need a battery.

Posted on Aug 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does the fuel pump click when i push the starter button on my 1400 intruder


Hi, Ralph for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Suzuki, despair not, for a mere zero $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Intruders Alert
Bike won start ticking noise heard motorcycles
Suzuki VS1400 Owner Manual
OEM parts for Suzuki
Suzuki Intruder VS1400 Service Manual

Feb 21, 2017 | 1995 Suzuki VS 1400 Intruder

1 Answer

Where's the flasher on a 1993 Suzuki Intruder VS 1400?


replace the indicater relay ! trace back the same colour wires !

Apr 04, 2014 | 1993 Suzuki VS 1400 Intruder

1 Answer

1993 800 suzuki intruder starter button wont work no clicking noise starter relay is new any suggestions


Check battery, check connections corrosion causes bad connection. Double check starter button switch, it may be bad. You may be able to verify this switch by "jumper" bypass of the switch..

Nov 30, 2013 | 1993 Suzuki VS 800 Intruder

1 Answer

My bike makes starting noise but it won't turn


if you hear a spinning noise then the starter needs replaced, aclicking noise means u need a battery.

Jul 27, 2010 | 1998 Suzuki VS 800 Intruder

1 Answer

Can you help me with startproblem suzuki vs700. Sometimes it start with now problems, sometimes not. I hear som ticking noise. I have changes start relay


On the right side of the bike right above the right front corner of the front cylinder there is a small braided cable. This cable needs to be taught but not too much. This cable opens a port to relieve the pressure on the front cylinder to make it easier to start for that little battery. It activates when you push the starter button. If it has stretched then when you try to start it, sometimes it will start but sometimes it will crank really hard and click, just hot and cant turn over fast enough without this working.
Too bad you had to waste the other money on parts, / Simple fix with a wrench only, no parts needed. Now you have the beginnings of a parts shop.

Cy Brush / Florida
321-225-0409

Jun 15, 2010 | 2000 Suzuki VL 125 Intruder LC

1 Answer

How do I test for a bad solenoid on a 1994 Suzuki Intruder vs800


I'm assuming when you press the start button will not turn over. Look for the solonoid ( Relay) and you will see two heavy guage wire one goes to starter and the other to the battery terminal positive. Where the two wires meet at the relay jump with a heavy wire 10 guage it will by pass the relay if it starts your relay is bad.

Make sure your battey is hot bike in nuetral and clutch lever squeezed

Mar 08, 2010 | 1994 Suzuki VS 800 Intruder

1 Answer

93 Suzuki 800 Intruder just quit starting


If it was the relay, you probably wouldn't hear it clicking. you may be able to hold the starter button, and tap on the starter lightly to see if it works.

Aug 11, 2009 | 1999 Suzuki VS 800 Intruder

3 Answers

Suzuki 1400 intruder wont start.. just clicking noise.


It's most likely the connection to the battery. The screws dont tighten in well and you get the famous clicking....I replaced the stock philips screws with a hex bolt and after two years of trying to solve the problen have been starting everytime for the past year no problems. Another gie away is the intermitant starting problem gets worse when wet.

Aug 11, 2009 | 1991 Suzuki VS 1400 Intruder

3 Answers

Starts fine. sounds fine but dies upon putting it in gear


Your kickstand switch is either broken or out of position. The bike kills the engine as a safety feature if it thinks the sidestand is down and the bike is put in gear while the engine is running.

Apr 12, 2009 | 1993 Suzuki VS 800 Intruder

Not finding what you are looking for?
2001 Suzuki VS 1400 Intruder Logo

192 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers

Richard
Richard

Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...