Question about 2007 Vento VThunder XL

Open Question

Broken lock on gas cap - 2007 Vento VThunder XL

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

I have a fuel door on a VW beetle that will not open electronically.


Some cars have a semi hidden wire in the trunk that you can pull to open the door.

Apr 21, 2015 | Cars & Trucks

2 Answers

2008 Toyota Camry gas-cap door release is stuck; how do you release it?


Hi fellow,
Your problem has two options ;first, you have to inspect the interior wire that pulls the lock of the gas cap.If found cut you should replace it at the mechanic's. Secondly, once the wire remains uncut or undamaged by any reason, the lock itself might be jammed due to the rust or misuse. Therefore, you are advised to use some anti rust liquid it wil work. Good Luck.

Jun 09, 2014 | 2008 Toyota Camry

1 Answer

Broken gas caps


Use pointy nose pliers, usually you can get into it and push the release or such to get it to move.

Mar 24, 2014 | Vehicle Parts & Accessories

1 Answer

How to remove the locking gas cap with broken out tumbler


Use a BIG or screw driver or pry bar drive it threw where the lock cylinder is or was, and pry the top of the locking cap to get to the threaded part and then just unscrew it out of the tank that simple.

Apr 06, 2012 | 2007 Vento VThunder XL

1 Answer

I bought a gas cap from checker auto parts because mine was broken the new one does not click....is it not fitting correctly?


  • If you bought a new gas cap and it is not clicking it is either not a locking gas cap or it is to small and not catching properly. You might want to take that gas cap back and ask for the proper one.

Regards, Tony

May 10, 2011 | Ford Explorer Cars & Trucks

1 Answer

I tried to open the gas tank (lock) but i stick my key in (also tried the spare) but the lock would not turn. I looked up some toubleshooting and used wd40 in the lock and along the rubber seal outside but...


There is either a small piece of something keeping you from fully inserting the key , the lock is broken, or the lock has been replaced and the replacement uses a different key. On my 2009 Ex250 the key turns 1/4 turn clockwise and is very easy to turn. Worst case scenario, you may have to drill the tumblers out of the lock. Even if you undue all the top screws but the cap will not come off. There is one security screw under neath to keep the fuel thieves from just taking the top off. If you damage the cap beyond use you can always replace it with a Slingshotracing gas cap. You could take the tank to a locksmith to see if they can pick it. Hope this helps.

Mar 02, 2011 | 2008 kawasaki Ninja 250R

2 Answers

P0440 evaporation emission control system malfunction


That is a very broad code could be as simple as a gas cap that is loose. or a loose or broken breather hose for your evap system. If you have an after market locking gas cap throw it away and get a factory style cap.

Feb 11, 2011 | 1999 Chevrolet Venture

1 Answer

Key no longer works in ignition. I stopped to gas up and the key I normally use would not open the gas cap door. I re-entered the car and the key would not turn the ignition. The key unlocks the steering...


take it to a lock smith to remove the broken part or you could jam the broken part down to where the ignition will turn with the broken key. I advise taking it to a lock smith to remove the broken part

Feb 02, 2010 | 2001 Toyota Tundra

1 Answer

I have a 1985 Honda Shadow motorcycle with a broken gas cap. The tumbler is out and I can see the slides, but can't get the cap off. Any sugestions?


sometimes if you fill the lock with a heavy grease, it may be enough to depress the tumblers su u can turn the lock with a screwdriver

Oct 31, 2009 | 1985 Honda VT 500 C Shadow

1 Answer

Once and a while car wont start


If the gas cap is off or defective this could be the source. GM's gas caps don't last, look at the o-ring and when it clicks, is it strong, and does it lock-on. If it all checks out then it could be a defective air-pump, or broken vacuum line.

Jun 03, 2009 | 2004 Pontiac Aztek

Not finding what you are looking for?
2007 Vento VThunder XL Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Vento Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Brad Brown

Level 3 Expert

15557 Answers

Are you a Vento Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...