Question about 2003 kawasaki KLR 250

Open Question

2003 Kawasaki KLR250 will not start?

The bike ran great. I parked it and about two hours later I went to start it. Two weeks later and it still wont start.

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 149 Answers

SOURCE: Bike wont start

Remove battery and get it charged the tested..More likely its failed. when engine is running check battery voltage it should be 12.8 to 14.2 volts with good battery

Posted on Jan 31, 2009

cape cod bob
  • 292 Answers

SOURCE: kawasaki zepher - stalled and now wont start

poor fuel, gummed up carbs. blocked fuel filter, if you in the US get some Berrymans B12 double the dose and put it in the gas, hopefully you can get it to turn and draw it through to the carbs, it should clean them out, also you can try the berrymans spray carb cleaner, remove air cleaner, make sure slider in carb is up and spray a bunch in.
did you have lights when it died or nothing at all?

Posted on Apr 03, 2009

  • 1 Answer

SOURCE: kawasaki klr250

Need a valve adjustment or and clean your Pilo jet

Posted on Jul 25, 2009

SOURCE: My 2008 Kawasaki 250r Ninja has NO power at all.

Check the battery connections especially the main wires and to the fuse box too.

Posted on Aug 06, 2009

nedkelly900
  • 345 Answers

SOURCE: Bike wont kick start or idle , it will coast

first drain the carby, then set your air mixture screw 2 turns out, from the fully turned in position. The starting proceedure is as follows, when the engine is COLD, turn on fuel, pull on the choke fully, and kick the engine over. DO NOT use any throttle, when the engine is cold, and the choke is on. Remember Choke on, NO throttle.
When warm, no choke, and a little throttle when kicking.

Posted on May 13, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1990 kawasaki 454 that wont start


DISCONNECT NEGATIVE CABLE AND START BIKE IF WORKS RECONNECT NEG AND REV AT HIGH SPEED TO CHARGE BATTERY YOU NEED TO CHECK RELAYS FUSES TERMINALS WIRES MALE TO FEMALE ENDS NO CONTACT ETC.

Jun 24, 2013 | Motorcycles

1 Answer

Zx6r 2004. Bike ran great for two months. Went out to dinner last night and came out to my bike not starting. Trailered it home, started when taking off trailer. Went for a 15 minute ride and parked it....


Hi, Matt it saddens me to inform you that you have to put on your Battery Priest Robe and prepare yourself for the Ceremonial "LOAD TEST" but before you begin, maintenance type batteries must be topped off with distilled Holy Water and all batteries must present their terminals to the battery charging altar to receive the electrical infusion of Holy Ions until they have reached a 100% full charge of 12.5 volts or better.
Below is a quick and easy test to see if your battery is in good condition or needs Last Rites and must be replaced.
1. Start by disconnecting the spark plug cables.
2. Adjust voltmeter to DC volts 20-volt range
3. Place the voltmeter leads to the battery terminals.
4. Turn the run/off switch to run.
5. Turn the ignition switch on and press the starter button.
6. Watch the voltmeter as your engine turns over for 15 seconds.
7. If the voltage drops below 9.5 volts, the battery is faulty and must be replaced.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
ZX6R 636 Bike won start
Kawasaki NINJA ZX6R My bike won start Starter problem or discharged battery
Kawasaki Ninja ZX6R Service Manual
OEM Parts for Kawasaki
Kawasaki Ninja ZX 6R Owner Manual
How to Tell if Your Battery is Bad in 3 Easy Steps

May 18, 2017 | 2007 kawasaki Ninja ZX6R

1 Answer

2007 kawasaki Ninja 250r Cranks but wont startt


It sounds like the float needle valves are lletting gas run into the bowl,in turn running gas into the motor,and fouling the spark plugs. Have you noticed if the oil level seems to be going UP,or the fuel level is going down? Kawasaki motorcycles are prone to leaking needle valves in the carbs for some reason. And the longer it sits,the worse its going to get.Try this,...pull the spark plugs and see if they are wet with fuel.Then,unhook the coils,and spin the motor over with the plugs out.If it shoots raw fuel about a foot out of each or ANY cylinder,then that is your problem. JUST BE SURE TO DISABLE THE COILS BEFORE SPINNING MOTOR OVER,AND DONT BE CLOSE TO THE PLUG HOLES WHEN YOU SPIN IT OVER!!
Good Luck!

Sep 26, 2012 | 2007 kawasaki Ninja 250R

1 Answer

Randomly won't start, happened after jumping dead battery


Probably the battery. Take it the chain auto parts place and they will test it for you.

Aug 29, 2009 | 2007 Mazda B4000

1 Answer

Oil leaking from under the seat of my Kawasaki klr250


not sure if this will help, but the crank case has a breather tube that is around that area. if the bike is on its side or has been doing wheelies, some oil can get thru the breather hose causing that problem.

May 02, 2009 | 2003 kawasaki KLR 250

1 Answer

KLR 250 2003 will not start tried lots please help


Hi, Fatjerry nice novella and the usual suspects are:
1. Fuel tank empty.
2. The fuel tank has old dead gas.
3. Fuel tank bottom contaminated with ethanol sludge, dirt, water, rust, etc.
4. Fuel supply valve/petcock turned off.
5. Fouled spark plugs.
6. Engine flooded as a result of overuse of the enrichner.
7. Vacuum hose to the fuel supply valve/petcock disconnected, broken, cracked, or pinched.
8. Fuel valve/petcock or filter clogged.
9. Fuel line to carburetor or throttle body pinched, kinked or blocked.
10. Carburetor float stuck.
11. Fuel injectors clogged.
12. A severely discharged or damaged battery, you need 12.5 volts or better and be able to pass a load test if necessary.
13. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
14. Loose or corroded wire connection at the coil or plug between ignition sensor and ECM module.
15. Spark plug cables in bad condition and shorting check for spark leakage in the dark, cable connections loose, or connected to the wrong cylinders.
16. Ignition timing incorrect due to a faulty ignition coil, ignition module or MAP, CMP, CKP, O2, TPS, ETP, IAC sensors.
17. Faulty neutral, clutch lever, or kickstand safety switch.
18. Faulty fuel pump or fuse or relay.
19. A stuck bent or burnt valve.
20. Tilt sensor needs a reset.
21. Security system not disarming alarm needs a reset.
22. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
KLR 250 won start
Former KLR250 owners help hard starting Kawasaki Forums
http://mototh.com/files/kawasaki/KLX250/Kawasaki-KLX250-Service-Manual_new.pdf "FREE"
Kawasaki KLR250 service manual repair 1984 2005 KLR 250 Download Manuals... $8
OEM Parts for Kawasaki
klr250ownersmanual pdf

Mar 04, 2017 | 2004 kawasaki KLR 250

3 Answers

Kawasaki klr250


Yeah,it starts. I do the same in mine. Or just use a cloth with fuel on it in the back of the carb,as i did before getting the can of spray starting fluid.Btw,if your bike doesnt want to start cold may be a carb problem(lean mixture) or choke not doing its job.

Mar 06, 2009 | 2003 kawasaki KLR 250

2 Answers

Kx 125 wont start


check air filter and drain old gas out

Feb 27, 2009 | kawasaki Full Suspension Mountain Bike Men

1 Answer

2003 883 sportster wont start


What u are describing is typical of a faulty ignition system, but could also be a fuel problem. I check by removing the aircleaner and rotating the throttle. If u see a nice spray of fuel, thats probably not the problem. Check for a spark at the plugs. I can explain how if you need me to. If you cant see a good spark, U have an electrical problem. I had a crank position sensor go bad on me. Dont do what I did (replaced the battery, ignition, and regulator as part of my diagnosis procedure)

Nov 08, 2008 | Harley Davidson Harley-Davidson Motorcycle...

Not finding what you are looking for?
2003 kawasaki KLR 250 Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...