Front indicator lights - BMW Motorcycles

The AU ford has two indicator relays , turning lights and hazard lights ,both use the indicator lights ,the hazards flash both front and rear lights , the turning indicator flashes one front and one rear light. I think the fault may be in the hazard circuit.

I suspect that the problem is in the indicator switch and not the lights. To prove this press the hazard lights and if all lights flash it is not the lights or circuits./he indicator unit just flashes and the power is directed to each side depending on where the indicator switch is positioned . If one side flashes first and repositioned to the other side and it won't work then it indicates a switch fault and not bulbs.

check battery earth to engine/frame

check for any blown bulb or fuse

For the front indicators look under the front wheel arch up towards the front light/indicators and you will see a small plastic panel this is to allow removal of the indicator bulbs

check the earths....could be a bad earth...

sounds like you have crossed the wiring,take apart and re try wiring 1 indicator side at a time this should clear the problem

I would say try and REPLACE the turn signal fuse/relay. It should be a square, black fuse/relay on your fuse panel. They run about $10.00.

There are two black plastic clips behind the the air filter, remove them and release the whole assembly to access the lights.

If you still get in troubles, have it replaced at a petrol station, they will help you in fitting the bulb, and it won't be expensive.


Here follows
2003 Chevrolet Tracker Light Bulb Size Chart
Low Beam Headlight Bulb Size: 9003/HB2
High Beam Headlamp Light Bulb Size: 9003/HB2
Parking Light Bulb Size: 1157A
Front Turn Signal Light Bulb Size: 1157A
Rear Turn Signal Light Bulb Size: 921
Tail Light Bulb Size: 7443
Stop Light Bulb Size: 7443
High Mount Stop Light Bulb Size: 168 Or 921
License Plate Light Bulb Size: 168
Back Up Light Bulb Size: 921
Front Sidemarker Light Bulb Size: 194
Ash Tray Light Bulb Size: 74
Step/Courtesy Light Bulb Size: 168
Trunk/Cargo Area Light Bulb Size: 168
Instrument-General Light Bulb Size: 158 or 74
Check Engine Indicator Light Bulb Size: 74
Hi-Beam Indicator Light Bulb Size: 74
Seat Belt Indicator Light Bulb Size: 74
Brake Warning Light Bulb Size: 74
Automatic Transmission Indicator Light Bulb Size: 74
Directional Signal Indicator Light Bulb Size: 74

Depending on whether it is the front or the back turn indicator light will determine on what needs to be done. If it is the front turn indicator light open the hood of the car you may need to take the entire headlight out. The headlight may have screws, take the screws out then the front light will come out from the outside of the vehicle replace the burned out bulb. The bulb should snap right in and then put the headlight back in make sure you put all screws back in from the inside of the hood. Step2 If it is the back turn indicator light, go through the trunk of the vehicle. If there is a panel covering the lights you must unscrew the panel and then replace the burned out light bulb. Some panels can be folded down without removing all of the screws to access the lights. This light may not require for you to pop the entire light out you maybe able to just replace the bulb. After you have replaced it screw the panel back into place. The back light should not require the entire light to be lifted out just a simple bulb replacement. Step3 In replacing either the front or the back indicator light you must gain access to the turn signal housing which is usually in the same case as the headlight or your rear lights. It is very helpful to also get the owners manual out this will tell you exactly what type of bulbs you will need to get to replace the indicator bulb.