Question about 2009 Yamaha Zuma Base

1 Answer

Yamaha yw 50 carburetor

After winter hibernating has 8-9mi less speed

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    One Above All:

    The expert with highest point at the last day of the past 12 weeks.

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

  • Yamaha Master
  • 47,210 Answers

Hi, Anonymous if your bike has been sitting idle for months or years and you did not do any pre-storage maintenance I feel your pain it will probably have a dead battery and not want to start or if it starts it will idle and run poorly then stall, here are the following steps necessary to complete in order to get your bike back to an acceptable running condition.
1. If your battery was 2-3 years old when you last had the bike running you should replace it.
2. If you believe your battery might still be serviceable remove it from the bike and put it on a 1 or 2 amp trickle charger for 24 hours. If it is the old lead acid type with visible cells and acid levels fill each cell to the top line with distilled water and replace the caps, run the vent tube into a plastic or styrofoam cup, any cells that are cloudy/milky replace the battery.
3. After charging remove the leads and let the battery sit for a couple of hours then check the battery voltage with a volt meter, you should have 12.5 volts or better, any readings in the 11 volt range you need to do a proper load test on the battery and replace as necessary, any readings in the 10 volt range you have a dead cell and the battery needs to be replaced.
4. Drain and flush fuel tank, google " how to clean a motorcycle gas tank" find a couple forums to view the different options available.
5. Remove and inspect your air cleaner paper elements that are not oil soaked can be cleaned with a soft brush and low pressure compressed air, oil soaked elements must be replaced. Gause mesh and foam elements can be cleaned by soaking them in a container big enough to completely cover them with a solution of 1 gallon of water and 1 oz. of Dawn dishwashing liquid for small and medium size elements, for monster size double the formula and let soak for at least one hour then rinse with warm water shake off excess and let air dry, "WARNING" do not use compressed air as this will embed micro-sized dirt and road grime and destroy the mesh pattern and stretch foam elements out of shape just squeeze it like a sponge and let air dry, use a fan if you're in a hurry. When completely dry spray a very fine mist of air filter oil evenly around the whole element.
6. Remove the carburetors, disassemble and decontaminate with a carb dip or if you have EFI remove injectors and clean with carb spray and compressed air
7. Remove fuel valve and filter disassemble and clean as necessary, remove, clean, and inspect fuel and vacuum lines and replace as necessary.
8. Replace spark plugs with new ones and check for spark.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
Yamaha YW50T Owner Manual
OEM parts for Yamaha
http://www.49ccscoot.com/manuals/Yamaha_BWS_Zuma_50_2T_Service_Manual.pdf

Posted on Nov 21, 2016

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
carlsbiz
  • 1124 Answers

SOURCE: Am preparing to store my 08 TW 200 for the winter.

It is loceated at the bottom of the bowl on the carb and faces down.. A tub shaped part of the carb..

Have a good day !

Posted on Oct 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I remove the choke cable from top of carburetor?


PDF]PW80T Owner's Service Manual - Yamaha

www.yamaha-motor.com/.../lit-11626-18-30_108... Yamaha Motor Company1st Edition, April 2004. All rights reserved. ... GINNING RIDER. DO NOT REMOVETHESE ITEMS UNTIL THE ADULT SUPER- ... may leak out of the carburetor or fuel tank. 5. ... Removal of this plate adds to the ..... side of the engine on top of the crankcase. 1. .... Throttle Check for proper throttle cable operation 5, 12. Air filter ...

Yamaha PW 50 checking carb - YouTube

? 3:03
https://www.youtube.com/watch?v=M5Pe6YH6l3c
Apr 18, 2012 - Uploaded by fupabox
Checking out the slider,choke,and fuel flow on a 2002 Yamaha PW 50 ... Top comments ... the idle speed adjustment is either too low or the carb is gummed up...with it ... get full throtle and it just boggs any suggestions on what i shud do ... Yamaha PW 80- First Start in Years - Duration: 7:26. by Alex's Bikes ...

How to clean a pw carb - YouTube




Dec 25, 2015 | 2004 Yamaha PW 80

1 Answer

Lost my keys to Zuma 50 cc Yamaha scooter need to be able to start without keys how


Hi, Jeremy for this situation I would call my local dealer or reputable shop's service/parts department and inquire about any possible quick fix or parts inquiry. If necessary transport your vehicle to the dealer or shop and have a professional technician take it for a test drive, if it is in running condition, and give you a written estimate of repairs and answer any specific questions you may have about your issue. For more information about your issue please visit the website below. Good luck and have a nice day.
https://www.tradebit.com/filesharing.php/search/0/yamaha+zuma+yw+50

Nov 01, 2015 | Yamaha Motorcycles

1 Answer

What is the length of the contra spring on 2010 yamaha bee wee 100cc


Hi, Anonymous for this situation I would call my local dealer or reputable shop's service/parts department and inquire about any possible quick fix, answers, or parts inquiry. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
ScooterCommunity
Performance Spring set for Yamaha 50cc 100cc Beewee 50 Beewee 100 BWS 50...
YAMAHA BWS YW100E Owner Manual
OEM parts for Yamaha
Yamaha XC125 Service Manual

Jun 25, 2014 | 2007 Yamaha yW 100 Beewee 100

1 Answer

Yamaha 2008 TZR 50 carburator connections


Hi, Anonymous for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Yamaha, despair not, for a mere zero $ you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Parts formoped Yamaha TZR 50 50 2008 Fuel system motor pl Online Store
Yamaha 2008 TZR 50 carburetor connections Google Search
Yamaha TZR50 03 Service Manual
OEM parts for Yamaha
YAMAHA TZR50 Owner Manual

May 26, 2012 | 2008 Yamaha TZR 50

1 Answer

No fuel getting to carb 2007 Yamaha yW 100 Beewee 100


Hi, Paul always check fuel flow first to isolate the problem area otherwise the usual suspects are:
1. Fuel tank empty.
2. Fuel cap or fuel tank not venting properly.
3. Fuel filter clogged with rust or dirt.
4. Vacuum line to fuel valve clogged, cracked, pinched, bent, broken, or missing*
5. Faulty vacuum line switch/relay
6. Petcock clogged or diaphragm cracked, cut or torn*
6. Fuel line from the fuel valve/petcock to the carburetor clogged, cracked, pinched, bent, broken, or missing.
7. Vacuum lines to the mechanical fuel pump clogged, cracked, pinched, bent, broken or missing*
8. Faulty electric fuel pump and or wiring*
9. Fuel line from the fuel pump to the carburetor clogged, cracked, pinched, bent, broken, or missing*
10. Carburetor inlet fitting clogged.
11. Carburetor float and or needle and seat stuck.
12. Carburetor overflow line clogged, pinched, or bent.
13. Vacuum line from carburetor deacceleration valve not zipped tied*
* If equipped or applicable.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a wonderful day.
Yamaha BWS 100 2 Stroke Scooter Problem
ScooterCommunity
http://www.49ccscoot.com/manuals/Yamaha_BWS_Zuma_50_2T_Service_Manual.pdf
OEM parts for Yamaha
YAMAHA BWS YW100E Owner Manual

Jan 12, 2012 | 2007 Yamaha yW 100 Beewee 100

1 Answer

Pls tell me the actual mileage after 1st servicing? and how to improve its mileage condition? the mileage is the main hedeache after purchasing Yamaha SZR..........pls. solve it...


I have not used Yamaha SZR. But I know Yamaha bikes are not popular for fuel efficiency. Although, I can say that with proper carburetor adjustment & running the bike between 50-60 kph improves the mileage a lot. I had RX-100, to which I was getting 50-57kmpl in Mumbai. People at the time weren;t getting average more than 35kmpl. It was a 2 stroke engine. I used to make the carburetor adjustment myself. When I service the bike from the service centre, the mileage was dropping by 10kmpl. So, you adjust the carburetor in such a manner that keep the idling speed at a level when the engine is just not stopping by adjusting the idling speed screw & adjust carburetor throttle screw to the smooth noise (minimum) of the engine. People used to keep engine running at traffic signal. If the signal is to change after 20-30 secs, shut off the engine. Avoid raising the throttle unnecessarily. Try to be at the top gear in optimum distance. I was using oils from Indianoil. Any other oil was dropping my mileage. Clean the Air Filter with petrol & moist it with oil once in a month. I think this may be helpful to you in achieving more mileage.

sonsunny

Jul 08, 2011 | Cycling

1 Answer

How to open seat on 2004 yamaha yw 50 zuma scooter


Hi, Rsalanchy for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Yamaha, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
https://sg.answers.yahoo.com/question/index?qid=20080127073621AAqQ1Zv
Yamaha Zuma 50cc Back End Removal
Yamaha YW50P Service Manual
OEM parts for Yamaha
Yamaha ZUMA YW50T Owner Manual

Jun 28, 2011 | 2005 Yamaha Zuma

1 Answer

Am preparing to store my 08 TW 200 for the winter.


It is loceated at the bottom of the bowl on the carb and faces down.. A tub shaped part of the carb..

Have a good day !

Oct 29, 2009 | 2005 Yamaha TW 200

Not finding what you are looking for?
2009 Yamaha Zuma Base Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

vince

Level 3 Expert

1211 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1147 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...