Question about 2003 Suzuki GSX-R 600

Open Question

2003 gsxr 600 turns over but wont run

I started my bike one morning it sounded like it was missing an five min later it shut off and i can seem to get it to start...i changed plugs, got battery checked, and cleaned fuel filter...what else can i check?

Posted by Anonymous on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 23 Answers

SOURCE: GSXR 750 Slingshot wont rev past 5000rpm, with or without choke

I have seen this before a few things to do too make sure. First take the air filter out and shine a light use your fingers to move the slides up and down I suspect the springs that go on the slide is not seated in center you can tell from the slide going halfway and hanging up. Next, the boots on the slides only go on 1 way there is a notch on the carbs for them. I would guess this would fix you up if not we can get deeper into it with air-fuel mix screw settings.good luck

Posted on Mar 25, 2009

Ad
  • 3567 Answers

SOURCE: i have a 89 suzuki gsxr 750,it fires but will not

Clean the air filter and, if you have one, remove the water trap bowl on the fuel petcock and clean it. How good is the battery? Install new STOCK plugs. Bear in mind it may be time for carb kits. Other than your cleaning the carbs, the carb kits and balancing and synchronizing of the carbs are best left for the shop to do.

Check the exhaust pipes. If there is a restriction in the burned gases exiting the tailpipe then the bike will not run right, will loose power and even die if too much back pressure builds up. Disconnect the exhaust system and tick off the neighbors with a quick ride around the block without a muffler. If the engine still dies then exhaust is not likely to be the problem.

Check the compression on all cylinders. Depending on the compression, the bike may be ready for a valve job. If you pull the head for the valve job then you might as well consider re-boring the cylinders and install new pistons and rings. Bear in mind, doing a valve job and / or pistons is not recommended for the novice. The good part is that when the work is finished you will effectively have a new engine.

Please rate this solution as "FixYa" if I have answered your questions. Thanks!

Posted on Mar 25, 2009

  • 440 Answers

SOURCE: My 2008 gsxr 600 that i bought 2 days ago is

Its nothing to do with the damper
The battery may not be accepting charge due to its age or condition (although as u can bump it soon after it sounds ok). Check this out with a charger & meter
There may be a bad or dirty connection somewhere between the alternator & regulator/rectifier or from there to the battery
It could also be a defective alternator winding or regulator/rectifier unit
Ride Safe
Bike-doc

Please mark this as useful (if it has been!!)

Posted on Aug 03, 2009

  • 265 Answers

SOURCE: suzuki gsxr 600 06 starting problems

200° is quite warm...
If the engine wont turn over, probabily you have a bad battery, a bad starter or a bad starter relay, or bad connections.

A hot engine has more compression. If the full battery power doesn't reach the starter it won't turn over...

Posted on Aug 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The bike starts on the button drives no problem turn it off leave for 10 mins turn back on f1 light is on bike wont start


http://www.gsxr.com/showthread.php?t=1234&highlight=codes i know th
is link is for gixxers but shouldnt be a massive difference and should give a rough idea hope it helps

Feb 13, 2011 | 2006 Honda CB 600 Hornet F

1 Answer

I have a 2007 gsxr 600. When i start it up and its cold it runs fineas soon as it heats up to temp it starts sputtering and loses power and it dosent idle very well like its missing bad pls help thx


You get any help on this problem? My bike is doing the same thing - Also, when it gets hot and turns off I can't get it to start back up all the time... Starting cold usually gives no issues -

granthoneycutt@hotmail.com

May 20, 2010 | 2005 Suzuki GSX-R 1000

1 Answer

1990 FZR 600 - Battery problems? drainage?


this is yours jarnater or regulater problem same problem to me i have fzrr 400 but i install a new regulater and then i solve my problem

Feb 18, 2010 | 1990 Yamaha FZR 600

2 Answers

Bike runs but when i try to start it the battery is dead


Do a voltage test at the battery to see how it is charging, it sounds like it is not... You should charge at 14.5 volts. Start the bike with the voltmeter connected and see what it does for voltage drop and see how it recovers after it is started. If it doesn't come up in voltage possible regulator rectifier or worse case bad stator.

Sep 10, 2009 | 2001 Suzuki GSX-R 600

1 Answer

Suzuki gsxr 600 06 starting problems


200° is quite warm...
If the engine wont turn over, probabily you have a bad battery, a bad starter or a bad starter relay, or bad connections.

A hot engine has more compression. If the full battery power doesn't reach the starter it won't turn over...

Aug 19, 2009 | 2006 Suzuki GSX-R 600

1 Answer

2003 gsxr 600 electrical problem


check corroded wires at connector of the left hand switch coupler

Jun 03, 2009 | 2003 Suzuki GSX-R 600

1 Answer

LEAKING OVERFLOW PROBLIM


it sounds to me like the carb float levels are out of adjustment and it is overfilling the bowls,or,the needle valve seats are worn and leaking,which will allow fuel to continue filling the bowls even though it looks like they are closed,remove the carbs from the bike,remove the bowls,turn the cabs upside down close the floats(push them right to the top,this simulates full bowls)then blow throgh the fuel inlet pipe,if you can hear air escaping from around the seats they are faulty,also check that the seats themselves are tight in the carb body,i dont know why but gsxr carbs seem to shake the valve seats loose..hope this helps

May 30, 2009 | 2000 Suzuki GSX-R 600

Not finding what you are looking for?
2003 Suzuki GSX-R 600 Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers

Richard
Richard

Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...