Question about 2003 Suzuki VL 1500 Intruder LC

1 Answer

Vl1500 starter switch

Hit starter button nothing . have full batt. power . checked rely good .

Posted by Anonymous on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

Sounds like a bad stator or voltage regulator

Posted on Sep 24, 2014

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: My vl1500 won't turn over. When you hit the start

had same problem ! found out it was the safety switch in the clutch that was not giving ok to start

Posted on Jul 11, 2010

markmezo
  • 15 Answers

SOURCE: 2006 suzuki sv 650 will

First prove its not the switch that is the problem, unplug it from the loom & short the cables with a paper clip (OW & YG) that would be my first step.

Wiring diagram

Mezo.

Posted on Jun 08, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 Suzuki Boulevard C90T will not start


Hi, Angel before testing any electrical component in the Starting System it is "IMPERATIVE" that you have a fully charged battery of 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a preliminary reading of 12.5 volts or more but little or zero amperage, the battery is faulty and must be replaced. AGM type batteries fall into this scenario more so than lead acid batteries.
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter.
4. Bank angle sensor needs a reset or is faulty.
5. FOB battery low or dead.
6. Faulty ignition switch.
7. Faulty starter button.
8. Faulty kickstand, clutch, neutral safety switch.
9. Security alarm needs a reset.
10. Starter relay, solenoid, starter have failed or circuit wiring faulty.
11. Starter armature or field coils have failed.
12. Main fuse or circuit breaker may be blown or faulty.
13. The electric starter is working but starter clutch has failed.
14. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
C90 wont start
What Do Check When My Motorcycle Won Start Honda Shadow Forums Shadow... very comprehensive
Suzuki VL1500 Service Manual
OEM parts for Suzuki
Suzuki Intruder VL1500B Owner Manual

Jun 15, 2017 | 2007 Suzuki Boulevard C90T

1 Answer

2000 Suzuki intruder VL1500 battery over 12 volts but no lights or power completely dead


Hi, Louis and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, needs to be 12.5 volts or better and be able to pass a load test if necessary.
4. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
5. Tip over sensor needs a reset.
6. Faulty ignition switch.
7. Faulty starter button.
8. Faulty kickstand or clutch pull in switch/sensor.
9. Starter control circuit, relay, or solenoid faulty.
10. Main fuse or circuit breaker may be blown or faulty.
11. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Totally dead no power
Suzuki Intruder 1500 LC
Suzuki VL1500 Service Manual
OEM parts for Suzuki
Suzuki Intruder VL1500B Owner Manual

Feb 25, 2017 | 2000 Suzuki VL 1500 Intruder LC

1 Answer

Yamaha MT03 - shorting / or loss of power


Hi, David check all wire connectors in the ignition and starter circuit and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, needs to be 12.5 volts or better and be able to pass a load test if necessary.
4. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
5. Tip over sensor needs a reset.
6. Faulty ignition switch.
7. Faulty starter button.
8. Faulty kickstand or clutch pull in switch/sensor.
9. Starter control circuit, relay, or solenoid faulty.
10. Main fuse or circuit breaker may be blown or faulty.
11. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Yamaha MT Owners Club
What to do When Your Motorcycle Won Start
Yamaha MT 03 Service Manual
OEM parts for Yamaha
YAMAHA MT 03 Owner Manual

Mar 08, 2017 | Yamaha MT-03 Motorcycles

1 Answer

Haedlight is not working on a suzuki vl1500 K5.


Take off the headlight and put power directly to the bulb ( a piece of wire and your car battery will work). If the bulb and fuses are good then try cleaning the starter button. It is a two position switch that both turns the head light off and engages the starter solenoid. If the starter button is defective you will have to replace the right switch assembly to fix the problem.

Apr 18, 2011 | 2002 Suzuki VL 1500 Intruder LC

1 Answer

When i hit the start button nothing happens the switch is good and gets power but doesnt turn bike over


If you have a volt meter hit switch to start and see if voltage is present at positive lead on starter.If your good to there its your starter has gone bad.

Apr 08, 2011 | kawasaki Ninja Zx7r Zx9r '94 To '04

2 Answers

Installed new baterry and new alternator...battery or alternator dies in one day


the alternator will not die in one day unless there is a direct short causing diode or coil winding failure which would give signs of smell, melted wires. Disconnect battery and give full charge. what year is this? while vehicle is running you should be able to briefly disconnect positive battery post connection and vehicle will still run if alternator is good. For a new battery to die in one day, one of two things i think has happened. Either the batt is faulty from supplier,( not likely but i have seen it ) or there is a direct draw or grounding taking place whether its direct in the starter selonoid or a direct draw through accessories. Are you sure all switches are off ? Push switches (on interior lights) nothing like dome lights,delayed lights are staying on! Does vehicle start hard like it almost needs a jump. If it has to be (and it takes time). to find out what is drawing the power ( i am old school) disconnect positive power source on batt. 2) disconnect ignition power source on starter. 3) connect pos batt wire to starter, 4) touch positive cable to positive batt post and look for spark or contact. if this reacts then selonoid or starter motor is shorted drawing the current. Or if you have volt meter and know how to use it, this is good to. If checks good then hook ignition connection back on starter.(disconnect pos terminal on batt prior to re-connect) I think the battery is having the life sucked out of it by a short in the system ( A DRAW ) this could be a quick find or fix or this could take days to track down. alot of variables here to try to explain. but i would seek into the starter first as usually this drains the battery quickly .

Jan 13, 2011 | GMC K1500 Cars & Trucks

4 Answers

Jeep doesn't start. Turn key, hear slight click in fuse box but nothing else? Took battery out to be checked Pep Boys says its good, needs a "slight" charge. Went home reinstalled the clean...


clean all connections very good ( batt post connectors,gound wire from batt to frame/motor, also clean starter connections,and alternator connections) I know pep boys checked but you cannot properly check a battery unless it has a full charge!!!!! If it wont accept a full charge then batt is bad, If it charges to a full charge and fails a draw test the batt is bad. also when a draw test is done you can have the charging system checked also to make sure batt is recieving the proper charge input. all inexpensive checks, get it running and take it to a garage, 3 min test usually not even a charge most of the time. NOT A DEALER, and have them show you what they are doing. if you are a female have a male friend go with you or have it done. I dont care what anybody says!!!!!! When it comes to a inexperienced female, the DEALERSHIP,the REPAIR GARAGES will all try to get some kind of MONEY out of you before you leave their place of business.

Jan 10, 2011 | 1996 Jeep Cherokee Sport

1 Answer

Starter turning motor over very slowly starter stalls after about half revolution. batt. load test, all connections good.


do a draw test on the starter hook a voltmeter to your batt and hit the starter button if it drops to2or3 volts then comes back up when button is released you need a starter it should only drop to about 6 volts under load

Jul 29, 2009 | Harley Davidson Harley-Davidson Motorcycle...

1 Answer

Our 2003 caravan just stopped starting,we have owned this van for 4 mon no problems, only 70000 mls, all of the sudden it won't start, changed out auto safety shut down relay switch, ignition switch still...


Check the starter selenoid, check for corrosion on batt, terminals and inside the cables, tap the starter with a metalic object and try to start the car, if it starts change the starter.

Jul 10, 2009 | 2003 Dodge Caravan

Not finding what you are looking for?
2003 Suzuki VL 1500 Intruder LC Logo

Related Topics:

108 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

Richard
Richard

Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...