Question about 1993 Harley Davidson FLSTF Fat boy
Posted by Anonymous on
Hi Anonymous, here is the short version: disconnect battery ground cable, drain and remove primary cover, starter jackshaft bolt while holding pinion gear, starter end cap, all wires and cables, starter mounting bolts, and remove starter. Go to website below to down (highly recomended) factory service service manual for $5.50
Posted on Apr 27, 2015
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Drain the fuel either by siphening or removing the cross over tube at the front of the tank and letting it drain that way or just block off those cross over lines and leave the fule in the tank for removal.
0) remove seat
1) drain fuel
2) undo cross over line (bottom front of gas tank.
3) shut off pet **** and remove fuel line from pet ****.
4)there should only be 2 bolts holding the tank on, one at the top front of the tank and one at the back of the tank.
All in all a pretty easy (but possibloy messy) job.
Posted on Jun 06, 2009
The starter on a late model Harley is a typical Nippondenso gear reduction type starter. They are all basically the same except for size.
To replace the starter clutch inside the starter assembly requires disassembly of the starter assembly.
I you will contact me directly, I will scan the procedure and drawings out of a service manual for you.
Posted on Sep 24, 2009
Disconnect battery , remove the outer primary case, pull back the lock tab on the starter jackshaft, unbolt the retainer screw, then remove the two starter bolts from the right side, sometimes you need to loosen the oil tank mounts to get at these, slip the starter and coupler out as a unit, replace the coupler and jackshaft the same way they came out when the new starter goes in, install bolts , retighten the jackshaft bolt and bend over the retainer, install and fill primary case, connect battery thats it buddy
Posted on Oct 12, 2009
its very straight forward.. Disconnect the battery and drain the chain case and open it ....... Then take the jack shaft bolt off. hold the gear with a pliers. After that - the starter just has 2 mounting bolts, Harley says to remove the rear exhaust but I havent had to. Disconnect the electrical and pull the starter straight out
Posted on Mar 11, 2010
Tips for a great answer:
Jun 14, 2014 | 2003 Harley Davidson FLSTFI Fat Boy
Feb 28, 2014 | 1993 Harley Davidson FLSTF Fat boy
Aug 22, 2013 | Harley Davidson Motorcycles
Apr 29, 2012 | 2006 Harley Davidson FLSTFI Fat Boy
Aug 18, 2010 | Harley Davidson Harley-Davidson Motorcycle...
May 20, 2010 | 1993 Harley Davidson FLSTF Fat boy
Jul 11, 2009 | Harley Davidson Harley-Davidson Motorcycle...
May 01, 2009 | Harley Davidson Harley-Davidson Motorcycle...
Mar 23, 2009 | Harley Davidson Harley-Davidson Motorcycle...
145 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: