Question about 2006 Harley Davidson FLHRCI Road King Classic
Posted by Anonymous on
Hi Anonymous, there is a small seal behind that arm and you have to remove the inner primary to replace it. Not a job for the average do it your self type. Take it to your local dealer or reputable shop. Good luck
Posted on Apr 18, 2015
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Tips for a great answer:
Aug 31, 2014 | Harley Davidson FXSTB - FXSTBI Night Train...
Jul 07, 2014 | 2005 Harley Davidson FXSTD - FXSTDI...
Oct 11, 2013 | John Deere 420,1020,2010,2020,2510,2520...
Mar 17, 2013 | 2002 Harley Davidson FLHRCI Road King...
Nov 14, 2012 | 2006 Harley Davidson FLHR Road king
To adjust the shift linkage and not the height of the foot pedal the shifter arm should be tight on the shifter shaft that goes into the transmission behind the primary inner case. The Shifter arm should be positioned with the top end just rear ward of the top transmission cover bolt, positioned there by its placement/orientation on the shifter shaft which is itself positioned by the shifter pawl and spring inside the transmission itself. With all of these components in place as they should be the shift linkage runs from the top of the shifter arm to the front of the bike and the shifter pedal shaft arm. To adjust the length of this shifter rod you will either loosen the lock nut and remove the bolt/threaded shaft on one end of the shifter rod and then loosen the locking nut on the rod at one end (or both ends) of the rod and turn it to lengthen or shorten (increase or decrease) the rod length on one or both ends of the linkage rod until you get it where it just fits into the shifter arm hole(s) again with the pedal sitting where you want it be, re-install all hardware and tighten all hardware etc. If you want the pedal height above a floorboard or if you otherwise just want to adjust the pedal height/position you would not adjust the shifter rod linkage but would loosen and remove the pedal arm and re-position it where you want it and then re-install it and tighten its hardware again etc. Of course you could adjust the pedal height in a small increment by adjusting the shifter linkage if the placement on the pedal rod serrations does not align the pedal close enough to the precise location you want it to be at.
Sep 29, 2012 | 2009 Harley Davidson FXD Dyna Super Glide
May 20, 2017 | 1991 Subaru Legacy
Mar 30, 2011 | 2004 Chevrolet TrailBlazer
Feb 12, 2009 | 1994 Honda Accord
Aug 14, 2008 | Chevrolet Camaro Cars & Trucks
64 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: