Question about Harley Davidson FXDWG - FXDWGI Dyna Wide Glide Motorcycles

1 Answer

I have a 2006 dyna wide glide i have a l e d tail light on it but the tail dont work but the brake light woks

Posted by Anonymous on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Harley Davidson Master
  • 3,506 Answers

Were the lights working properly and then stopped or was the LED light installed and then did not work or?????????

Posted on Oct 18, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

DJ_MAX1369
  • 119 Answers

SOURCE: 2006 dyna wide glide primary noise

sounds like the chain is way to tight readjust clutch and tensioner and check for noise. you may even wanna run a charge test to see if you have stator problems or a loose compensator nut

Posted on Mar 31, 2009

v2iper
  • 150 Answers

SOURCE: will a gas tank off a 5 harley dyna wide glide

It sure will!! You answered your own question. guess i get no points for this one.

Posted on Jun 15, 2009

  • 72 Answers

SOURCE: does an 04 harley dyna wide glide have 3/4

its a 3/4 axle same as all the rest

Posted on Aug 06, 2009

  • 4 Answers

SOURCE: does anybody have a wiring diagram for 2006 dyna

You will need to purchase a service manual. P/N 99481-06A from Harley Davidson. Any dealer should be able to provide you with one for approximately $65.00.

Posted on Aug 10, 2009

  • 280 Answers

SOURCE: 2010 harley dyna wide glide. when I press the


Is the clutch cable adjusted correctly, you may need to adjust the cable so that the clutch is released more fully, there will be an adjuster on either end of the clutch cable - adjust it so that the cable is tighter - but there should be a little bit of play left in the clutch - if this does not cure the problem you could have some gearbox damage,
The bike is still under warranty so take it to a harley dealers and have them look at it.

Posted on Jan 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Tail light not working brake works


Is the tail lite OEM or was it installed after production?? DID it work and then stop or did it maybe never work???

Apr 17, 2014 | 2006 Harley Davidson FXDWGI Dyna Wide...

1 Answer

Tail light troubleshooting


Hi Anonymous, go to www.officialharleyparts.com and download free a wiring diagram for your year and model. Good luck

Apr 05, 2014 | 2000 Harley Davidson FXDWG Dyna Wide Glide

1 Answer

My running light doesn't work but my brake lights


sounds like fuse, is a different fuse to brake lights

Jul 24, 2013 | Motorcycles

1 Answer

How to replace rear brake pads


Hi Ron, for more information on your question please visit the websites below and good luck:
How to Change Rear Brake Pads on Harley Street Glide

Apr 16, 2013 | 2006 Harley Davidson FXDWGI Dyna Wide...

1 Answer

Have a 2006 dyna wide glide foot brake light brake light hand brake does not replaced lever wherte is the brake switch


The front brake switch is located inside the right handlebar control. It is a plunger type switch. The correct way to install a new one is to solder the wires on the new switch to existing wires from the old switch. Cut the wires about 2 inches or so from the old switch. Be careful when reinstalling the front lever or you may damage the plunger on the new switch.

Jun 16, 2012 | 2006 Harley Davidson FXDWGI Dyna Wide...

1 Answer

Install front brake pads 2006 harley dyna wide glide


Hi Anonymous, for more information on your question please visit the websites below and good luck:
How to Change the Front Brake Pads on Harley Davidson

Apr 09, 2012 | 2006 Harley Davidson FXDWGI Dyna Wide...

1 Answer

2001 hd dyna wide glide brake light does not come on when brakes are applied , tail light works,bulb is ok , is it the brake sensor ,where is it located and what does it look like thanx


Your Wide Glide has two brake light switches. One is in the right handlebar switch housing and operated by a tang on the front brake lever. If it's not working you probably have a bad switch up there as well. The rear brake switch is underneath the bike. Find the metal line coming out of the rear brake master cylinder. Follow this line back towards the rear brake. You should find a "tee" fitting with a small switch screwed into it. It'll have two wire plugs with about four wires on it unless they've changed something. You'll know it when you see it. Replace this switch first. Since the front brake light works off this switch as well, it may fix the front brake light switch as well. If not, you'll have to take the right handlebar switch housing apart to get to the front switch.

Good Luck
Steve

Mar 29, 2011 | 2001 Harley Davidson FXDWG Dyna Wide Glide

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

105 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Gills Lango

Level 2 Expert

195 Answers

Mike

Level 3 Expert

4336 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...