Question about 2003 Harley Davidson FLHR Road king

1 Answer

Removing fuel gauge on 2009 road king police - 2003 Harley Davidson FLHR Road king

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Harley Davidson Master
  • 43,693 Answers

Hi Anonymous, it's a press fit, while pulling up on it rock it back and forth, do not attempt to unscrew it. Good luck

Posted on Apr 18, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Harley Rdkng FLHPI police seat air suspension mechanism removal.

There are two screws below the rubber stem fixed it to the frame. You can hardly see them from any angle but can reach them through the two round openings next to the stem. Use a small wrench, through the openings, to access and remove the screws, then you can remove the stem. However, keep the entire police seat assembly since you might want to put it back like what I am doing now. I tried serveral Harley and other brands seat, high or low profile, and found the police seat is the most interesting seat to ride with.

Posted on Apr 14, 2009

  • 2 Answers

SOURCE: Fuel Gauge stays on empty

sounds like a fuel sending unit problem or an issue with the sending unit's float. May need replacing. HD- hundred dollar

Posted on Apr 20, 2009

  • 148 Answers

SOURCE: where is the oil dipstick on an 03 road king

The oil dipstick is located on the right side of bike almost directly under the football cover for the air cleaner. It's a round knob that pulls directly out (Kind of wiggle as you pull on it). Just check like a regular car dipstick pull, wipe and reinsert and then look at dipstick.

Posted on Jul 07, 2009

  • 190 Answers

SOURCE: 2007 road king police abs light stays on

with most ABS light stay means a problem.

most of the time the wheel speed sensor.

2 wire connection to pick up coil (transducer)

what is located near the axle hub.

may be not getting signal from open circuit

or transducer to far away from ring

Posted on Jul 29, 2009

v2iper
  • 150 Answers

SOURCE: Idel adjustment on fuel injected road king.\not on

Thats not totally correct. remove your air filter cover. look to the lower right side. You will see a small hole thats where the screw driver goes in to adjust your idle. Ya the dealer has a scanlizer that can also do it if u want to spend the bucks.

Posted on Dec 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1997 harley heritage softail classic add a fuel gauge


Harley Davidson Gauge Upgrade - YouTube

? 8:03
www.youtube.com/watch?v=zqx6VUX5od0
Mar 22, 2012 - Uploaded by Steve Hill Install of a Harley-Davidson 5" Combined Speedometer and ... I need to replace the speedometer of my 1998 Road King ClassicFLHRCI. .... Harley-davidson LED Fuel Gauge Install. ... How to Remove & Replace the Speedometer on a 2009 Harley DavidsonSoftail Custom 70900070A - Duration: 12:14.
You may try these as well:
www.officialharleyparts.com

Sep 27, 2015 | Motorcycles

1 Answer

Fuel gauge dont work and light is on on 2005 road king


Hi Anonymous, check your wiring and connections to the fuel gauge sending unit, then remove sending unit and manually raise and lower float arm to confirm function. Good luck.

Apr 13, 2013 | 2005 Harley Davidson FLHRS - FLHRSI Road...

1 Answer

How to remove harley road king gas tank fuel 2005 model


I have a 2008 Road King Classic (and have had the tank off), so maybe they're similar.
Disconnect the negative lead of the battery.

My dash has a screw under the nose of the seat (which must be removed) and one in the front.
lift dash and unplug harness.

If you have a gas gauge in the left hand gas cap, underneath tank unplug it's connector.

The fuel line has a quick disconnect. Pull fitting, and line unplugs.
There is a check valve inside to keep gas from leaking, but it's a good idea to have a catch cup, just in case some residual fuel flows out.

From there, I have a bolt on each side of the front of the tank, one in the center rear, then lift it off.

Mar 24, 2013 | 2005 Harley Davidson FLHRS - FLHRSI Road...

1 Answer

Fuel gauge is pegged to empty on 09 street glide


Don't know if it's the same routine, but here's the troubleshooting for a 2009 Road King:

Disconnect harness from fuel gauge
Turn ignition switch to IGN. Check for voltage at terminal 1 of fuel gauge connector.

If no voltage, repair the break.

If voltage present, disconnect harness connector from speedometer.
Check for continuity between terminal 9 of speedometer connector and terminal 2 of fuel gauge connector.

If no continuity, repair the break

If there is continuity, check resistance to ground on yellow/white wire in speedometer connector.

If less then 10 Ohms, go to item #1
If more then 10 Ohms, go to item #2

item #1:
Disconnect the fuel pump/level sending connector from the sender.
Check for continuity between terminal "A" of the connector and ground.

If continuity is present, locate and repair short to ground.
If continuity is not present, replace the fuel level sender.


item #2:
Greater then 10 Ohms resistance:
Reconnect fuel gauge connector to the gauge.
Turn ignition switch to IGN.
Check for voltage on terminal "9" of the speedometer connector.

If voltage is present, replace the speedometer.
If voltage is not present, replace the fuel gauge.


Hope this helps!

Nov 26, 2012 | 2009 Harley Davidson FLHX Street Glide

1 Answer

Will a 2002 Harley Road King Police Seat fit on my 2010 Road King?


No this will not work. unfortunately Harley has changed their seats and frames a couple of times since 2002 i would search for a 2009 2010 or 2011 police edition seat.

Dec 23, 2010 | Harley Davidson 2010 Flhrc Road King...

1 Answer

The fuel guage on my 2005 HD Road King stopped working--its either the guage or the sender/float unit---how do I replace both items??


Hi H36dive, always check your instrument fuses first also you could have a faulty sending unit or guage, there could be a problem with your wiring. On models with the fuel gauge posing as a left hand fuel cap the gauge is a press fit do not try to unscrew it, simply ample force lift up in a rocking motion to remove gauge. Disconnect wires to the gauge and with a set of positive and negative jumpers from the battery connect the positive jumper and flash the negative, gauge should peg full, if not replace gauge. With a test light check for power to the sending unit and gauge, then remove the sending unit and manually operate the float arm slowly with the correct wiring hooked up to the fuel gauge and sending unit and the ignition on, the gauge should respond accordingly if not replace the float arm assembly. For a free wiring diagram please visit the website below. Good luck and have nice day. Harley Davidson Wiring Diagrams and Schematics

Nov 06, 2010 | 2005 Harley Davidson FLHR - FLHRI Road...

1 Answer

I have a 2001 road king i want to know if there was a recall on the fuel filter and tha call letters for a road king police edition


FLHP & FLIPI, one is carb the other is fuel injected.
The fuel filter is inside the tank on both carb and FI models.
From what I have read, there may have been a recall on this model year, where they replace the fuel filter and clean or replace the injectors.
A quick call to an HD dealer service department would let you know positively. And cost nothing.

Jun 18, 2010 | 2001 Harley Davidson FLHR - FLHRCI Road...

1 Answer

How to remove the gas gauge sending unit on an


Hi Colhand, for more information about your question please visit the websites below. Good luck and have nice day.
How to replace Harley Davidson fuel filter on Fuel Injected models Part 1

Jun 05, 2010 | 2000 Harley Davidson FLHR-FLHRI Road king

1 Answer

My fuel disconnect on my 2000 police road king leaks when i reconnect is there orings that could cause the problem


Yes, there are, unfortunately the easiest way to replace them is to remove the old one and match it up to a replacement.
A quick note here is that often it is not the O-ring, sadly it is the connector hose and or the coupling on the fuel tank. So if replacing theO-ring does not help, then you may need to replace those items.

Dec 14, 2009 | 2000 Harley Davidson FLHR-FLHRI Road king

Not finding what you are looking for?
2003 Harley Davidson FLHR Road king Logo

Related Topics:

97 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

Mike

Level 3 Expert

4340 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...