Question about 1993 Harley Davidson FLSTF Fat boy

1 Answer

How to change a starter drive on a 1995 herritage softail

Posted by Anonymous on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Harley Davidson Master
  • 39,907 Answers

Hi Anonymous, here is the short version: Disconnect battery ground cable, drain primary and remove primary cover, remove starter jack shaft bolt while holding the pinion gear, remove rear exhaust pipe, remove all wires, cables, and bracket from starter, remove the 2 starter bolts, now for the fun part, if the Harley Gods are wearing white suits you may be able to wiggle out starter while sticking out your tounge at a 37 degree angle, if they are wearing black well you might have to either loosen or remove some oil tank mounts to facilitate extraction. Good luck

Posted on Apr 18, 2015

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

wd4ity
  • 4565 Answers

SOURCE: How do you change the transmission oil in a 92

On the right side of the transmission just below the chrome clutch release mechanism cover, there is a small pipe plug that takes a Torx wrench. Remove this plug to drain the transmission. Since this hole is fairly small, it helps to warm the transmission up before draining. Once drained, reinstall the plug, and refill with 20-24 ounces of H-D transmission lube or Amsoil lube. Do not use the new H-D Syn3 20W50 oil as it will make your transmission run noisy.

Posted on Apr 09, 2010

czaa
  • 4514 Answers

SOURCE: 2007 herritage softail wont start

make sure post connections are good n tite--is batt have 12.6volts-test it--a fuse may be blown also--do u hav a repair manual-all mechanix havum

Posted on Jul 05, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Which way does the jackshaft coupling go in a 95 herritage softail


The jackshaft must be installed back onto the starter shaft prior to installing the jackshaft with the shallow side of the coupling going/facing towards the jackshaft and also facingthe jackshaft splines. Remember to reinstall the coupling retaining ring if it was removed. ALSO, be sure to install the coupling on the starter output shaft with the counter bore facing the jackshaft. THEN put the spring inside the coupling and install the pinion gear on the shaft put the lockplate and the thrust washer on the bolt and put the bolt in place in the jackshaft. If you removed the retaining ring put it back on shaft and then slide the jackshaft assembly back into position in the inner primary. In order to hold the lockplate and thrust washer in place be certain that the lockplate tab is properly in the keyway. THEN, having aligned the lockplate tab and thrust washer properly in the slot with the jackshaft keyway screw the jackshaft bolt into the starter shaft and while holding the pinion gear in position tighten the bolt to 84-108 in-lbs (9.5-12.2 Nm) and bend the locking tab against bolt head.

Jun 22, 2014 | Harley Davidson FLSTC Heritage Softail...

1 Answer

REMOVE STARTER SOLENOID 1995 HERITAGE SOFTAIL


The starter silinoid is connected to to starter and can't be replaced with out the starter itself when you buy a new starter it'll come with a new silinoid on it pretty expensive too

May 21, 2014 | 2000 Harley Davidson FLSTC Heritage...

1 Answer

Can you tell me how to fit tyre pressure guage at a garage between spokes of a Harley Davidson Herritage


You can't, i've tried every which way. I just went and bought a shortened pencil style gauge for 3 bucks at a hardware store

Jun 01, 2013 | 2011 Harley Davidson FLSTC Heritage...

1 Answer

How to take a starter off a 1995 Harley Davidson heritage softail


Remove the primary cover. Remove the small bolt at the end of the starter. From the right side of the bike, remove the two bolts holding the starter to the back side of the primary housing. This job is much easier if you remove the oil tank to get at the starter bolts, but I have done it with the oil tank in place, by using long ball allen wrenches. Always replace the locking tabs at the end of the starter when replacing the starter, or removing it from the bike for any reason,

Aug 11, 2012 | 2000 Harley Davidson FLSTC Heritage...

1 Answer

Diagnosing starter problems with 1995 heritage softail classic won't start, charged battery- now no power when I turn ignition on


Hi Anonymous, and the usual suspects are:
1.Ignition/Light Key Switch not in IGNITION position.
2.Engine Stop switch in the OFF position.
3.Discharged battery, loose or corroded connections (solenoid chatters).
4. Bank Angle Sensor tripped and Ignition/Light Key Switch not cycled to Off and then back to Ignition
5. Starter control circuit, relay or solenoid faulty.
6. Electric starter shaft pinion gear not engaging or over-running clutch slipping.

May 06, 2012 | 2000 Harley Davidson FLSTC Heritage...

2 Answers

2007 herritage softail wont start with new battery and new alarm battery....no pwr to starter....this happened all of a sudden


Check you're starter relay. Replace if you think it may be bad. You can check to see if you have voltage going to the relay when you press the start button. I don't have a schematic but you can tell if you check and only have voltage when the start button is pushed. If the voltage is always there, this is not the start button.

Good Luck
Steve

Jul 04, 2011 | Harley Davidson Bullet Classic 500...

1 Answer

How to change the drive belt on 2003 softail springer harley the belt that trunes thr reair tire


To change the final drive belt on your Softail, you must drain the primary and pull the outer primary cover off. Then, you must take the engine sprocket, primary chain, and clutch assembly off. Then you must remove the starter and the inner primary. Then, raise the bike and remove the rear wheel and the swingarm. It's quite a job.

Good Luck
Steve

Mar 20, 2011 | Harley Davidson FLSTS Heritage Springer...

1 Answer

How to remove starter 1995 heritage softail


To remove the starter on you Softail, first disconnect the negative side of the battery.

Then drain the primary and remove any footboards, shifters, ect. so that you can get the outer primary cover off. Once the cover is off, remove the small bolt that holds the starter jackshaft on and remove the jackshaft. The jackshaft coupling may come out with the jackshaft. Mark which way the coupling goes back in as there is a snap ring on the inside that is not in the center.

Now, go to the right side of the bike and remove the exhaust system, and remove the bolts that hold the oil in. Do not take the tank out but you need to be able to lift the tank just a bit. Remove the battery cable from the starter using a 12mm wrench. There are two large bolts that hold the starter into the inner primary, remove these two bolts and unplug the small wire at the top of the solenoid and the starter will come out.

Good Luck
Steve

Feb 07, 2011 | 2000 Harley Davidson FLSTC Heritage...

1 Answer

How do you change the transmission oil in a 92 herritage softail


On the right side of the transmission just below the chrome clutch release mechanism cover, there is a small pipe plug that takes a Torx wrench. Remove this plug to drain the transmission. Since this hole is fairly small, it helps to warm the transmission up before draining. Once drained, reinstall the plug, and refill with 20-24 ounces of H-D transmission lube or Amsoil lube. Do not use the new H-D Syn3 20W50 oil as it will make your transmission run noisy.

Apr 08, 2010 | 2000 Harley Davidson FLSTC Heritage...

Not finding what you are looking for?
1993 Harley Davidson FLSTF Fat boy Logo

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Gills Lango

Level 2 Expert

195 Answers

Mike

Level 3 Expert

4336 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...