Question about Victory V 92 C Motorcycles

1 Answer

My switch is on but have no power on my 2000 v92c

I have a new battery all conections are good all fuses are good but no power to anything not the fuel pump not the lights not the dash could it be the starter diode

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 22 Answers

Most likely

Posted on Apr 14, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
Benimur
  • 6966 Answers

SOURCE: fuel pump won't power up on 94 rf600r

Hi and welcome to FixYa,

On most Suzukis with fuel pump that I have worked on, the wiring would be:

  • Yellow/Green - start interlock, connected to the clutch lever position switch and/or starter control relay;
  • Black/White - ground;
  • Orange/Yellow - ignition B+12; and
  • Black/Yellow - trigger pulse, connected to the - terminal of one of the ignition coils and/or to the CDI/igniter.
Just a start, do postback how things turned up or should you need additional information. Good luck and Thank you for using FixYa.

Posted on Nov 28, 2008

  • 1 Answer

SOURCE: I have a 2000 Honda Shadow 750 ACE. While riding

Take the starter button off and put a 12 volt tester on one of the 4 leads that are wired into the button. Test each- If you find a hot line, take a small piece of wire and jump the current over to the other parrallel button. I worked on my bike for two weeks before I discovered this problem. Another problem was that the headlight would not come on. The starter would not crank at all. I took a screw driver and raised the brass leads on the switch so they would make contact and put the switch back together, and it worked. Good luck.

tim reynolds

Posted on Jul 31, 2009

  • 55 Answers

SOURCE: No start or turn over. Battery registers 13 volts. Stopped for

Its a bad earth between battery and chassis or starter and chassis

Posted on Sep 12, 2009

Testimonial: "bournetoride: Your suggestion on earth was excellent. Turns out battery could not pass a load test. No prior indication of failure. "

  • 921 Answers

SOURCE: 1997 Suzuki TL1000S - no electrical power at all.

check kill switch circuitry its located near the start button asembly.

Posted on Oct 04, 2009

Woods Goat
  • 85 Answers

SOURCE: Getting no power to nothing. Battery good. starter relay

I don't think it's your relay, if you've got power to nothing.Unless it is somehow shorting to the frame.

Likely candidate is the key switch itself. Check the wire that feeds the switch from the battery. If it doesn't have power, you likely have a broken wire or hidden fuse.

If it's got power check the other wires coming from the switch for power with the switch on. If no power there, the switch is bad.

*Help me out. Rate me!

Posted on Jun 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fitted a new fan radiator switch on my fiat X19 but still does not allow fan to come on , tested fan on its own it's working fine. Could b my wiring, as I connected a power cable from battery to switch...


use power lead from battery fused conect to + lead of fan conect negetive lead of fan to heatsensor located on engine or radiator fan will switch on at opperating temp

Dec 17, 2013 | Lincoln Mark VIII Cars & Trucks

1 Answer

2000 1.8t passat will not start


Nice descriptive statement. Too bad it can't be flushed and forgotten!

Some testing will have to be done to find all the problems. A new battery and starter is a good start. It will make finding the no crank problem a lot simpler and hopefully not expensive. You could check for power to the starter solenoid when key is held in cranking position. If you have power there, check grounds and battery and starter cable connections-starter is not getting power from the battery. If no power on the solenoid wire, you will have to trace the path from the ignition switch to the solenoid to find the problem. I hope you have a wiring diagram for the start circuit, You said you checked fuses. Did you check if they all have power with key on? Something like a fusible link (if your car has them) could blow out and cut power to fused circuits.
Well, good luck. Post back if you find anything or need more help "polishing".

Jun 12, 2012 | 2000 Volkswagen Passat 4Motion

1 Answer

I have a 2000 Nissan Altima GXE, have changed altenator and left battery unhooked for 24 hrs. Now I can not keep car running, donot have inside working lights or anything to do with the power system...


the battery should be dead by the way you describe it...so just jump start the car from another car...if that doesn't work then you might need a new battery if the battery is too old...like 4-5 years old...
Good Luck!

Oct 13, 2010 | Nissan Altima Cars & Trucks

3 Answers

2000 xterra wont crank. just a click when i try to crank. new starter batt is good. ??????


check your postive and neg,cables to the starter ,if there is alot of corrision on the wires you wont get a good signal

Sep 20, 2010 | 2006 Nissan Xterra

1 Answer

Car has no power, however the battery and alternator are brand new


MOST TIME BATTERY CABLES WORN OR CORRODED CAUSING POOR GROUND PROBLEMS IF BATTERY CABLES GOOD .IF DASH LIGHTS DONT COME ON WHEN IGNITION KEY TURNED ON CHECK IGNITION FUSE.IF FUSE GOOD YOU COULD HAVE A FAULTY IGNITION SWITCH.

Sep 03, 2010 | 2000 Daewoo Lanos

1 Answer

I need to know what wires are what in my dash for my radio in my 2000 grand prix please nothing is labeled like it should be for example it says red wire is accessory I dont have a red wire the closest...


first things first check your fuses and i mean all of them replace all that are bad with proper fuse amprages

you are going to have to do some probing of those wires to find the ones you need you can buy a voltmeter(25$ or less) or a simple test light(2-5$) from a local automotive store

colors to look for are
primary power wires :red,yellow, black for ground
accsesory wire from igntion ,orange or blue with wite stripe and posibly pink(rare)

any wire that has an on and off state from the turn key igntion can be used depending on its gauge/size test the orange one first as this is the most common color to use for the accsesories wire
to test you have the igntion in the on postion if you get a readying of +12 volt and then turn the igntion of and recive a reading of 0 volts this would be an on off wire
note: check the auxsilary postion of the turn key igntion also if there is no power to the wire in the auxzilary postion it is the incorect wire for the radio

BLACK> should be a ground wire
RED>should be an igntion supply wire of a larger diameter
YELLOW> should be a battery supply lead strait from the fuse box battery conection "always on"connect the wire of the stereo labeld battery to the always on battery lead ,this is for the memory function of the radio

ORANGE>(may be pink only seen pink in buick's) should be an on/off wire from the igntion and used for the main power of the radio so it is shut of when the car is turnt of this is also the wire you would hook the amplifyer on off up to if the radio dont supply the blue wire with white stripe aka ant/motor
test the on off state of the wire befor conecting it to the radio
you will conect the red (+ positive) wire to this on/off state wire

cation! disconect the batery ground wire when conecting anything to the main yellow battery wire as it is directly conected thru an exspensive(12$) 30 amp fuse

if you dont know what wires are what for the speakers in the car use a 9 volt batery to find the speaker wire leads (ues a brand new 9 volt)
ntsc standard color pairs are
white and grey front
green & brown for back
i dont remeber the left and right
the black stripe on the speaker leads means the ground or negative side of the speaker
good luck instaling your new radio hope i have helped you out

Feb 24, 2010 | 2000 Pontiac Grand Prix

1 Answer

I have a 2000 Cadillac DeVille and the front passenger side power doorlock isn't working. Would it have anything to do with a fuse being blown? It's just the one door.


take the door trim off and remove the motor and press the button to open if the wires are still good and the conections are clean and it dosnt work still than will need replacing

Oct 29, 2009 | 2000 Cadillac DeVille

1 Answer

2005 chevy 2500 brake lights wont work


Just to be sure you checked fuses underhood? There is a junction block at rear of truck on frame it can cause lights to not work check it to make sure all conections are tight.also check the trailer hook up for brake light power as this is on a seperate cicuit but is supplied by brake switch.If you have power there it will eliminate switch.your fuse box has a brake fuse and trailer brake fuse

Dec 08, 2008 | 2000 Chevrolet 2500

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

90 people viewed this question

Ask a Question

Usually answered in minutes!

Top Victory Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers

Joseph Hoffmann

Level 3 Expert

1702 Answers

Are you a Victory Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...