Question about 2008 Qlink Legacy 250

Open Question

Clutch Belt broke while riding, I replaced the belt. Now every time I go to throttle up to go, the bike stalls. It runs fine while idleing, but will not move. Is this a clutch problem or is there some way the belt could not be on right?

Posted by Anonymous on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 42798 Answers

SOURCE: engine runs and idles but wont rev up all engine dies??

check for blockage in main jet as there is no fuel getting to the emulsion tube to mix with the air.

Posted on Jul 29, 2013

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Kawasaki 450r


I had a similar problem on one of my bikes. Turned out a "Test Port" had rattled loose between the carb and the intake. I threaded a screw in the hole to prevent the leak and problem was resolved.

Apr 02, 2014 | K and N Kawasaki Kfx450 Kfx450r K and n...

1 Answer

Starts stalls


contaminated or water in the fuel is most likely the culprit here.
drain the tank and carb (small screw at bottom of carb float bowl)
Add fresh fuel from a CLEAN fuel source. Best to completely drain your fuel can and fill it up with fresh fuel. That way if the fuel can is the culprit you eliminated doing this twice.
What happened was fuel sits on top of water, this is why the bike would still idle. The idle circuit in the carb pulls fuel from a higher point than the main jet. This is also why when you hit the throttle it would just die, it was sucking most like something other than fuel.

Apr 02, 2014 | kawasaki KX 450 F Motorcycles

1 Answer

2005 caravan stalls when at stoping


Check the compression, all cylinders should be about 125 lbs, If some are off you may have bent some valves when the timing belt broke, the pistons
will hit the valves & bend them, If so, it is best to replace the head
I did this before no fun.
Good luck.

Feb 22, 2012 | 2005 Dodge Caravan

1 Answer

Bought the Bike Used from a HD Dealer 2004 XL1200C Sportster. 2400 Miles 2nd time I took the Bike for a ride It was Slamming into Gears Very Loudly, Had the Clutch adjusted and Gasket Replaced, Next Time...


check for the pinched vacuum line at the carb,, sportys are hard to locate because they are tucked in way behind , it ay have come disconnected, unless there is a load on the motor it will idle fine, add a little load and you get the feeling no fuel is getting through unless you rev it up

Jul 01, 2011 | Harley Davidson XL 1200 C Sportster Custom...

2 Answers

1983 honda gold wing 1100 ,120,000 klm,runs great .When should one be doing a clutch change?


If you go easy on the clutch and do not pull a trailer, you may never have to replace the clutch. My GL1000 clutch has over 150,000 Miles (around 240,000 km) on it and works just fine

May 09, 2011 | 1983 Honda GL 1100 Innerstate Gold Wing

1 Answer

No start fuel ok spark ok


throttle position sensor,and crankshaft position sensor.

May 03, 2010 | 2004 Chevrolet Aveo

2 Answers

Engine stalls when put into first.No slack on clutch cable. Bike not used regularly.


check your idle speed.you should have about 1 cm of free play in the lever.also does it start up agian and are you able to drive it if not check your side stand switch

Oct 18, 2009 | 1994 Yamaha XV 535 Virago DX

2 Answers

1996 dodge stratus stalls upon stopping and imediate starting.


Hi I am Vortash sounds like an inlet manifold air leak or check the ignition leads they could be sparking out to earth , or possibly the choke is stuck on or filter needs changing restricting air flow .. Hope this is of help regards Vortash

Apr 12, 2009 | 1996 Dodge Stratus

2 Answers

Rough and noisy idle


i have a 2000 kia sportage the timing belt broke and the 2.0 is a zero clearance motor.you need to find out if it bent the valves.it did in mine.

Aug 24, 2008 | 2000 Kia Sportage

Not finding what you are looking for?
2008 Qlink Legacy 250 Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Qlink Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4525 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers

yadayada
yadayada

Level 3 Expert

76164 Answers

Are you a Qlink Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...