Question about Triumph Sprint GT Motorcycles

1 Answer

Loss of all complete power on 2011 Sprint GT

Tried installing headlight modulator, now have lost all power

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

Check your fuses, it sounds like you shorted something to ground.

Posted on Apr 18, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2011 Triumph Sprint GT high idle


Hey Graham..
Have you had it tuned up lately...if you had the valves adjusted, the intake valves are too tight...if no one has been adjusting your valves.. you might have an air leak..??
Does the engine rpm's "kinda float" around for a few seconds..idling high then settle back to normal..? .. YES. then its a classic symptoms of too tight intake valves.

Jun 28, 2017 | 2012 Triumph Sprint GT

1 Answer

While driving on the interstate, my 2011 Mustang GT suffered a complete electrical shut down. The car died and nothing electrical will work. Twelve hours later i still do not have any electrical powe


ck the back of your alternator , ck the wires , also the same for the starter sounds like a wire broke of or shorted out , look good you will find it or your alterantor went bad and will kill the battery for sure , ck that too,

Dec 15, 2014 | 2011 Ford Mustang GT

1 Answer

2011 chevy traverse u0073 and numerous comm codes and vehicle loses power while driving


u0073 and other codes are an intermittent loss of communication with the body control module ,,,your speedometer and gages will stop working and the transmission will go into a defalt mode with a loss of power,, dealer will have to diagnose the loss of high speed communications between modules

If you need further help, I’m available over the phone at https://www.6ya.com/expert/thomas_9f23c57b7a2fc8ff

Oct 16, 2014 | Vehicle Parts & Accessories

1 Answer

Triumph Sprint GT complete loss of all power


Hi, Anonymous before testing any electrical component in the Starting System it is "IMPERATIVE" that you have a fully charged battery of 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a preliminary reading of 12.5 volts or more but little or zero amperage, the battery is faulty and must be replaced. AGM type batteries fall into this scenario more so than lead acid batteries.
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter.
4. Bank angle sensor needs a reset or is faulty.
5. FOB battery low or dead.
6. Faulty ignition switch.
7. Faulty starter button.
8. Faulty kickstand, clutch, neutral safety switch.
9. Security alarm needs a reset.
10. Starter relay, solenoid, starter motor or circuit wiring faulty.
11. Starter armature or field coils have failed.
12. Main fuse or circuit breaker may be blown or faulty.
13. Faulty ignition relay.
14. The electric starter is working but starter clutch has failed.
15. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Sudden total temporary electrical failure
K11 Owners Group View topic TOTAL loss of all electrical power
Triumph Sprint ST Service Manual
https://www.triumphestore.com/Triumph_2013_Sprint--GT.html
Triumph Sprint ST Owner Handbook Manual

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Aug 29, 2017 | Triumph Sprint GT Motorcycles

1 Answer

Tried to install a headlight modulator in a 2011 Triumph Sprint GT. now I have no power whatsoever, battery drained replaced with a new battery and still no horn, lights, or power


It sounds like another fuse is blown or possibly a relay. Check all of them, if none are bad, then make sure your battery cables are good, use a test light to check them. Its more then likely a bad relay though. Good luck !

Apr 13, 2014 | Motorcycles

2 Answers

Reset oil light 2011 jeep gand cherokee


Turn key to on position(do not start). Hit gas pedal completely to floor 3 times. Change oil light should reset.

Jul 25, 2012 | 2011 Jeep Grand Cherokee

1 Answer

Front driver door has no power, I have checked the fuses but no controls will work


This is a manufactures bulletin


SUBJECT:
Inoperative Right Front Door Switches OVERVIEW:
This bulletin involves replacing the right door interior handle. The loss of ALL functions may occur when attempting to control them from any of the switches located on the right door due to electrostatic discharge through the right door interior handle. The right door interior handle must be replaced to protect the switch module from static electricity. The new handle is more resistant to electrostatic discharge. MODELS:
2004 - 2008 (CS) Pacifica SYMPTOM/CONDITION:
The vehicle operator may experience a permanent loss in ability to actuate ALL of the following functions from the right door switches: ^ Power door locks. ^ Right power mirror. ^ Right power seat adjustments. ^ Right power window control. ^ Right heated mirrors. ^ Memory functions associated with the listed systems on right side (if applicable). ^ Loss of communication with the right door switch module to Scan Tool: DIAGNOSIS:
Perform a "Hard Reset of the right door switch module. This may be accomplished by removing all power (including memory keep alive power) from the right door switch module by unplugging the module power connector. Alternatively, vehicle power may be interrupted by removing the negative battery terminal when the ignition switch is in the OFF position. If after performing the hard reset functions of the right door switches return perform the Repair Procedure.
dak408_79.gif

PARTS REQUIRED:
REPAIR PROCEDURE:
1. Disconnect the negative battery cable. 2. Remove the right door trim paneldak408_80.gif
3. Remove the door tweeter speaker. Refer to the service information in TechCONNECT. Refer to 8 - Electrical > Audio > Speaker > Removal (Fig 1). 4. Remove the power seat switch. Refer to the service information in TechCONNECT. Refer to 8 - Electrical > Power Seats > right Seat Switch > Removal. 5. Replace the right door interior handle, p/n 05170261AA, as described on Mopar Instruction Sheet K6855628 included in the handle kit. 6. Install the power seat switch. 7. Install the door tweeter speaker. 8. Install the right door trim panel. 9. Connect the negative battery cable.

Nov 25, 2010 | 2006 Chrysler Pacifica

1 Answer

Sprint Smartview Software won't load on a Dell Laptop


you can download and install the software off sprint.com/downloads and pick your device and install it directly off there

Oct 06, 2009 | Sierra Wireless 598U USB Modem

2 Answers

Headlights work intermitently


HI,Inspect the #27 fuse holder of the Central Junction Box (CJB) for a questionable contact issue with the male spade of the fuse, which may cause intermittent loss of contact.if ok sounds like you need lcm= light control module.

Sep 30, 2009 | 2003 Mercury Grand Marquis

1 Answer

Tried to install Sprint wireless card on computer


Try restarting computer and as you see anything on the screen, start tapping F8 key. This will take you to Safe Mode and will not load many drivers including the Sprint card. I'd go to Control Panel >Programs/Features(or Add or Remove programs if you're running XP) and uninstall the Sprint app. Restart the computer and it should come up normally. Then call Sprint Tech Support for help.

Jul 30, 2009 | Acer Computers & Internet

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

87 people viewed this question

Ask a Question

Usually answered in minutes!

Top Triumph Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4995 Answers

yadayada
yadayada

Level 3 Expert

80637 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Triumph Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...