Question about 2005 Bajaj CT 100

1 Answer

Signal light not working

Posted by Anonymous on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Bajaj Master
  • 40,698 Answers

Hi Anonymous, before diagnosing any turn signal issue make sure the bulb is good and the light fuse has continuity with a test light. If no turn signals work the cause could be a faulty turn signal module or the connector going to it, look for corroded, loose, or broken pins/sockets. Contact spray cleaner is great for removing corrosion. If your speedometer does not function properly it will have to be fixed first because your turn signal module gets the data from the speedometer for normal turn signal function. If your front turn signals don't work use a test light to check for power and ground at the bulb socket, then start backtracking the wiring through every wire connector to the turn signal switch/button and check for continuity, go all the way back to the fuse if necessary to find the cause of the malfunction. If your rear turn signals don't work check your rear fender wiring harness connector first for corroded, broken, loose pins/sockets, power, and a good ground, (the harness connector is usually located under the seat on the front of the rear fender) then keep tracing the wiring look for obvious harness damage caused by the rear tire. If you still can't find the malfunction backtrack from the rear fender wiring harness connector. If one side does not work you could have a faulty turn signal switch or module check for continuity. For more information about your issue, please visit the websites below. Good luck and have a nice day. Fix scooter that does not have working turn signals
EZ Fast Blink Fix on Motorcycle Turn Signal Relay Installation
DOWNLOAD BAJAJ CT 100 SERVICE MANUAL
http://www.marutibajaj.com/pdf/ct100.pdf
Bajaj Auto Ct 100 2015 User Manual

Posted on Nov 28, 2015

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Brake light trouble right side brake light will not come on but both flashers work also turn signals work older ford truck what could the problem


I have to think the problem is inside the turn signal switch, a poor internal connection. You know the brake signal first goes through the turn switch before it goes to the bulbs. That is why the brake lights and rear turn signal lights share the same filament in the bulb, and the same wire going to those lights. The only difference is the turning side light is affected by the turn signal flasher, causing blinking, while the other side- the non turning side-does not go through the flasher relay, but straight to the bulb from the turn signal switch. Change your turn signal switch and I believe you will solve the problem. Let me know, okay?

Sep 16, 2015 | Ford Cars & Trucks

2 Answers

69 turn signal problem left turn signal not working. right turn signal causes both to falsh


it's the grounds if they're both flashing fast it's definitely grounds take a test light and see if its got power goes through the test light grounded to the frame and if the light comes on then it's definitely your grounds

Jul 29, 2014 | 1969 Pontiac Firebird

1 Answer

Rear turn signals


Often LEDs have difference electrical tolerances and are not compatible with other systems without special adapters to balance conductivity etc.

Jun 22, 2014 | 2003 Harley Davidson FXST Softail Standard

1 Answer

Turn signal not working


TAIL LIGHT NOT WORKING

It can be faulty tail light bulb or its issue with tail light control switch or its wiring's are short.

Check the voltage at fuse slot of tail light.Do you receive 12 volt there.If not,then it says tail light switch is not receiving power supply.


---------

There are few help links related to your problem.I suggest you refer the list and check the help links.Click the link below:-----




Turn Signal Not working

http://technoanswers.blogspot.com/2012/11/turn-signal-not-working.html

----------

Right turn signal not working on Pontiac Car?

http://schematicsdiagram.blogspot.com/2011/12/right-turn-signal-not-working-on.html

--------

Only one side indicator light working on car?

http://schematicsdiagram.blogspot.com/2011/12/only-one-side-indicator-light-working.html

-----------

Turn signals not working on 1987 Jeep Wagoneer?

http://schematicsdiagram.blogspot.com/2011/12/turn-signals-not-working-on-1987-jeep.html

-----------

SOLVE YOUR 4 WAY FLASHER RELATED PROBLEMS HERE

http://repairhelpcenter.blogspot.com/2012/11/4-way-flasherturn-signal-flashersignal.html

----------

1994 Toyota Camry: Bypass Tail light Relay Circuit?

http://whatisbyme.blogspot.in/2012/04/1994-toyota-camry-bypass-tail-light.html

-----------

2008 Toyota RAV4: Replace Tail light Lens Cover?


http://technoanswers.blogspot.in/2012/04/2008-toyota-rav4-replace-tail-light.html

--------

2003 Chevrolet S10 Tail light Fuse

http://schematicsdiagram.blogspot.com/2012/11/2003-chevrolet-s10-tail-light-fuse.html

---------

Chevrolet Parking light and Tail lamp light Wiring diagram

http://schematicsdiagram.blogspot.com/2012/11/chevrolet-parking-light-and-tail-lamp.html

----------

Car Tail Lights Not Working?

http://schematicsdiagram.blogspot.com/2011/12/car-tail-lights-not-working.html

----------

These details will help.

Thanks.

Feb 15, 2013 | 2004 Pontiac Grand Am

1 Answer

Turn signal,brake lights not working


I would check for voltage at the turn signal switch. The brake lights go thru the turn signal switch, except for the high mount light.

Jul 24, 2012 | Cars & Trucks

2 Answers

95' Buick regal, 3rd brake light works, tail lights work, turn signals work, stoplight switch seems to work ie 3rd brake light working, fuse is ok, changed bulbs, but no rear brake lights.


If the third brake light works and the regular ones don't, it is most likely a bad turn signal (multifunction) switch. The switch is able to kill the brakes lights to run the turn signals, and in rare circumstances does this. I've seen it several times. It could also be wiring, especially near the turn signal switch, but it is usually the switch.

Nov 25, 2009 | 1995 Buick Regal

1 Answer

Left turn signal beeps very fast and signal light not working, now is working fine and so is signal light


When your turn signal goes out it tends to blink VERY rapidly before burning out, It's a nice way to let you know before hand that you need to replace the bulb soon.

Apr 27, 2009 | 2005 Hyundai Elantra

Not finding what you are looking for?
2005 Bajaj CT 100 Logo

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Bajaj Experts

sachin sharma
sachin sharma

Level 2 Expert

171 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Joseph Gallucci

Level 2 Expert

120 Answers

Are you a Bajaj Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...