Question about 2008 Triumph Street triple

1 Answer

I have a 08' triumph street triple. Just installed a Clear Alternatives integrated tail light / signal combo. and a ERMAX undertail with integrated signals. Connected all and have 20W 5 ohm resistors placed to control the flash rate. Each side was wired and confirmed function before final wiring. After completion all lights and signal functioned as they are suppose to, but the engine wont start. The gauges work and the fuel pump starts but when you attempt to start the engine you hear a single click at one of the connectors in the subframe where the 30 amp fuse is located. Fuse is good. Went to the dealer service center for advice and was told to use my car battery with engine off to try and start the bike. This was to rule out that the bike battery was lacking charge to start the bike. Now there is no electrical power after I connected the batteries. ( blk to blk and red to red) . Cables were connected correctly. Please help

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 95 Answers

It is very technical problem, as the battery concerned and the power fuse.so ill post a forum which only deals with the triumph rat motorcycle.they have the perfect teams for supporting and repairing service.

just post the problem ,the super moderators responsible for triumph motorcycle repairing and maintenance.

http://www.triumphrat.net/maintenance-and-workshop-talk/

just register in the website for free and post your problems,we guide you in right direction instead of guiding you in wrong side.thanks for using fixya.
if yo like my suggestion kindly rate me.

Posted on Jun 17, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2016 Triumph Street Triple R instrument settings


Hi, Anonymous for this scenario you will need your service/owners manual if you can't find the best tool you ever bought for your Triumph, despair not, for a mere $18 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
2017 Triumph Street Triple 765 Lineup Fast Facts RS
Dash Menu Run Through New Triumph Street Triple 2013
Triumph Motorcycle Speed Triple 2011 2016 Service Manual Download Manuals... $18
http://www.triumphestore.com/
Triumph Motorcycles

Jul 04, 2017 | 2016 Triumph Street Triple R

1 Answer

2016 triumph street triple 675 rx i want odometer to stay on


Hi, Matt for this scenario you will need your service, parts fiche, and owners manual if you can't find the best tool you ever bought for your Triumph, despair not, for a mere zero $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Odometer while running
Dash Menu Run Through New Triumph Street Triple 2013
http://torrkish.com/triumph/Workshop%20Manual.pdf
http://www.bikebandit.com/oem-parts/2016-triumph-street-triple-rx/o/m158183
Triumph Speed Triple Handbook

Jul 04, 2017 | 2013 Triumph Street Triple

1 Answer

I have 2008 Triumph Street Triple 675. I'm trying to install a new speed sensor?


But you do not say what the issue is, you just say im trying to install a new sensor. what is the problem why you cannot, ????

Jan 20, 2015 | 2008 Triumph Street triple

1 Answer

My Triumph Street Triple displayed the ECU malfunction light after a flat battery which has since been satisfactorily charged. How can I reset the ECU so my bike doesn't remain in limp home mo


You could try the 12 minute tune which I think is appl;icable to this model.This resets most issues.
Start the bike from cold...do not touch throttle then wait til fan comes on then time 12 minutes exactly then turn bike off.If this dont work go to a dealer so they can plug into the ECU and find out the cause..

Sep 17, 2014 | 2013 Triumph Street Triple

1 Answer

Why dose my bike Triumph Street Tripple R 2010 has issue with the white wire heating up connecting from ignition to connector?Resulting in no power nor display on the pannel. But when I play with the


Check owner manule for the correct fuse size that must be installed in the fuse box for your power relay for your head light if this is correct one it must be a earth leak near head light check all earth points on your bike tighten or replace where needed

May 13, 2014 | 2010 Triumph Street Triple R

1 Answer

Is there a manual for the street triple r 2011


http://www.triumph.co.uk/media/Daytona_675_OHB_UK%281%29.pdf

Jan 07, 2013 | 2011 Triumph Street Triple

1 Answer

2008 Triumph Street Triple won't start


Hi, Cbitt331 before testing any electrical component in the Starting System it is "IMPERATIVE" that you have a fully charged battery of 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a preliminary reading of 12.5 volts or more but little or zero amperage, the battery is faulty and must be replaced. AGM type batteries fall into this scenario more so than lead acid batteries.
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter.
4. Bank angle sensor needs a reset or is faulty.
5. FOB battery low or dead.
6. Faulty ignition switch.
7. Faulty starter button.
8. Faulty kickstand, clutch, neutral safety switch.
9. Security alarm needs a reset.
10. Starter relay, solenoid, starter have failed or circuit wiring faulty.
11. Starter armature or field coils have failed.
12. Main fuse or circuit breaker may be blown or faulty.
13. The electric starter is working but starter clutch has failed.
14. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
ST3R won start HELP
What to do When Your Motorcycle Won Start
Triumph DAYTONA 675 Service Manual
http://www.triumphestore.com/
Triumph Daytona 675 Owner Handbook Manual

Jun 16, 2017 | 2008 Triumph Street triple

1 Answer

I have replaced the stock tail light assembly with


i dont know alot about this but my best gess is you have a bad ground check and make sure you have a good solid connection. hope this helps you.

Jan 03, 2010 | 2008 Triumph Triumph Bonneville

Not finding what you are looking for?
2008 Triumph Street triple Logo

Related Topics:

130 people viewed this question

Ask a Question

Usually answered in minutes!

Top Triumph Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Triumph Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...