Question about 1989 Yamaha XV 535 Virago DX

1 Answer

94 yamaha 535 virago sounds fine, just wont start

Had starter rebuilt. Went back and had starter clutch in the motor replaced. Replaced spark plug and battery. Sounds clean when you press the auto starter, but it just wont fire. HELP!!!

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 64 Answers

Check to make sure your getting gas by pulling off the hose, if no gas comes out your petcock is clogged. If this is the case blow air up into the hose, and if gas comes out now your tank has to be cleaned out.

Posted on Jun 23, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1994 Yamaha XV 535 Virago DX will not start


Hi, Jen before testing any electrical component in the Starter Circuit it is "IMPERATIVE" that you have a fully charged battery of 12.5 volts or more and be able to pass a proper "LOAD" test because your battery may have 12.5 volts or more but little or zero amps causing the battery to be faulty and must be replaced, especially "AGM" batteries.
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter.
4. Bank angle sensor needs a reset or is faulty.
5. FOB battery low or dead.
6. Faulty ignition switch.
7. Faulty starter button.
8. Faulty kickstand or clutch pull in switch/sensor.
9. Security alarm needs a reset.
10. Starter relay, solenoid, starter have failed or circuit wiring faulty.
11. Starter armature or field coils have failed.
12. Main fuse or circuit breaker may be blown or faulty.
13. The electric starter is working but starter clutch has failed.
14. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
1987 Virago will not start
What to do When Your Motorcycle Won Start
Yamaha XV 535 DX Virago Service Manual
OEM parts for Yamaha
Yamaha 1994 XV535F Owner Manual

May 10, 2017 | 1994 Yamaha XV 535 Virago DX

1 Answer

'94 Virago 535 Hair line crack on starter clutch


you can if you can take off the side case ! b4 you re fit make sure the fasure is still flat as you mite get a little distortion ! get a good flat surface ie glass and a large piece of wet n dry paper , wet with water and place cover on and press on gently and push n a rotating motion and check all parts of gasket face has a nice clean finnish ! P...

Dec 02, 2013 | Yamaha Motorcycles

1 Answer

Can you weld on a starter clutch '94 virago 535


Hi, Anonymous absolutely if done by a professional that knows how to properly quench the metal to keep its hardness for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Yamaha, despair not, for a mere $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
Yamaha XV 535 DX Virago Service Manual
OEM parts for Yamaha
http://www.starmotorcycles.com/assets/service/manuals/2000/LIT-11626-13-16_110.pdf
Yamaha XV 535 Virago Low Bars 88
Tips Tricks

Dec 02, 2013 | 1994 Yamaha XV 535 Virago DX

1 Answer

1994 Virago 535 wont start, and the headlight wont turn on?


Hi, Anonymous and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, needs to be 12.5 volts or better and be able to pass a load test if necessary, check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Bank angle sensor tripped and ignition/light key switch not cycled to the "OFF" position and then back to the "ON" position.
5. Faulty ignition switch.
6. Faulty starter button.
7. Faulty kickstand or clutch pull in switch/sensor.
8. Security alarm needs a reset.
9. Starter control circuit, relay, or solenoid faulty.
10. Main fuse or circuit breaker may be blown or faulty.
11. Electric starter shaft pinion gear is not engaging or over-running starter clutch slipping.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
1987 Virago will not start
XV535 Won start
Yamaha XV 535 DX Virago Service Manual
OEM parts for Yamaha
http://www.starmotorcycles.com/assets/service/manuals/2000/LIT-11626-13-16_110.pdf

Jun 08, 2013 | 1988 Yamaha XV 535 Virago DX

1 Answer

Starter engages while the motor is running


Hi, William the starter drive/Bendix/clutch is a mechanical gear driven component that engages the clutch pack ring gear to turn over the engine. It has an internal mechanism that allows the gear to turn in one direction and once the engine starts allows the drive gear to free spin. If gear free spins in both directions then the drive gear has failed, it is not serviceable and needs to be replaced. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
94 XV535 starter problem
work around For Yamaha Virago Starter Clutch Problems
Yamaha XV 535 DX Virago Service Manual
OEM parts for Yamaha
http://www.starmotorcycles.com/assets/service/manuals/2000/LIT-11626-13-16_110.pdf

Mar 28, 2013 | 1994 Yamaha XV 535 Virago DX

1 Answer

I have a virago 535 when i go to start it the starter just spin`s pop it in to gear pull back a couple times an then it will catch to start ..help what do i need to do


Hi, Jamie557255 the starter drive/Bendix/clutch is a mechanical gear driven component that engages the clutch pack ring gear to turn over the engine. It has an internal mechanism that allows the gear to turn in one direction and once the engine starts allows the drive gear to free spin. If gear free spins in both directions then the drive gear has failed, it is not serviceable and needs to be replaced. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
94 XV535 starter problem
VX535 starter clutch install 1of 5
Yamaha XV 535 DX Virago Service Manual
OEM parts for Yamaha
http://www.starmotorcycles.com/assets/service/manuals/2005/LIT-11626-18-21_1000.pdf

Sep 12, 2011 | 1997 Yamaha XV 535 Virago DX

2 Answers

Startr not working when i start pushing start button


Chk clutch safety switch, Kickstand safety switch anf emergency shut down switch,

Jul 01, 2009 | 1988 Yamaha XV 535 Virago DX

2 Answers

Starting problem


your camshaft is out of time with the crankshaft allowing the valves to stay open when they should be closed causing the popping sound

May 20, 2009 | 1995 Yamaha XV 535 Virago DX

1 Answer

I was riding my '94 Virago 535 when it made a loud whirring sound then the bike stalled and I was unable to start the bike again. When I press the starter button nothing happens except the headlight goes...


Yes, the starter clutches sometimes get stuck on those bikes.
Then the starter turns at very high speeds and get broken.
Remove the starter from the engine ( that's an easy job )
Hold the starter in a bankwrench and connect a 12V battery to it. If the starter turns, he is OK, if not, replace the starter and his clutch system.

Mar 30, 2009 | 1994 Yamaha XV 535 Virago DX

Not finding what you are looking for?
1989 Yamaha XV 535 Virago DX Logo

605 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...