Question about 2010 Keeway TX125 Supermotard

Open Question

How to change a clutch lever on a keeway

How to change the clutch lever

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My keeway superlight wont start , it turns over but just wont kick in any ideas?


Hi, Anonymous and the usual suspects are:
1. Fuel tank empty.
2. The fuel tank has old dead gas.
3. Fuel tank bottom contaminated with ethanol sludge, dirt, water, rust, etc.
4. Fuel supply valve/petcock turned off.
5. Fouled spark plugs.
6. Engine flooded as a result of overuse of the enrichner.
7. Vacuum hose to the fuel supply valve/petcock disconnected, broken, cracked, or pinched.
8. Fuel valve/petcock or filter clogged.
9. Fuel line to carburetor or throttle body pinched, kinked or blocked.
10. Carburetor float stuck.
11. Fuel injectors clogged.
12. Fuel injectors stuck open.
13. Severely discharged or a damaged battery should have 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a cursory reading of 12.5 volts or more but little or zero amperage the battery is faulty and must be replaced, AGM batteries fail in this scenario more so than lead acid batteries.
14. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
15. Loose or corroded wire connection at the coil or plug between ignition sensor and ECM module.
16. Spark plug cables in bad condition and shorting check for spark leakage in the dark, cable connections loose, or connected to the wrong cylinders.
17. Ignition timing incorrect due to a faulty ignition coil, ignition module or MAP, CMP, CKP, O2, TPS, ETP, IAC sensors.
18. Faulty neutral, clutch lever, or kickstand safety switch.
19. Faulty fuel pump or fuse or relay.
20. A stuck bent or burnt valve.
21. Tilt sensor needs a reset.
22. Security system not disarming alarm needs a reset.
23. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Basic chinese bike troubleshooting guide
Scooter Troubleshooting Scooter won start All about Scooters
KEEWAY SUPERLIGHT 125 150 SCOOTER SERVICE REPAIR PDF MANUAL DOWNLOAD 2006... $12
Keewayparts com Genuine Keeway Parts Shipped Worldwide
KEEWAY Speed 125 User Manual

Jun 30, 2017 | Keeway Motorcycles

1 Answer

Keeway Superlight knocking noise from engine


Hi, Killian I would love to help you with your engine or chassis noise but I just loaned my brand new pair of listening ears to your local dealer's chief technician so he could take your bike for a test ride and give you his professional opinion and estimate about your noise and repair cost. If you are a little short on "DRACHMA" and a Dealership is not on your list of fun places to visit then perhaps the list below will help soothe your worried mind so you can make an informed decision.
1. Bearings---SCREECH
2. Belts---CHIRP
3. Brake Rotors---BUZZ
4. Chains---RATTLE
5. Clutches---CHATTER
6. Cylinders---PING
7. Fronk Forks---Plunk
8. Gears---WHINE
9. Head Gasket---HISS
10. Hydraulic Lifters---TAP
11. Pistons---SLAP
12. Rear Shocks---SQUEAK
13. Shifting Trans---CLUNK
14. Solid Lifters---TICK
15. Starters---CLICK
16. Connecting Rods Go---KNOCK-KNOCK---who's there, it's me "*****"
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Performance Scooter Tuning Maintenance Repair
How to diagnose problem by the noises your bike makes
KEEWAY SUPERLIGHT 125 150 SCOOTER SERVICE REPAIR MANUAL 2006 2012 Download... $10 cheap
Keeway Superlight 200 Parts Catalog pdf
KEEWAY Speed 125 User Manual

Apr 23, 2017 | Keeway Motorcycles

1 Answer

Keeway dorado 250cc motorbike,i did change the fuse wire/modified using wire.now having problem with no power at all..cant start ..battery & fuse look working..any issue related or how to fix this?


Hi, Mustafa and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, needs to be 12.5 volts or better and be able to pass a "LOAD" test, your battery may show 12.5 volts but has little or zero amps and must be replaced.
4. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter.
5. Bank angle sensor needs a reset or is faulty.
6. FOB battery low or dead.
7. Faulty ignition switch.
8. Faulty starter button.
9. Faulty kickstand or clutch pull in switch/sensor.
10. Security alarm needs a reset.
11. Starter relay, solenoid or starter circuit wiring faulty.
12. Starter armature or field coils have failed.
13. Main fuse or circuit breaker may be blown or faulty.
14. The electric starter is working but starter clutch has failed.
15. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Yamaha Vstar 250 won start need to diagnose and fix possible fuel battery...
cranks but wont start
http://www.benelli.keeway.my/image/post/manual/dorado.pdf
https://www.aliexpress.com/store/group/Stock-Parts-2V49FMM-XV250-Keeway-Cruiser-Dorado/436449_252868059.html

Mar 25, 2017 | Keeway Motorcycles

1 Answer

My keeway matrix 70cc wont climb uphill even though i have 21mm carb...malossi clutch...polini air filter.


the variator is probably stuck as the rollers wear and either fall out in there and jam it up or wear into the side of the ramps.does it go ok on a straight?

May 06, 2015 | Keeway Motorcycles

1 Answer

How do i fix the choking on my 2008 Keeway Superlight?


If you put the choke on does it get better or worse,and have you checked the valve clearances are right.

Feb 22, 2015 | 2008 Keeway Superlight 125

1 Answer

How much oil for keeway outlook 150?


You should change the oil on the keeway outlook 150 every 2000 Kmts and the old oil should be drained completely and add one liter.

May 22, 2014 | 2010 Keeway Outlook 150

1 Answer

How do i change the belt on my 2009 keeway outlook scooter?


There's some work needed to be done on that. Download the service manual and buy the proper tools for that job.
https://www.scribd.com/doc/238408121/Manual-de-Taller-Keeway-Logik-Idioma-Ingles

Apr 02, 2011 | Keeway Outlook 125 Motorcycles

1 Answer

Removing seat on Keeway 125 speed


on the left side of the bike at the back there is where you can insert your key, put it in and turn, behind the key there is a lever pull it down and the seat will release, you need to pull up the seat at the same time.

good luck.

Aug 08, 2010 | 2008 Keeway Superlight 125 II

1 Answer

How to chane battery on keeway outlook 125


You have to remove the lid that covers the battery on the floor of the scooter. There are only two screws to be removed and the battery is exposed.

Apr 08, 2010 | 2008 Keeway Outlook 125

Not finding what you are looking for?
2010 Keeway TX125 Supermotard Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Keeway Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers

Ron Stone

Level 2 Expert

197 Answers

Are you a Keeway Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...