Question about 2002 Honda CR 125 R

1 Answer

Hi.I have a 2000 honda cr 125 and it has problems starting.I cleaned the carb.put a new plug in and its got 150psi compression.It takes about 30 kisks to start it.When it does run it runs great.Any ideas.

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

Chage engine valve

Posted on Jun 15, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My Honda 2002 cr 80 wont idel and is hard to start. I put a new carb kit and plug in it and still is hard to start.

The main cause of an idling AND starting problem is a clogged pilot jet--the small one. Take it out of the carb, blow it out again and make sure you can see light through its very small opening before reassembling the carb.

And, be sure the compression is 125 psi or higher.

Sep 26, 2014 | 2005 Honda RC 51

1 Answer

Why is my honda cr 125 2000 year dumping gas out

the float in the carb is getting stuck give it a couple of taps and if that doesnt work u need to take the carb off and clean it

Aug 07, 2012 | Honda Motorcycles

1 Answer

How do I remove carb from 98 honda cr 125? Everything seems to be in the way not sure what to take off to get to it

remove airfilter , loosen airbox then undo both clips either side of carb , remove fuel pipe , tilt carb towards you so you can remove the cable and throttle slide and put to the side hanging ! press the rear tube between airbox and carb , soft , then pull carb out !! pictures or vidio as you start ! P...

Oct 03, 2011 | 2002 Honda CR 125 R

1 Answer

I have 1982 cr 125, I'm having a hard time starting it I cleaned the carbs changed the filter put new oil in it but it won't start.

does it have a spark ? remove plug , place in hand and crank , do you feel it tingle ? if not check cap is ok , remove it and put ht in hand and crank , any joy ? if not then check coil etc ! P...

Mar 28, 2011 | 2002 Honda CR 125 R

1 Answer

I have a 1991 honda cr 250 I cant get to start at fist gas ran right thru carb and out bottom i took carb apart and got the floats to stop sticking cleaned it out with carb cleaner put back together but...

try a new spark plug. if u fowl out a plug some time they will not fire under compression.2 strokes need. fuel,fire and air, very simple is possible crank seal are bad .that doesn't allow the engine to create vacuum in the crank case.thus fuel and air will not make it to combustion chamber.

Jul 11, 2010 | 2002 Honda CR 250 R

1 Answer

Have a honda crf100f 4cycle got spark wont start,


Jan 23, 2010 | 2002 Honda CR 125 R

1 Answer

I have a 94 cr 125 , that i just bought , it started at the guys house but now wont start for me , tried putting a new plug in , any ideas

Try a compression test first see what it is, next check for spark, remove plug from engine leave connected, ground the end of the plug to the engine and kick over, if you have good compression and spark, it is in the carburation, some bikes dont start well when cold due to bad carburation(air leaks, bad jets etc)you could try roll starting down hill and see if it starts.

Nov 07, 2009 | 2002 Honda CR 125 R

1 Answer

Honda cr 125 new top end rebuild started ok but when switched of petrol leaks out of overflow tube every couple of minuates

sounds like the float in the carb is stuck or set to the wrong hight give the carb a few taps with a screwdriver if that dont work take the carb off and check the float and needle.

Oct 08, 2009 | 2002 Honda CR 125 R

2 Answers

2002 CR 250-has gas on carb,new plug and only starts with a squirt of starting fluid and dies instantly.

Best would be to clean the carburator, it seems the gas doesn't enter the combustion chamber, the jets could be blocked.
Check the valve clearance too, not bad to take the compression test of the cylinder.

Jul 22, 2009 | 2002 Honda CR 250 R

1 Answer

Engine compression for 2002 125 CR Honda, 125lbs?

that sounds pretty decent, it is 7 years old so there will be less compression now than when new, obviously beacuse of wear. but 125lbs is good.

Mar 18, 2009 | 2002 Honda CR 125 R

Not finding what you are looking for?
2002 Honda CR 125 R Logo

Related Topics:

309 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

5060 Answers


Level 3 Expert

81400 Answers


Level 2 Expert

342 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides