Question about 2011 kawasaki Ninja ZX-14

1 Answer

ZX 14 KAWASAKI WONT START NO ERROR CODE

BIKE WAS STARTING FINE THEN JUST DONT WANT TO START

Posted by on

  • Bashier Bhayat
    Bashier Bhayat Apr 01, 2014

    ok the pump is not going on and there is no spark

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Filmmaker:

    Uploaded 5 video answers.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 152 Answers

I'd be looking at the fuse that controls the kill switch or the switch it self?
Good luck....

Posted on May 21, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 7 Answers

SOURCE: Kawasaki zx7 won't start

Hi. I had the same issues as what your saying. What we found was that the leads are a screw in into the spark plug cap. Unscrew the leads to the cap, trim the ends off by a mm or 2 and re-screw back into cap that goes onto spark plug. There renown for pulling out and giving weak or no spark.

Posted on Jul 07, 2009

  • 15 Answers

SOURCE: my 05 kawasaki ninja 636 will not start. the

I am not familiar with Kawasaki's but with Suzukis you need to hold the clutch before yuo can start it. If this is the case and you are, then it might be the switch is defective or the wire has come loose. It might also be worth checking the kill switch is in the run position. The humming noise is the fuel pump priming and is normal

Regards

Chris

Posted on Nov 06, 2009

nedkelly900
  • 345 Answers

SOURCE: Bike wont kick start or idle , it will coast

first drain the carby, then set your air mixture screw 2 turns out, from the fully turned in position. The starting proceedure is as follows, when the engine is COLD, turn on fuel, pull on the choke fully, and kick the engine over. DO NOT use any throttle, when the engine is cold, and the choke is on. Remember Choke on, NO throttle.
When warm, no choke, and a little throttle when kicking.

Posted on May 13, 2010

  • 16 Answers

SOURCE: 1998 Kawasaki Vulcan 1500 classic will not start,

under the seat there is a reset button that taked a metal prong thingie (dont know whent it's called) you can use a paper clip - just jump the two terminals and try to start it,, doesnt happen all the time but it does happen.

Posted on Jul 23, 2010

  • 20 Answers

SOURCE: 2007 kawasaki ninja 650r. when I goto start the bike it makes a clicking sound but wont start. the clicking isnt from the starter it comes from an area by the battery.

Sounds like your hearimg the solinoid clicking, basically it makes the connection from the start button to the starter. It's often mounted right next to the battery as well. Now if your sure the battery is good and fully charged fallow the positive cable from the battery to solinoid, from solinoid to starter motor, and check each connection is tight and clean from corrosion. Also fallow the ground from the battery to the frame check for the same. If all look up to par, jump start the bike from a battery charger or vehicle with cables. If it starts, recheck the battery voltage.

Posted on Mar 23, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1999 Kawasaki ZX-9R Ninja will not turn over


Test the battery, bike batteries can and do just go open and dead all of a sudden, have been stranded more than once, filled with gas and then no start nothing, no lights nothing.

May 20, 2017 | 1999 kawasaki ZX-9R Ninja

1 Answer

2007 Kawasaki zx14 temp gauge flashing hot to cold and will not start and the bike is not hot


on the 2007 that flashes hot and cold and wront start the cdi ecm unit is bad that is what runs all that

May 27, 2012 | 2006 kawasaki ZX-14

1 Answer

Bike wont start


If you can't find another similar connection on the new motor, you might need to swap heads (if it's the same exact motor).

Jan 14, 2009 | 1999 kawasaki ZX-9R Ninja

1 Answer

My bike won't start i have changed everything out possible. the start button wopn't work just replaced it. but you can ark it off the starter relay


You have a 2001 ninja zx-9 your bike wont start...I dont know from here if it is ,or is not cranking. If you can get it to crank do you have spark? What did it do last time it ran ....did it die slowly or just ran and next time didnt. If you have spsrk is it blue or yellow spark...

Dec 16, 2008 | 2001 kawasaki ZX-9 R Ninja

Not finding what you are looking for?
2011 kawasaki Ninja ZX-14 Logo

Related Topics:

111 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4533 Answers

yadayada
yadayada

Level 3 Expert

76630 Answers

bazzz7071
bazzz7071

Level 2 Expert

342 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...