Question about Moto Guzzi Nevada 750 Club Motorcycles

Open Question

Rtturnsignal ft and rear lights on continuous even wth ign key off

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do i change out the ignition switch?


Ign Systems 8D - 19 Service manual '92 Dak
Disconnect neg battery cable Tilt column:Remove tilt lever (counterclockwise) Remove upper and lower covers (3 screws) Remove ign switch mounting screws (3) with torx bit Gently pull switch away from column Release two connector locks on the seven-terminal wiring connector. Remove connector from ign switch Release connector lock on the Key-in-switch and Halo Light four terminal connector. Remove connector from switch Remove key cylinder from switch as follows: With key inserted and ign switch in the LOCK position use small screwdriver to depress the key cylinder retaining pin flush w/ key cylinder surface Rotate the key clockwise to the OFF position The key cylinder should now be unseated from the ign switch assembly With key cylinder in unseated position (key cylinder bezel about 1/8 inch above ign switch halo light ring) Rotate key counterclockwise to LOCK position and remove key Remove key cylinder INSTALLATION; Install electrical connectors to switch making sure locking tabs are fully seated into connector Mount ign switch to column Shifter must be in PARK position Park-lock dowel pin on ign assy must engage with park-lock slider linkageVerify ign switch is in lock position (flag is parallel w/ ign switch terminals..off to the right) Apply dab of grease to flag and pin Position park-lock link and slider to mid-travel Position ign switch against lock housing face Be sure pin is inserted into park-lock link contour slot Tighten screws Assemble cover Tighten more screws Tilt column and install tilt lever (clockwise) instsall neg battery cable Gently insert key cylinder into ign switch asssy until it bottoms Insert key and gently push key (inward) and rotate clockwise to end of travel Rejoice in how much money you just saved yourself

Jun 16, 2014 | 1992 Dodge Dakota

1 Answer

My lights are on but continue to ding as if car is off but lights have been left on but car is still running???1996 Chevy Beretta v6


its either a faulty ign switch or a faulty door switch ,,,, the system thinks the door is open or that ign is not on ,,, there is a micro switch in the ign to tell if key is in or out ,,,, try spraying a spray oil into ign switch and working key in and out to see if it will free out ,,, hope this helps

Dec 06, 2013 | Cars & Trucks

2 Answers

2 WIRES PULLED OUT OF THE PLUG ON BACK OF ALTERNATOR ONE WHITE WTH RED STRIPE ONE BLACK WTH WHITE STRIPE WHICH ONE IS IN THE CENTER


dont guess.
ouch, the FSM shows all connector pin outs in the rear.
you never said the year.
nor country diff, countries have different harness colors.??????
my 04' FSM shows.
2 wires. (not counting case and big wire)
the 2 plug. called A11 plug.
a11 pin 2 white red. charge lamp.
a11 pin1 black white,,, IG fuse.

but where are the, page 9a-16 shows that.
harness side,
key up, locking key up
1, 2 , X ( x is blank socket pin) left to right.
1 blk-wh
2 whit red,

or go to alldata dot com and look.

Sep 22, 2013 | Suzuki XL7 Cars & Trucks

1 Answer

Security light blinks continuously on 07 Avalon, accompanied with beeping.


Try doing this: push the brake pedal, turn the ign key from off to on five times, this should reset the system.

Jun 06, 2012 | 2007 Toyota Avalon

1 Answer

When U turn ign key no check eng light all others turn on try to start ,nothing wigle key and clock,heater fan climate control sorta work but as you continue to turn key it shuts of and nothing ive...


You may want to check the engine to boy gounf . It is located at the rear top of engine anfd is bolted to the engine intake manifold and screwed to the firwall. It's just a short stainless steel braided strap Remove ,clen rnds and sand of any pat tthat would interfere with a good connection. Good Luck _Ned_

Oct 15, 2009 | Mazda Millenia Cars & Trucks

2 Answers

MY 1995 SUZUKI SIDEKICK WILL NOT SHUT OFF EVEN WHEN THE KEY IS IN THE OFF POSITION. I CAN EVEN PULL THE KEY OUT AND IT WILL STILL CONTINUE TO RUN. I HAVE GOTTEN IT TO KILL IF I SHIFT INTO GEAR AND TURN THE...


Sounds like you have a bad ign switch, where the contracts are staying connected or the wire plug behind the switch is burnt causing the car to stay running. reply back if that is ok and i will look in the books, Don Suzuki tech

Aug 10, 2009 | 1995 Suzuki Sidekick

1 Answer

96 camaro


could be ign switch, relay, fuse, bad starter, corrosion on the battery cables, faulty starter cable, bad battery, corrosion on the starter, dead battery, bad alternator that allowed the battery to go dead, wrong key, bad key, worn key... shall I continue?

Aug 07, 2008 | 1996 Chevrolet Camaro

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Moto Guzzi Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

john h

Level 3 Expert

12104 Answers

Are you a Moto Guzzi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...