Question about 2001 Suzuki DR 200 SE

1 Answer

My dr 200 wont start when cold with full or half choke i jump start it and when it warms up the choke works fine....the mind boggles thanks guys

My 1996 wont start on full or half choke until its warmed up so jump start is the only way to start and choke works fine when warm

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 42 Answers

Are you giving it any throttle when you try to start it, yu shouldnt, keep throttel completely closed when using hte choke or you will flood the engine

Posted on Apr 02, 2014

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 420 Answers

SOURCE: DR 200 runs really cold. Takes about 15 minutes or so to warm up

It depends on the tempature, if its pretty chilly out yeah. Try easing the choke in slowly, and when it will idle at about half choke go aheand and take off but run the bike easy for a few minutes then close the choke.

Posted on Mar 29, 2009

dmsr63
  • 2050 Answers

SOURCE: starts good cold with choke runs bogy until fully

You might be too rich on the pilot jet. (Too large)
Run it for a minute with the choke on, then shut the choke off, and let it run with just a little thrttle till it's warm. If it doesn't "clear" up, your jetting may be off. (The pilot does idle) Pull the plug to see what color it is. Black is too rich. (Too large of a jet)

Posted on Dec 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to start a ryobi200blower blower 200


First , prime the priming bulb about 4 x...

Next put the choke lever in full choke position

Give a couple slow pulls, then a good strong pull...

(The unit should burp, run for a second)

Next put the choke lever in the half choke position

Pull rope

It should start and run, now put the choke lever all the way in the off position and let unit warm up a minute... if when you turn choke off it stalls out, u didn't warm it up enough...

Oct 10, 2015 | Garden

1 Answer

I was using my o17 saw today it was runing Just fine I shut it off when I went to start it again it fired on choke seting after that I could not get it to do anything what is wrong with it


All 2-strokes love to run rich when cold thus full choke till it kicks, half choke to start and leave on for 5 seconds high rev's to warm & lubricate, then no choke to run. Restart when hot is 1 pull full choke (you are now flooded) & then no choke til it starts. Try it. Works every time on all of my 2-stroke engines.

Apr 22, 2015 | Garden

1 Answer

Does a 2003 dyna wide glide. Have a Manuel. Choke on a carb model ? And where is it. It starts. But cold natured. Till its warm you have to work throttle till its half warm


Have a look. If one is fitted, it will be next to the carb and have the word "Choke" written on it. Most bikes nowadays have an automatic choke that is operated by a full turn of the throttle before starting, it will switch off when a bi-metallic strip reaches the set temperature.

Jun 21, 2013 | Motorcycles

1 Answer

How to start the generator


Hi Joe, I had asked for a little clarification and have not received any information. I will answer this question based on the generator is in good working order and it is a recoil start. Open the petcock, (this is the fuel valve) and give it about a minute to fill the fuel bowl on the carburetor. If your generator has an engine an on/off kill switch, set to on. If the generator has an auto idle switch set it to off. If the engine has a throttle lever located under the carburetor, push it all the way down (full throttle). Pull the choke knob out completely, there is a detent on the choke for half choke, pull it past this for full choke. pull the recoil starter rapidly. As soon as the engine starts running push the choke knob to half choke, this will allow the engine to run smooth while it's warming up. Depending on the climate that you are in, warm up time will vary. After a minute or two in cold climates start pushing the choke knob in, if it starts to run poorly pull it back out too the half position and let it warm up some more. When you can posh the choke in without the engine faltering it is ready to go. In warmer climates you might be able to start the engine without the choke or in the halfway position. Robin Subaru makes some of the finest small engines available. I would choose a Robin over a Honda every time. I hope this gets your generator going, and once again this is based on the generator being in good working order. Good luck, Michael Burke.

Dec 03, 2011 | Coleman Powermate Subaru 5000W Portable...

1 Answer

What is the recommended method for cold starting of this bike after a storage period of 2 months...what position of choke, etc....I have no kickstart, just battery ignition.


First of all, check, if the oil is now way fuller than before - if you left the petcock on PRI the gearbox is now full with a gaz-oil-mix! You need an oilchange. (and check the airfliter of excess gaz, too)
Recharge the battery.
Now, if that's ok, (petcock always on ON), pull out the choke and start the motor.
2 month is not very long, should be fine, especially when you put Sta-Bil in the gaz tank before winter.

----
Owner of a Suzuki DR200SE V (V stands for 1997)

May 14, 2011 | 2002 Suzuki DR 200 SE

1 Answer

Weedeater dies when you open choke


After you start it and are in the second stage of the choke (half choke ) let it run for awhile until it warms a bit then try openning choke and going to full throttle.

May 21, 2010 | Poulan 25cc 2-Cycle Gas Powered String...

1 Answer

Hard start tb475ss troy built weed wacker when i close the cold start lever it starts but its 75 degrees out its like the primer ball is inop but i see fuel moving through the lines when priming did not...


These 4 cycle trimmers need to be primed 10x before a cold start. The bulb will feel *firmer* on the last two or three depressions and you'll know that the carb is primed.

Full choke and and full throttle on first tug should see it hit once with a puff of smoke. Second start attempt should be in choke position two (half choke) and with full pressure on the throttle. Should rev to life on start attempt. Let the engine IDLE for 30 seconds, moving the choke to off at the end of the waiting period. Let engine idle to warm another full minute with no choke, then set to work!

May 02, 2010 | Troy Bilt Tb425cs 26cc 4 - Cycle Curved -...

1 Answer

Hello I have a 1996 Suzuki DR-200 and recently put


G'day mate the 1st thing i would go for is float level then compresion if it does have the **** it wont take the fuel in , rules are if it has **** ( induction ) Squeeze (compression) Bang ( spark) and Blow (free exhaust) then it should go, if it was running to lean there is good chance it has a burnt exhaust valve which will greatly drop the compression/induction, also check the valve clearence. hope this helps

Apr 04, 2010 | 2000 Gas Gas EC 300

1 Answer

DR 200 runs really cold. Takes about 15 minutes or so to warm up


It depends on the tempature, if its pretty chilly out yeah. Try easing the choke in slowly, and when it will idle at about half choke go aheand and take off but run the bike easy for a few minutes then close the choke.

Mar 29, 2009 | 2003 Suzuki DR 200 SE

1 Answer

2004 Kawasaki Prairie 700 wont start


Never mind guys, i figured it out, the valves actually tightened up and pushed them off their seat, no compression, so i got the feeler guages and fixed it, lots more power now:P thanks anyway.

Jan 28, 2009 | kawasaki Full Suspension Mountain Bike Men

Not finding what you are looking for?
2001 Suzuki DR 200 SE Logo

262 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

Richard
Richard

Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...