Question about Yamaha Moto 4 350 2wd 87 Airbox Air Box

1 Answer

No power to coil on moto 4 350

I have no power going to coil

Posted by Anonymous on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Prodigy:

    An expert who has answered 500 questions.

  • Yamaha Expert
  • 545 Answers

Change the cdi unit

Posted on Feb 02, 2015

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Moto Guzzi has been charging for 2 weeks, battery ok, lights come on, press start and nothing, tried to bump start a no go. ?


Hi, Adam before testing any electrical component in the Starter Circuit it is "IMPERATIVE" that you have a fully charged battery of 12.5 volts or more and be able to pass a proper "LOAD" test because your battery may have 12.5 volts or more but little or zero amps causing the battery to be faulty and must be replaced, especially "AGM" batteries.
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter.
4. Bank angle sensor needs a reset or is faulty.
5. FOB battery low or dead.
6. Faulty ignition switch.
7. Faulty starter button.
8. Faulty kickstand or clutch pull in switch/sensor.
9. Security alarm needs a reset.
10. Starter relay, solenoid or starter circuit wiring faulty.
11. Starter armature or field coils have failed.
12. Main fuse or circuit breaker may be blown or faulty.
13. The electric starter is working but starter clutch has failed.
14. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
It will not Start Technical Topics
Washed my Moto Guzzi V7 won start
https://www.manualslib.com/brand/moto-guzzi
http://www.harpermoto.com/oem-moto-guzzi-illustrated-parts-catalog.html
http://mybikemanuals.com/moto-guzzi

Apr 08, 2017 | Moto Guzzi Motorcycles

Tip

Ducati Fault Codes


Engine Fault Codes - Ducati 749/999


To see the fault codes, with the ignition off hold both dash buttons down and turn ignition on.


1.1 TPS Disconnected


1.2 TPS short circuit to earth


2.1 Pressure Sensor short circuit to power supply


2.2 Pressure Sensor shorted to earth


3.1 Water Temp Sensor shorted to power supply


3.2 Water Temp Sensor shorted to earth


4.1 Air Temp Sensor shorted to power supply


4.2 Air Temp Sensor Shorted to earth


5.1 Battery Hi


5.2 Battery Low


10.1 Hor. Coil shorted to power supply


10.2 Hor. Coil shorted to earth


11.1 Ver. Coil shorted to power supply


11.2 Ver. Coil shorted to earth


12.1 Inj1 shorted to power supply


12.2 Inj1 shorted to earth


13.1 Inj2 shorted to power supply


13.2 Inj2 shorted to earth


14.1 Inj3 shorted to power supply


14.2 Inj3 shorted to earth


15.1 Inj4 shorted to power supply


15.2 Inj4 shorted to earth


16.0 Pump Relay


17.1 LH Fan shorted to power supply


17.2 LH Fan shorted to earth


18.1 RH Fan shorted to power supply


18.2 RH Fan shorted to earth


19.1 Starter Solenoid shorted to power supply


19.2 Starter Solenoid shorted to earth


30.0 ROM/Eprom error


34.0 Signal Panel Sensor


36.0 Speed sensor


37.0 Immobiliser (transponder)


37.1 Immobiliser (antenna)


37.2 Immobiliser (instrument panel serial driver)


37.3 Immobiliser (serial cable disconnected)


37.4 Immobiliser (ccm serial drive)


37.5 Immobiliser (key not recognised)


37.6 Immobiliser (ccm program)


38.0 Can Line error

Source http://moto-files.weebly.com/ducati-fault-codes.html

on Dec 20, 2016 | Motorcycles

1 Answer

Where to take it for repair. I am residing in Sarita Vihar New Delhi.


Ak Mehra

Long press power and volume down button.

You can go to

Mark
Motorola Support My Moto and then click Support and then Repair centres if you need assistance.

Jul 05, 2015 | Motorola Moto E

1 Answer

6v magneti marelli ignition coil wiring / terminals.


the blank one and you can check this out after the bike is running or at least when you get the coil to fire by placing the lead part of a pencil in the gap between the spark plug or a good ground and the gap between the pencil and the spark plug wire so you can see the spark jump to the plug or ground from the plug wire and if the spark flash is on the wire side of the pencil the coil the coil is wired with wrong polarity if the system is a positive ground system. The coil will work no matter what the polarity ie no matter which of the terminals you connect to power and which you connect to ground, the only difference will be a somewhat weaker spark if electron flow is reversed from what it should be i.e. if it is from negative or ground to positive on a negative ground system or as on some older British ignition systems from positive to negative on a positive ground system. The flash will appear on the side of the pencil lead away from the current flow i.e. the flash will occur as the current leaves the pencil lead. Hope this helps.

Dec 10, 2014 | Moto Guzzi Motorcycles

1 Answer

How would I put my cell phone, a moto g(XT1028), on safe mode? it has the fbi virus.


Go to power off. Blog Press Power down. Then choose reboot into safe mode.

Mark
Motorola Support

Sep 06, 2014 | Motorola Mobility Moto G 8 GB Black...

1 Answer

Bike does not switch on


Check all connections first for tightness.

Usually is a loose connection.

If still no go then you need expertise to check the ignitor and erthing system.

Apr 10, 2010 | 1982 Moto Guzzi V 50 II

1 Answer

Started of with misfire on right hand bank


have problems hooking up the starter, regulator altenator, rectifer on my 1978 850T3 problem started when I took off the fairing then found som bad wired and connections wer bad front part of bikes wiring is ok is the back part having problems.

Apr 04, 2009 | Moto Guzzi 850 T 3 Motorcycles

1 Answer

Coils


To be honest get any 12 volt ones from a bike accessories shop to suit either electronic or points ignition. I have used coils like these with no problems. ,,

Nov 10, 2008 | 1990 Moto Guzzi 750 Targa

Not finding what you are looking for?
Yamaha Moto 4 350 2wd 87 Airbox Air Box Logo

Related Topics:

91 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...