Question about 2007 Bajaj Discover

1 Answer

Misfire How do tuning

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

Pull the plug and clean it, pull the air filter and clean or replace it, with the plug out of the cylinder cycle the motor a few times - as if you're trying to start it - but cover anything you don't want gunk to get on. If there's residual oil in the cylinder this can help flush it out.
Of course like the last answers mentioned, your spark plug's gap should be correct, and it would be wise to make sure you have the correct amount of oil in it.
If the air filter is paper, replace it. If it's a foam filter, use some foam filter cleaner, not something as abrasive and destructive as brake/carb cleaner. A mild dish washing soap and hot water in your kitchen sink will do the job but not too hot that the rim of the air filter falls off because the temp disrupted the adhesive.
Spark plugs are fine with being cleaned with the brake/carb cleaner but I'd go with the brake cleaner. I find it evaporates better with less residue.

Posted on Feb 03, 2015

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Mecury sable misfire on two cylinders, Does this mean I can do a tune up on my car and it should act fine.


if the misfire is on 2 adjacent cylinders , a tune up will be a waste of money unless you have a compression test done first
adjacent cylinders is generally a head gasket
modern EFI engines do not need a tune up as the computer in the ECM does a tune up every 30 seconds
what you should be doing is having the fault codes read to see there are any reports from the sensors that need attention
most misfires are from bad injectors so a quality injector cleaner is about all the tune up you need to do

Jan 24, 2017 | Cars & Trucks

1 Answer

Why does my avensis seem to be "lumpy" and as though its missing. also seems sluggish


that is called misfire.
did you forget tuneup time?
33million hits.
https://www.google.com/webhp?gws_rd=ssl#q=how+to+tune+up+an+engine.

misfire is caused by 50 things.
we tune it up (crossfingers) the if still misfiring, do the test.
ask for list of simple test.

do the 60,000 mile list,in the operators guide.

Jul 04, 2014 | 2007 Toyota avensis 1.6

1 Answer

05honda crv cutting out bad


MISFIRING.
2005 , in USA (are you) has OBD2 technology engine puter brain.
and in fact can set DTC P030x errors on misfire.
in USA, (not canada) it glows the CEL on all misifires. running...
does it glow the CEL driving?
if yes, then scan it. (USA)
get it scanned.
or take car to any ASE cert,.mechanic for a tune up, ever do the 60k mile service, ever? id bet not. most just drive car till it misfires.
but only you know that...
misfire can be caused by 50 things, (complexity)
top 3?
1: no tune ups done. (spark parts and filters)
2: EGR stuck open (clean it, most shops do at tune up time.
3: bad fuel. old fuel.

Dec 09, 2013 | 2005 Honda CR-V

1 Answer

Misfire


ever tune it up , read the opr. guide for the 60kmile maintenace,?

no car engine runs for 300k miles, ever, skipping tune ups
tis a fact.

Dec 04, 2013 | 1992 Toyota 4Runner

2 Answers

Hooked up computer to dodge ram 1500 4.7 liter magnum code came up p300 p301 what does this mean


P0300 is the random misfire code. P0301 is the misfire code for Cylinder #1. When was your last tune up? non platinum spark plugs should be replaced around 30-60k along with the wires. With platinum plugs that extends out to 100k. I would try a tune up first plugs and wires. Reasonably cheap fix that is a prevenitive maintenace item anyways. If you have just recently had a tune up or it does not solve your problem you most likely have a bad coil pack on cylinder#1.

Hope This Helps.

Zeppelinx12

Mar 16, 2011 | 2004 Dodge Ram 1500

1 Answer

We have a check engine light for misfired cylinders. We are planning on doing a tune up. Will this fix the problem?


usually a complete tune up will cure the problem. BUT, you can also get misfires for coil problems. also 1 bad injector will cause misfires. a tune up is always a good place to start. you may need to have the codes cleared after the tuneup.

Feb 12, 2011 | 1996 Oldsmobile Cutlass Ciera

1 Answer

# 6 cylinder misfire. 88300 miles. should I do tune up?


A misfire can be caused by many thing, most common is a defective ignition coil or defective fuel injector, the plugs last well over 100,000 miles so unless you disturbed them they should be ok. Your first tune is at 100,000 miles as stated in the owners manual under maintenance. Engine problems can also cause a misfire, these include a vacuum leak at the intake manifold or a burned valve.

Jan 16, 2011 | 2000 Chevrolet Blazer

2 Answers

Got misfire in cylinders 1 & 2 after tune-up


Could be bad coils, or someone switched the two wires if it has wires.

May 28, 2009 | 1999 Ford Expedition

1 Answer

Service engine light still on after tune up


I would have this vehicle scope tested to see which, if any cylinder is misfiring. A tune up WILL NOT necessarily eliminate any ignition malfunction, but a QUALIFIED tech will note a problem. Many factors can be involved in a MISFIRE, including, coils, compression, timing, and more. Hope this helps

May 18, 2009 | 2001 GMC Savana

2 Answers

96 bmw 740il misfire


This is a pretty common problem. I would change your valve cover gaskets. They run around ~ 50 bucks. If they are bad it will leak oil into spark plug well and cause a misfire. Very known on the 740.. Also if tune was not anytime not too long ago id change spark plugs while you at it. Then clear the computer and if you still get misfire on 8 try changing the ignition coil which is right about the cylinder with cylinder ignition coil 5. clear the computer. if you get random misfire and misfire cyclinder 5 after then its your ignition coil. parts store runs around 100 bucks

Dec 22, 2008 | 2005 Hyundai Santa Fe

Not finding what you are looking for?
2007 Bajaj Discover Logo

74 people viewed this question

Ask a Question

Usually answered in minutes!

Top Bajaj Experts

sachin sharma
sachin sharma

Level 2 Expert

171 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers

chandrakantm

Level 1 Expert

8 Answers

Are you a Bajaj Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...