Top bolt is spinning with the shaft, I don't have a torch or air tools. Vice grips keep poping off...any help Also i cant get the wheel bearing out. it won't budge all parts are original .
The wheel bearing is pressed in and held in with a snap ring so you would need a shop press to make that easy to change. As far as the shock goes you can remove the whole thing from the car once on a bench you can try to hold the nut with a wrench and try turning the shaft. if your using factory parts you can get those shocks 2 ways either just the shock or the whole assembly.
SOURCE: Front wheel bearing problem with 2002 rio
It,s probebly that the knot that holds the bearing in plase is being plased too tight, It,s the oldest trick in the book... this way you will have return about every two or tree months to get it fixed, and so the mechanic can keep eating.
SOURCE: bearing at u-joint from transmission is out. What is this part?
try www.autozone.com to see if they have your car listed for diagrams pictures and step by step instructions if your car is not listed then try your local library they have all the car manuals and even copy them for you
SOURCE: wheel bearings
the wheel bearin and hub is one . the bearin is press in . some times it just easer to change the hole thing .and you will have to disconect the tierod upper and lower ball joint . i hope this help you
SOURCE: Rear Brakes drum 2004 Kia Rio
The rear drums are held on by a spindle nut. You first must remove the dust cap then unstake the nut and remove it. Behind that is a retaining washer and the outer bearing. The bearings can become a little stuck in which case a hammer can usually persuade them to loosen up.
73 views
Usually answered in minutes!
×