It says in the booklet not to add more that 2 spacers , but it doesn't cut very short is there a half space or adjustment i can do as this is branf new petrol flymo
There should be two sets of holes for the deck mounts. Check and see if it is in the upper or lower hole. Place in lower hole if applicable. Also ther is an adjustment nut on both side of the mower deck that has a jam nut and a gear nut. The gear nut adjusts the height of the mower deck on each sid here is link that might helpe. Loosen jam nut and turn to go up or down. Then tighten jam nut. This should be done on a level surface. here is a link that will help you as well.: http://homeguides.sfgate.com/adjust-deck-height-husqvarna-100712.html
SOURCE: does not give a short enough cut
Have you always had this problem?
Have you had the blades off to sharpen?
Could the blades have been mistakenly put on upside down ?
The turned up piece goes toward the deck
Check your deck hangers to be sure they are free and not binding anywhere and to be sure they are dropping as far as they can go in the lowest deck setting.
your deck should move up and down evenly as you lower and raise it.
Unless spacers are an option for this cause i wouldnt use them.
Check the tire pressure 14 psi front 10psi rear .
hope some of this helps for you
SOURCE: my flymo 350 turbo compact isint cutting can i adjust the blade height ?
You can put spacers under the blade, a twin pack of spacers are available from Flymo part no. 513811081., from memory you are allowed to fit three spacers.
120 views
Usually answered in minutes!
×