Question about Suzuki GSX 600 F (Katana Motorcycles

1 Answer

1992 suzuki gsx600f no spark when earthed

Sparks when plug is a copule of mm from frame but stops when i earth it as it should be iv tryed new plug witch did get it runnin untill i washed it iv tryed cleaning all joins in the wires (ecu an relays aswel)iv taken off the sidestand sencer an wired it. i dont know wot else to try

Posted by on

  • dave
    dave Mar 26, 2014

    any ideas???

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Suzuki Expert
  • 391 Answers

You may have gotten something wet. Try blowing out the spark plug caps on the wires. Blow off the wires and coils and their connections too. A coil can cause this but usually not on all cylinders.

Posted on Apr 13, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Benimur
  • 6966 Answers

SOURCE: the headlight flashes and the turn signal goes out

Hi and welcome to FixYa,

It would seem that some wires have crossed. You can verify connection by following the wiring diagram.

Good luck and thank you for using Fixya.

Posted on May 11, 2009

  • 245 Answers

SOURCE: where is the xt600e earth/ground wire connection

If your negative battery cable has been disconnected, and you can't tell where it goes, anyplace on the metal frame where you can make a good connection will be ok. You will need a sturdy bolt that you can tighten enough.

Posted on Nov 21, 2009

  • 3567 Answers

SOURCE: witch plugs go to witch wires on an 92 suzuki

This should help out. Please rate my answer. Thanks!
90e0c56.gif

Posted on Jan 14, 2010

  • 3567 Answers

SOURCE: I took the plug wires off and forgot witch one

The diagram below should help. Please rate my answer. Thanks.

0eaea97.gif

Posted on Sep 06, 2010

pack484hawks
  • 13 Answers

SOURCE: apache quad rlx100cc evrything seems ok turning

Check kill switch and lanyard kill switch if it is equipped with one. CDI may be bad. This is very common on small engines. Could also be the coil. My money is on the CDI! good luck. www.solanocycle.com

Posted on Jan 03, 2011

Testimonial: "thank you for your advice i have done some testing and believe it could be the resistor pack i am going to get a new one and go from there."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No spark,"Gardentech" (Netto/Aldi) how can I test ignition unit?


no meter needed just take the spark plug out then hook the coil wire back to it, try to find a dark area then hold the spark plug to the head anywhere that's metal and have a friend try to start it or do so yourself with the switch on of course. If it sparks at the end of the plug then the coil is good. If not install new plug , repeat procedure. Also, check all wire connections and ohlm out the switch why your at it.

May 30, 2014 | Garden

1 Answer

How to wire new tail light for a 03 suzuki gsx600f?


Brown is tail
Red is stop
either back or green is earth.
Why do you need to "rewire" if you have a new one just leave the wiring and light sockets on the bike replace the tail light and put the original light sockets back in the new tail light.

May 03, 2014 | 2003 Suzuki GSX 600 F (Katana)

1 Answer

Test cdi box


Hi, Anonymous and the usual suspects are:
1. Fouled spark plugs.
2. Severely discharged or a damaged battery, should have 12.5 volts or better and be able to pass a load test if necessary.
3. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Loose connection at ignition coil or plug between ignition sensor and module.
5. Spark plug cables in bad condition, shorting / leaking, spark plug cable connections loose.
6. Faulty ignition coil or electronic control module or CDI box.
7. Faulty CKP, CMP, or BAS sensor.
8. Faulty ignition switch.
9. Tilt sensor needs a reset.
10. Security alarm failing to disarm needs reset
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
Probable Solution to the Firing on One Cylinder Issue 50MPH at WOT No More
https://groups.google.com/forum/#!topic/rec.motorcycles.tech/BxBKbi9w2k4
Yamaha XV 535 DX Virago Service Manual
OEM parts for Yamaha
http://www.starmotorcycles.com/assets/service/manuals/2000/LIT-11626-13-16_110.pdf

Apr 13, 2014 | 1997 Yamaha XV 535 Virago DX

1 Answer

Gsx600f no spark when earthed


Cracked plug insulator. Repl. spark plug.

Mar 25, 2014 | Suzuki GSX 600 F (Katana Motorcycles

1 Answer

Intermittent spark when cranking dt 125 2006


if batteries ok then its bad connection, check all connections battery solenoid, starter and earth to frame

Feb 22, 2013 | 2006 Yamaha DT 125 RE

1 Answer

1979 Suzuki GS750 won't start. new plugs, only getting spark with 3 at of 4. Does anyone know what might be the problem?


HI THATS ODD TO HAVE 3 SPARKING, AS THE IGNITION COILS ON THE OLD GS WERE 1COIL FOR 2 CYLINDERS IE 1&4 CYLINDERS USED 1 COIL AND 2&3 USED THE OTHER , SO IF YOU ARE GETTING A SPARK AT EITHER OF THESE THAT MEANS THE COIL IS WORKING, ON THE COIL THAT IS ONLY GIVING A SPARK AT 1 PLUG SWAP THE PLUG OVER AND SEE IF IT THEN SPARKS IN THE OTHER CAP THIS WILL ELIMINATE THE PLUG, IF THE PLUG THAT WAS SPARKING IN THE OTHER LEAD NO LONGER SPARKS IN THE OPPOSIT LEAD THEN OBSERVE THE LEAD REMOVE THE CAP AND EARTH THIS OUT WHILE YOU TURN OVER THE ENGINE, THIS WILL ELIMINATE THE CAP,

Aug 31, 2010 | 1980 Suzuki GS 750 L

1 Answer

My olds 1992 88 stopped running. changed the fuel filter and drained all of the old fuel (which wasuper rusty and contaminated). the car seems to want to start now but wont. i have been told to change the...


have you got a good spark- take out a plug and lay it plugged into the lead on top of the engine so the tip is earthed (touching the engine) and crank it over - DO NOT TOUCH THE PLUG WHILST CRANKING AS IT GENERATES MASSIVE ELECTRICAL VOLTAGE..............
if it sparks its probably a fuel problem still and not ignition/electrical.

Sep 18, 2017 | 1992 Oldsmobile 88

1 Answer

I have recently renovated a Suzuki Bandit 600S I have got it all back together, and all is well, apart5 from one problem I cannot seem to cure. (Electrics are not my strong point). When I turn the igition...


Hi, I've just reno'd a couple of bikes and I found that the powdercoating on the frame and various brackets, along with fresh paint, really messed with the standard earthing set-up. I ran an extra earth lead from where the battery earths to a bolt on the cylinder head. I also had to add extra earth wires to an IT 250 tail light assy.when new plastics and grommets were added everywhere. Hope this helps, cheers.

Aug 09, 2010 | Suzuki GSF 600 S Bandit Motorcycles

1 Answer

O3 rm 125 has no spark


check simple things first like, spark plug,try a new one or the plug cap,a bad earth frame connection in relation to the ignition system,cdi unit earth,ecu frame earth etc, etc 1. check the kill switch. 2.check the resistances in the high tension coil. Primary around 0.6 ohm, secondary around 15~20k ohms. 3 . check the output source coil , black/red~ red/white it should carry about 20~ 28 ohms with an output of around 30 volts. 4. last but not least check the pulse coil. red~ green 85~ 115 0hms.Glad to help Red.

Nov 21, 2009 | 2003 Suzuki RM 125

1 Answer

Electric Shock


First of all confirm that you have electric earthing in your home.
Because the earthing gets the extra current into the earth & stops getting shocked...

Apr 24, 2008 | Philips SAA7130 TV Tuner/FM Radio/Video...

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

163 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4535 Answers

Richard
Richard

Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...