Question about 2000 Yamaha DT 125 R

1 Answer

Iv got spark but it will not start

Wiring loom has been bernt out

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 60 Answers

Fire, fuel, air. If you're missing one, the engine won't run. You have spark, or "fire" Now check for fresh fuel (a wet plug) and finally air flow to from the air intake filter to the combustion chamber. If everything checks out, you may have a timing issue or internal engine damage.

Posted on Mar 25, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the wiring harness for a 1995 jeep grand cheeokee


wiring harness is used to connect all the electronic devices in the vehicle from front bumper through to the back bumper
three sections
front engine bay loom
interior looms
rear vehicle loom
wiring loom covers
lighting
motors
communication and monitors
starting and charging
switches and levers
door locks
engine management and transmission computers

26313092-l1c4a4q5iaygyp55rgdzzhpc-3-0.jpg

Oct 16, 2016 | 1995 Jeep Grand Cherokee

1 Answer

Where does the qoule wire conect to to make spark so the bike can start


all depending on what make and model the bike is,some COIL wires go to the wiring loom some are wired straight to the points some straight to the cdi but the big thick coil wire goes to the spark plug

Dec 09, 2015 | Motorcycles

2 Answers

I have an intermittent misfire on one cylinder.


Could be bad connection to injector or bad injector?

May 02, 2015 | AEM 2001 Ford Ranger - 4.0L V6 - Brute...

1 Answer

Fault code vauxhall corsam


Have you had an oil pressure switch replaced recently ? If so the problem is probably the engine wiring loom,what happens is the oil leaks into the loom and ends up at the plugs for the ECU and the coil pack and crank sensors,meaning they all need to be replaced.

May 04, 2017 | Vauxhall Cars & Trucks

1 Answer

My 2001,Honda Goldwing 1800 SWINGS BUT WONT START!!!!!


it is either:
no fuel - empty tank, blocked fuel filter, blocked fuel pipe

no spark - check the spark plugs by removing and thenh reconnecting to the HT wires then see if they are sparking in the dark

or start at the fuse box and work down the loom for overheating or broken / cut wiring

Sep 20, 2013 | VStream Windshield Vent For Honda Goldwing...

1 Answer

Husqvarna 36 cc chainsaw wont start replaced spark plug cleaned carb


Are you getting a spark..? - NO? check wiring loom from ignition module, check timing gap between flywheel and ignition module, check on/off switch.
Does it have compression.? - NO? then check piston/rings and cylinder
Is fuel getting to the cylinder.? - NO? Carb problem of fuel line issue

Dec 06, 2012 | Husqvarna Garden

1 Answer

I just changed engine from 1.5 vtec auto to 1.5 non vtec 5 speed cn i stil use the vtec wiring loom


Only if you want to take the time to trace a wiring diagram down for both engines.

Oct 30, 2011 | 1991 Honda Civic

1 Answer

1996 dodge stratus. one of the four coils will


it sounds like a broken wire in the engine wiring loom disconect the wires from the coil pack and and check for continuity from them to the engine controll module

Apr 15, 2010 | 1996 Dodge Stratus

1 Answer

I have a vw 2.0 sdi caddy van o6 that runs lumpy on idal and some times will not start propley, also has lack of power and is running rich.Have used bosch kts diagnosics and has a fault with injector 4 so...


set the injector lash on all the injectors then use vag com / engine / outputtests/ measuring block 13 the injector readings must be approx 0.50 any thing over that and is over fuelling

Oct 02, 2009 | 2006 Volkswagen Golf

Not finding what you are looking for?
2000 Yamaha DT 125 R Logo

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...