Question about 2002 Suzuki GSF 1200 Bandit S

1 Answer

Hi rpms when starting and staying hi while riding

High rpms while running and starting goes 4500

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Try rerouting the throttle cable, could be making it jam up if it has a tight bend, if not this, then check your inside throttle cable, sounds like it might have a couple of broken wires and they are jamming inside the outer cable, or the outer cable could be bent.

Posted on Mar 24, 2014


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My `94 toyota camry 2.2L, in the morning starts fine the RPM is at 1100, then when it gets warm it goes dowm to 800 RPMs is that normal or it should stays at least between 900 or 1000RPMs, please somebody...

high idle on starting is normal as it is the same as a choke being on. When it drops back it should be around 900. However tacos in cars are not real accurate under a 1000 rpms so have it checked manually with a rev counter. Run the fault codes to check for a problem.

Feb 27, 2015 | 1994 Toyota Camry

1 Answer

My pickup runs at an extremely high rpms. it is a 93 F250 powerstroke turbo diesel any thought on what i should try?

check the timing of the pump as pump timing if incorrect will cause engine failure . High rpms may be from the accelerator control not being assembled properly on installation or if ECM controlled the connection to the pump is not correct. Looking at ford diesel rpm specs , some fords run to 6500 rpms while others are at 4500 . As you have not stipulated the engine size or capacity ,it is hard to advise other than to go on line to googlr - type in ford max rpms for your engine and see what it is suppose to be

Dec 27, 2014 | 1993 Ford F250

1 Answer

Riding mower v twin acts like its running out of gas how to check what is wrong

Does it idle normally, but only start starving of fuel under load or high revs?
If so, check the fuel filter - just a simple plastic cylinder that the fuel line runs through before going into the carburettor. Quite cheap and easy to replace.

Aug 26, 2013 | Craftsman 21 Hp 42" Deck, Ys 4500 Lawn...

1 Answer

Husqvarna Riding Lawn Mower High engine rpm after warm up

pour liter fluid all over the machine then throw a lit match into it

Aug 29, 2012 | Husqvarna Garden

2 Answers

Rendezvous 04, the rpms stay idling high without pressing gas.


Sep 30, 2009 | 2004 Buick Rendezvous

1 Answer

Idle goes up and down and when the car starts it runs at 4000 rpms.

Hi thi may be a vacum leak in one of the tiny hoses or lines at the engine ,if you dont have a vacum gage you can run a simple test by gently spay some carb cleaner spray close to the lines and air hoses with the engine runing, if you notice the rpms going high there is the problem.

Aug 18, 2008 | Mitsubishi Eclipse Cars & Trucks

Not finding what you are looking for?
2002 Suzuki GSF 1200 Bandit S Logo

Related Topics:

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts


Level 3 Expert

78919 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4818 Answers


Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides